等噴燃燒器 的英文怎麼說

中文拼音 [děngpēnránshāo]
等噴燃燒器 英文
isojet burner
  • : Ⅰ量詞1 (等級) class; grade; rank 2 (種; 類) kind; sort; type Ⅱ形容詞(程度或數量上相同) equa...
  • : 噴動詞1. (液體等受壓力而射出) spurt; spout; gush; jet 2. (噴灑) spray; sprinkle
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 燃燒 : (物質劇烈氧化而發光、發熱; 燒) burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    超聲波由於其空化機理及對液體的流變性影響特性,在油霧化中逐步引起人們的重視,尤其在重渣油高粘度液體的霧化過程中逐步顯示出其優越性,但其具體的霧化機理還需要做進一步的研究在氣泡霧化嘴基礎加入懸臂式簧片哨,將超聲波與氣泡霧化相結合是本文討論的主要內容本文從研究超聲波的一些機理入手,討論了超聲動力發生氣泡霧化以及液體粘度對霧化質量的影響,並通過具體的實驗,根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律,以便找到超聲霧化的一些規律,豐富對超聲霧化機理的研究,對超聲霧化嘴的設計具有一定的指導意義。
  2. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題:在額定負荷下,爐膛出口超溫、低溫段過熱前煙溫高達936 ,遠遠超過815的設計值;四周水冷壁結焦嚴重,過熱管壁溫度超標,無法帶上額定負荷;甚至有時因煤質量的變化,必須投油助的嚴重情況進行了分析研究。在實際生產過程中,的結構、布置,水冷壁的粘污、結垢,過剩空氣系數、一次風溫、煤種及其濃度變化許多因素都會偏離鍋爐的設計工況,從而影響爐內的傳熱和,造成爐膛出口超溫、水冷壁結渣問題。
  3. These results show that since the existent defects of combustion device structure and its hypothetical circle of contact, these make a poor primary and secondary wind rigidity in operation and a too big actual circle of contact. in addition, the coal used is extreme prone to burn and reside in boiler. under such a condition, the coal powder ignites earlier in a short time and short distance when it leave the jet - combustioning device, and splashes the water cooler, eventually this results in a burned coal residue in boiler

    針對宏偉熱電廠410t / h煤鍋爐嚴重結渣問題,對煤的結渣性、爐內溫度工況及空氣動力工況進行實驗研究,由於結構和假想切圓選擇的缺陷,使得鍋爐在正常運行時,一、二次風剛性較差,實際切圓過大,加上目前用煤質屬于極易、易結渣煤質,致使煤粉在離開很短的時間、較短的距離內開始著火,並沖刷水冷壁,最終造成爐膛結渣。
  4. Combustion system of power plant boiler is taken as the research object of this thesis. the research mainly focuses on the faults of boiler combustion system, such as flame center deflection, powder feed inequality or break, primary air pipe jammed, spontaneous combustion, and backfire or kill in burner spout

    本文以電站鍋爐系統為研究對象,主要圍繞鍋爐系統運行中可能出現的爐膛火焰中心偏斜、給粉機下粉脈動、一次風管道內堵粉、自口回火、滅火故障展開研究。
  5. Automatic sprayer burners for domestic fuel oil with a flow rate of up to 200 kg h

    流量小於或於200千克小時的家用油的自動
分享友人