窄粒度分佈 的英文怎麼說

中文拼音 [zhǎifēn]
窄粒度分佈 英文
narrow particle size distribution
  • : 形容詞1. (橫的距離小) narrow 2. (心胸不開朗; 氣量小) petty; narrow 3. (不寬裕) hard up; badly off; short of
  • : Ⅰ名 (小圓珠形或小碎塊形物) small particles; grain; granule; pellet Ⅱ量詞(用於粒狀物)
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : 分Ⅰ名詞1. (成分) component 2. (職責和權利的限度) what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] (料想) judge
  1. The equipment could mill all kinds of material which could be milled on traditional pulverizer, but also could mill powder which strictly prescribe the maximal diameter and size distribution is confined, such as kaoline, talcum powder, copycat powder, coating, mica, hormones, alumina etc

    設備都能超細加工在普通粉碎機上能夠被粉碎的物料,尤其適合加工那些嚴格規限最大顆井要求的產品,比如高嶺土、滑石粉、復印機粉、塗料、雲母、生長素、氧化鋁等。
  2. Results protein - loaded microspheres showed good sphericity and narrow diameter distribution, the encapsulation efficiency reached 95 %

    結果微球球形優良,,蛋白質包封率達到95 % 。
  3. The new method is compared with the ordinary fire law, the characteristic of product such as to possess that the diametre is small and the size distributes narrow and the agglomeration level is light etc, and for further adopting the measure scatters providing the possibility

    實驗所得納米粉體與火法煅燒樣品相比,產品具有徑小、、團聚程輕等特點,並且為進一步採取措施進行散提供了可能。
  4. Different from clay soil and sand soil, the particle extent of silty soil is more narrow, so the component design method and construction technology, which is reasonable for clay soil and sand soil may not be effective to silty soil

    粉質土不同於粘性土和砂性土,其范圍,所以適用於粘性土與砂性土的配合比及施工技術與方法並不就一定適用於粉質土。
  5. The optimum technic conditions have been gotten in in preparaing high dispersive a1 ( oh ) 3 colloid by controlling reactant concentration, ph value, reaction temperature, matured time. they are the prereguisite to prepare nanopoder of a - a1203. this paper entirely and systematically studies the following three kinds of drying stages : oven drying, dehydration with alcohols and azeotropic distillation stage

    本文採用逐步逼近法進行了氫氧化鋁膠體的沉降實驗,對膠體形成的體系反應物的初始濃、體系的ph值、反應溫和膠體的陳化時間進行了系統優化,並獲得了制備高散氫氧化鋁膠體的最佳工藝參數;此膠體經過過濾、 80下烘乾后所得樣品,在掃描電鏡下直接觀察其徑為50nm ,且范圍,顆的表面清潔,為球形。
  6. A worm grading device is installed in the machine, which will release the satisfied particle from the grinding chamber to avoid over - gringing. in this way we not only makes super fine powder, but also we make the particles uniform and even. this machine can carry out dry - grinding and grading operation for all kinds of organic substance and mineral substance, so the powder made by this machine is widely used in the chemicals, metallurgy, mine, energy, electronics, medincine, pesticide, plastic, paper - making, pigment, painting, dyestuff, grinding - stuff, food and cosmetics industries

    該機內裝高效蝸輪級機,能使被粉碎后的合格細粉及時離,迅速排出機外,避免「過粉碎」 ,不僅能制取超微粉,而且還有產品、均齊性高、顆形狀便干控制、產品散性好、可廣泛應用於化工、冶金、礦業、能源、電子、醫藥、農藥、塑料、造紙、顏料、塗料、染料、磨料、食品、化妝品等行業,能對各種有機物和無機物進行乾式粉碎和級作業。
  7. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現:二氧化硅膠體顆均勻於脲醛聚合物網路中,煅燒去除有機模板后微球表面變粗糙,而徑沒有明顯變化; ph值較小時,復合微球中聚合物含量較大,而ph值較大時,得到復合微球結構鬆散,因此熱處理后的二氧化硅微球孔容及平均孔徑都較大,而在ph = 0 . 8時,得到最小值;武漢理工大學碩士學位論文隨著熱處理溫的變化,小於160時,空,而比表面積較小,在350時,由於有機模板的去除,微球孔結構發生突變,比表面積明顯增大,而孔徑變寬,溫繼續升高時,二氧化硅網路發生收縮,平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態,沒有太大變化。
  8. The starting oxidation temperature of copper powders prepared by hydrothermal method is about 210 and average particle size is about 0. 7 m

    採用此參數可得到平均為0 . 7 m ,,開始氧化溫約為210的超細銅粉。
  9. The contrast experiment of chemistry reducing process and hydrothermal treatment were studied. the results showed that the crystallinity of copper powders prepared by hydrothermal method clearly increased, and the grain size distribution became narrow comparing with the copper powder prepared by reducing process

    通過化學還原法與水熱法制備銅粉的初步對比試驗,證明水熱處理過的銅粉,結晶提高,從而具備了還原法所不能比擬的優良性能。
  10. For adapting to the need of industrialization and improving the properties of materials, the method of mechanical activation has introduced on the basis of traditional calcinations at high temperature. the stardard spinel limn204 is prepared by the mechanical activation - high temperature solid synthesis method. the thermodynamic property, the physical - chemistry performance and the producing techniques of. battery have been studied by means of thermogravimetry ( tg ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), scanning electric microscopy ( sem ) as well as various electrochemical analysis methods. studies show that synthesis temperature, calcinations time, recipe of raw materials, heat treatment and particle size of products are main factors affecting the performances of limn204 cathode materials. with the increment of synthesis temperature and time, the structure and crystal of products are getting to perfect

    隨著合成溫和時間的增加,產物的結構和晶型越趨于完善,但在1100得到的產物有燒結和晶增大的現象,恆溫時間超過24h后對材料的性能影響不是很大; li mn比在0 . 95 1 . 05 2的條件下都可得到標準的尖晶石limn _ 2o _ 4 ,尤其當li mn比為1 . 05 2時,所合成的材料具有較好的電化學性能;通過兩段合成法制備的產物性能要比一段合成法法制備的產物性能好,而兩段間隔合成法比兩段連續合成法處理的材料性能更佳;顆隨著球磨時間的延長而減小,比表面昆明理工大學碩士學位論文摘要卻增大,小且范圍的材料有利於鏗離子的擴散。
  11. It was showed that mipm between 50 - 300 ? m with macro - pores could be prepared via both seeds swelling and suspension polymerization method and suspension polymerization method, the former method could prepared the mipm with narrower size distribution while the later one was easier to carry out and more time - saving. the morphology of the mipm was influenced by many factors including swelling solvent, stirring speed, dosage of seeds, dispersant, dilute and progenic solvent

    M的、具有大孔結構的mipm ,前者的產物具有相對較,但後者的制備工藝則較簡單、制備周期也較短;溶脹劑、攪拌速、種球用量、散劑、稀釋劑和致孔劑是影響產物微球形態的主要因素;乳液聚合法能夠制備得到0 . 16 - 0 . 56
  12. As the ta concentration increases, the average diameter of capsules decreases exponentially. simultaneously, its distribution gets narrow, and its polydispersity index decreases

    隨著ta濃的增加,膠囊徑呈線性關系減小,,多散指數略有降低。
  13. This product has high purity, uniform particle size, narrow distribution range and reliabke performance

    產品純高,徑均勻、范圍,性能穩定可靠。
  14. The optimum preparation conditions and the predicted quantitative equation have been obtained, which can be used to prepare starch microgel with smaller size and narrower size distribution

    進一步通過均勻設計逐步回歸法得到了制備平均徑較小、的澱粉微凝膠的優化工藝條件和預測定量方程。
分享友人