等效磁路 的英文怎麼說

中文拼音 [děngxiào]
等效磁路 英文
equivalent magnetic circuit
  • : Ⅰ量詞1 (等級) class; grade; rank 2 (種; 類) kind; sort; type Ⅱ形容詞(程度或數量上相同) equa...
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • : 名詞1. [物理學] (磁性; 能吸引鐵、鎳等的性質) magnetism 2. (瓷) porcelain; china
  • : 1 (道路) road; way; path 2 (路程) journey; distance 3 (途徑; 門路) way; means 4 (條理) se...
  1. The essential aspect of the mathematic model for inductor is the description of the hysteresis loops of the magnetic core material. the jiles - atherton ferromagnetic theory combined with the experience formula proposed by h. g. brachtendorf, c. eck and r. laur, was applied in this case. the model is more flexible than jiles - atherton ’ s, especially in the circuit model convert

    本文採用了由h . g . brachtendorf 、 c . eck 、 r . laur提出的經驗公式與jiles - atherton鐵滯理論相結合的修改新數學模型,並將該模型轉換為模型模擬滯特性,實驗結果表明,該模型比jiles - atherton模型靈活,利於轉換為宏觀電模型。
  2. Three magnetic chain models of asynchronous electromotor are gotten from t - ii evanescence equivalent

    由t ?型瞬態得出異步電動機的三種鏈模型。
  3. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究,內容包括: ( 1 )本文採用有限長行波面電流作用於有限長鐵芯上的模型,引用了氣隙場一維解,研究了單層繞組場,奇數極半填槽雙層繞組在採用整距和短距時場的分析、比較,簡單介紹了二維解; ( 2 )用有限元軟體ansoft對大圓環直線感應電機空載氣隙場進行了靜態分析,並分析了結果; ( 3 )用軟體進行了額定電壓下的瞬態分析,得到了轉矩,位移,轉速隨時間變化曲線圖,利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較,採用法計算了堵轉時的最大電力並做實驗進行了驗證,由實驗測得了三相電流波形,並與計算結果進行了比較,對其不對稱性進行了定性分析。
  4. In this thesis, the structur principle tal the systein project of coodess ic card were investigated and the reader was also designed. the main researches are as follows :. firstly, an equvalent circuit model of the indution power sapply of contatless ic card was presented by anaiyzing its work principle

    本論文研究非接觸ic卡原理,設計讀寫器具,提供系統方案,主要進行了以下幾個方面的工作:首先,通過分析非接觸ic卡感應電源天線近區場和電感應原理工作原理,建立了非接觸ic卡感應電源的模型,用ewb軟體進行了電模擬,與實際測試結果比較,證明了建立的感應電源電模型是正確的。
  5. Those could provide theory foundation and reasonable equivalent magnetic circuit for the calculation and analysis. a method of determining main dimensions of the srm is given according to any speed - torque profiles, either

    這些工作為分析開關阻電動機的工作原理,建立合理的等效磁路模型提供了理論基礎和可靠依據。
  6. However, recent years the study of electric eddy - current detection mostly overweights the study of measuring system, and the design of the eddy - current. methods are still equivalent magnetic circuit and equivalent electric circuit model calculation and experiment ' s experience design method

    然而,近幾年電渦流測量方法的研究多偏重於測量系統的研究,而對渦流檢測探頭的設計至今仍採用等效磁路模型計算同實驗相結合的經驗設計方法。
  7. Equivalent - circuit model for a four - level - coaxial - circular - cone - like magnetically insulated transmission line

    4層圓盤錐形絕緣傳輸線的模型
  8. Emcn considers the influence of the different flux distributions and leakage flux in alternator. the calculation accuracy is greater than conventional mec. emcn possess advantage of conventional mec and fem

    法又考慮了電機內部的通分佈的不同和漏通的影響,因此其計算精度遠遠高於傳統的等效磁路法。
  9. B ) equivalent circuit method and finite element analysis ( fea ) to compute the static force are presented, the results obtained by each method are compared one with the other. c ) the results of dynamic simulation by means of the software, ansoft show the hlfm " s characteristics when the motor works in the special frequency and single stroke and the conditions used for position control. d ) the measured static thrust - displacement characteristics and the dynamic characteristics during starting show good correlation with the calculated results

    在設計並製作了實驗樣機的基礎上所做的研究內容包括; ( 1 )分別用能量法和麥克斯韋張量法推導電力的計算公式,並討論他們的不同應用范圍; ( 2 )分別用等效磁路法和有限元法作直線力電機的靜特性分析,並比較分析它們的計算結果; ( 3 )用有限元模擬軟體做直線力電機動態特性的模擬,分別分析直線力電機的頻率特性、動子開合閘特性和開環位置控制的工作特性; ( 4 )做直線力電機的靜推力?位移特性實驗和動子開合閘的動態實驗,並將實驗結果與計算結果進行對比,實驗驗證了計算模型及計算方法的正確性。
  10. In many years, the analysis of mechanical characteristics of permanent magnet bearings is deeply studied by scholars in the world, mathematical model is built for analyzing mechanical characteristics of permanent magnet bearings by static magnetic circuit method and equivalent magnetic charge method

    長期以來,國內外學者對永軸承力學特性進行了深入地研究,建立了採用靜法和荷法分析永軸承力學特性的數學模型。
  11. Equivalent circuits of two proposed electromagnetic stop band filters have been developed. and their parameters have been optimized using this method

    本文對兩個新提出的電阻帶結構濾波器建立了,並用該方法優化了相應的參數。
  12. Since the analysis of the inverter and its control system is very complex, the frequency analysis, time domain analysis and control system is made in capacitance operated conditions limited to pressure of time and paper length. the research content can be summed up as follows : ( 1 ) a new equivalent circuit of dbd circuit ( dielectric barrier discharge ) that consider the consume of transformer, the on - off switching loses and so on is presented based on the ozonier powered by sine current source. as compared with the former equivalent, the new equivalent circuit can be depicted the actual ozone circuit accurately

    本文主要針對容性狀態下的臭氧發生器電源進行相關研究,研究內容包括以下幾部分: ( 1 )在正弦電流源供電的dbd型發生器的基波基礎上,提出了一種考慮電雜散損耗(變壓器勵損耗、開關管開關和導通損耗以及其他元件的熱損耗)的改進型基波,並採用該得出了適用的臭氧發生器電源設計方法,實驗驗證了該基波具有工程設計精度高的優點。
  13. With the software cadence, model establishment and parasitic parameter extraction are made on the main pcb lines of the proposed circuits. equivalent circuit models of common mode combined with differential mode current and noise simulation models are also established on full bridge switching - mode converters. study on the simulation of conducted interference noise is made with the software saber and the effects on the circuits " noise by the main parasitic parameters are also analyzed

    在對全橋開關型變換器電工作原理分析的基礎上,建立了全橋開關型變換器主要元器件的電干擾參數模型,利用cadence軟體對其pcb主要印製導線進行了建模分析和寄生參數的提取,得到了全橋開關型變換器傳導干擾的共模、差模噪聲電流模型以及噪聲模擬模型,並運用saber軟體進行了傳導性干擾噪聲的模擬研究,分析了主要寄生參數對電噪聲的影響。
  14. A new terahertz source of folded waveguide traveling - wave - tube which based on vacuum electronics is introduced, which may answer the question for scarcity of small, economical terahertz source with continuous wave of high average power. secondly, transmission characteristics of terahertz wave in the periodic slow wave circuit of folded waveguide traveling - wave - tube have been researched combined with development of micro - fabrication technology. dispersion relation and interaction impedance of the slow wave circuit are deduced by the way of equivalent circuit, and results accounted by theory are close to those simulated by software

    其次,結合計算機模擬技術對這種新型太赫茲輻射源的折疊波導慢波線傳輸特性進行研究:用法從理論上推導了慢波電場、色散關系及線耦合阻抗,電模擬軟體計算得出的慢波電色散曲線與理論計算所得結果基本上一致,表明這種尺寸的慢波電在太赫茲頻段有著色散曲線較平坦以及寬帶、低損耗的良好傳輸特性。
  15. The question of magnetic path is transformed into the form of circuit topology to derivate the equivalent circuit between stator and rotor

    為了便於分析,將問題轉換成電拓撲的形式,推導出定轉子之間的
  16. So this method has many advantages in calculating special field such as 3d field and highly saturated field. the calculation results meet the requirements of engineering. this paper analyzes, models and calculates a six - pair poles hybrid claw - pole alternator

    具有有限元法和等效磁路法的優點,因此,此方法在計算特殊的電機場如三維場或者高度飽和的場能夠發揮其自身的優勢,滿足電機工程設計的要求。
  17. The dissertation places an emphasis on the research of mechanical characteristics of permanent magnet bearings, research is mainly done in the following aspects : mechanical characteristics of permanent magnet bearings is analyzed by static magnetic circuit method and equivalent magnetic charge method respectively, mathematical models are also built by the two methods

    本文的工作內容圍繞永軸承力學特性的研究展開,主要做了以下幾個方面的工作:採用靜法和荷法對永軸承的力學特性進行了系統地分析,並建立了這兩種方法的數學模型。
  18. The first, the effect of the sizes of coupling slots in a coupling double gap cavity on the cavity characteristics is studied through simulation computation of three dimensions electromagnetic field and analysis of equivalent lumped element circuit. it is concluded by the research that, in lower frequency band, bigger coupling slots in a coupling double gap cavity are beneficial to raising the characteristic impedance and lowering the frequency of it mode

    第一,採用三維電場模擬計算方法和集中元件法研究了耦合雙間隙腔中耦合槽尺寸對諧振腔性能如何影響問題,得出了重要結論:在較低頻率波段,耦合雙間隙腔中開大耦合槽有利於提高模的特性阻抗,降低模頻率。
  19. The equivalent magnet circuit network ( emcn ) method is based on combination between conventional mec and fem. the conventional magnet circuit method transfer the field in electrical machine into magnet circuit to analyze and calculate the parameters and performance of electrical machine. the emcn splits the magnet circuit into many elements according to the different flux distribution in the machine

    法的思想是來源於有限元法和等效磁路法的結合,傳統的等效磁路法是把場轉化為計算,而有限元法是把電機內部根據場分佈的不同,把求解區域劃分成各個單元,因此,法是結合兩者的優點而提出來的。
  20. One downside of the integrated bearings is increased coupling between the radial and axial degrees of freedom. the analysis of coupling is done by method of an electric circuit analog of the integrated magnetic bearing. the basic equation of magnetic circuit and the equation of suspension force are derived when permanent magnet flux and electromagnetism flux simultaneity is effected

    利用等效磁路法建立了該軸承的懸浮力數學模型,依據此數學模型分析了徑向和軸向懸浮力之間的非線性耦合關系,得出在轉子平衡位置附近,徑向和軸向懸浮力是解耦的結論,從而為控制帶來了極大的方便。
分享友人