等離子噴塗 的英文怎麼說

中文拼音 [děnglízipēntú]
等離子噴塗 英文
plasma spraying
  • 等 : Ⅰ量詞1 （等級） class; grade; rank 2 （種; 類） kind; sort; type Ⅱ形容詞（程度或數量上相同） equa...
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 噴 : 噴動詞1. （液體等受壓力而射出） spurt; spout; gush; jet 2. （噴灑） spray; sprinkle
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 離子 : [物理學] ion
  1. Chemical inhomogeneity and immersion behavior of plasma sprayed hydroxyapatite coatings

    等離子噴塗羥基磷灰石塗層的化學不均勻性和浸泡行為
  2. Numerical simulation for flow field of cooling water in plasma sprayed gun

    等離子噴塗槍冷卻水流場數值模擬
  3. Wear failure analysis of plasma spray coating on damping area of turbine blade

    渦輪葉片阻尼面等離子噴塗層磨損失效分析
  4. Air plasma spray forming of sofc anode layer by using charcoal mixture

    陽極層的等離子噴塗混合炭粉成孔工藝
  5. Research of bone bridge - like on plasma sprayed ha coating

    等離子噴塗羥基磷灰石塗層的骨橋接性研究
  6. Although arc spraying has the advantages of high deposition efficiency and low cost, only electrically conductive wire materials can be adopted for arc spraying. the quality of coatings produced with plasma spraying and hvof is high, but large volume of plasma spraying equipment makes it difficult to be used on site, and the high investment of equipment, the large consumption in fuel and high cost prevent from spreading of hvof

    雖然電弧噴塗的效率高、成本低，但它僅適用於具有導電性的線材噴塗：等離子噴塗及超音速噴塗制備的塗層質量高，但等離子噴塗設備龐大，不適用於鍋爐現場噴塗；超音速火焰噴塗設備昂貴、耗氣量大、塗層成本高，從而限制了它的推廣。
  7. Current evolution of plasma sprayed hydroxyapatite coating

    等離子噴塗磷灰石陶瓷塗層研究進展
  8. High efficient supersonic plasma spray technology

    高效能超聲速等離子噴塗技術
  9. The wear - resistance of the rps tin coating is significantly higher than that of the quenched m2 high - speed steel. the wear resistance of the quenched m2 high - speed steel was improved about 2. 5 times by the rps tin coating under high load. the antifriction performance of the tin coating is also very excellent due to the self - lubricating effect of tin, the friction efficient of which is about 5. 3 % that of the quenched m2 steel

    在無潤滑條件下，反應等離子噴塗tin塗層的耐磨性明顯高於淬火m2鋼，在高載荷下，其耐磨性是m2鋼的2 . 5倍；同時，由於tin的自潤滑效應，塗層的減摩性遠遠優于m2鋼，高載荷下摩擦系數僅是m2鋼的5 . 3 。
  10. Research on the thermal shock resistance of functionally gradient coating by plasma spray

    等離子噴塗功能梯度塗層抗熱震性研究
  11. 8 - 1. 2g / min, and collection efficiency achieve 8 - 10 % under these parameters. through the study on the dispersion process of the nanoparticle tio2 in water, the author finds out that whisk time, dispersant types, dispersant concentration, dispersing time, ph value, temperature and electrolyte concentration have significant influence on dispersing effects. through contrastive and orthogonal experiments, the author obtains that composite dispersants have better results than single dispersants

    研究表明，液料等離子噴塗制備的納米tio :顆粒平均粒徑為10 ~ 50nln ，其晶型以銳欽礦為主，且隨著電弧功率的增大，銳欽礦含量減少;在本次實驗工藝參數下，收集速率為0 . 8一1 . 29 / min ，收集效率為8一10 % o通過對納米ti02顆粒在水介質中的分散性研究，發現機械攪拌時間、分散劑種類及濃度、分散時間、 ph值、溶液溫度和電解質濃度對納米tio :顆粒的分散穩定性有很大的影響。
  12. Two phases atomizing nozzle and parallel board electrostatic precipitator were designed. ti02 powders were synthesized by plasma spraying with ethanol solution of butyl titanate as liquid feedstock on the optimized parameters

    對等離子噴塗工藝進行了優化，使用噴霧裂解法，以鈦酸丁酯的乙醇溶液作為噴塗原料，成功的合成了納米tio _ 2顆粒。
  13. Our experiments emphasized the correlation between micro structures and some properties of the coatings and tried to obtain the protective coatings with the comprehensively good properties, in which auger electron spectroscopy ( aes ), scanning electron microscope ( sem ), and x - ray diffraction ( xrd ) were employed to investigate the composition, microstructure and crystal phase of the coatings respectively, and the properties test was primarily considered with the wear resistance and corrosion resistance of the coatings

    本論文主要採用pvd技術中的磁控濺射鍍膜（ ms或rms ）及部分用等離子噴塗（ ps ）和熱氧化（ to ）表面處理技術研究了鈾的具有代表性的三種防腐保護鍍層，即單質al 、氧化物al _ 2o _ 3和合金al - zn鍍層。實驗力圖在制備技術、工藝參數及鍍層的微結構和性能之間找到一些內在的聯系，探索綜合性能較好的防腐蝕鍍層。
  14. Plasma sprayed hydroxyapatite coated titanium dental implant

    等離子噴塗.羥基磷灰石塗層-鈦基牙種植體
  15. Using nano structured material powder as the coating stuff, laser is employed to remelt the plasma spraying coating basis so that the nano structured powder material could be clad on the surface of the plasma spraying base or infiltrated to the plasma spraying coating

    提出了一種納米改性塗層的復合工藝方案和技術路線。以納米為填料，在激光重熔等離子塗層的同時，將納米材料熔覆在等離子噴塗層表面或滲入等離子噴塗層內部。
  16. Oxidation resistance of thermal barrier coating layers prepared by plasma spraying

    等離子噴塗熱障塗層抗氧化性能研究
  17. In the aspect of thermal spraying processes the main techniques applied to water wall tubes include flame spray, arc spraying, plasma spray and high velocity oxy - fuel spray ( hvof ). flame spray possesses the characteristics of simple equipment, easy of use and low operating cost, but the coating adhesive strength is low, and porosity and oxidation is high

    在噴塗工藝方面，制備管道塗層的方法主要有火焰噴塗、電弧噴塗、等離子噴塗、超音速火焰噴塗等。火焰噴塗具有設備簡單、使用方便、操作成本低的特點，但它的塗層結合強度低，氣孔率及氧化物含量高。
  18. With the hardness tests, it is indicated the hardness of the nano alumina or nano silicon carbide coating is improved to 1. 6 - 2. 5 times as that of the plasma spraying coating. with the wearing tests, it is indicated that low laser power employed, the wearing performance of the coating without nano material increase to 1. 3 times as that of the plasma coating, at the same time, the wearing performance of the coating with nano material increase 2. 3 - 6 times as that of the plasma spraying coating, the wearing mechanism is further analyzed. with the erosion tests, it is indicated that the erosion performance of the coating with nano material increase five times as that of the plasma spra

    與相應等離子噴塗層相比，硬度測試表明，含納米al _ 2o _ 3或sic的各種復合塗層硬度提高了0 . 6 - 1 . 5倍左右；耐磨性測試表明，小功率下單純的激光重熔耐磨性提高了30 ，而納米滲入后塗層的耐磨性提高了1 . 3 - 5倍左右，對耐磨性提高的機理作了進一步的探索和分析研究；耐蝕性測試表明，經激光熔覆納米滲入后的各種塗層耐蝕性能提高了4倍以上，同時塗層厚度、表面質量對腐蝕性能有影響。
  19. Study on structure and wear characteristics of plasma spray coating of wc - 17 co

    等離子噴塗層組織結構及磨損性能研究
  20. Friction and wear characteristics of plasma - spray ed al2o3 - 40 tio2 and cr2o3 coatings on aluminum alloy

    3等離子噴塗層的摩擦磨損特性
分享友人
分享到 Line

分享到臉書