筒內 的英文怎麼說

中文拼音 [tǒngnèi]
筒內 英文
intube
  • : 名詞1 (粗大的竹管) a section of thick bamboo 2 (粗管狀物) thick tube shaped things 3 (衣服等...
  • : 名詞1. (內部; 里頭; 里邊) inner; inside; within 2. (妻子或妻子的親屬) one's wife or her relatives 3. (姓氏) a surname
  1. The cylinder is filled with the slurry to be studied.

    筒內注滿待研究的泥漿。
  2. Cylinder dryer is a dind of rotatin continuous drying equipment with internal heating conducting - style, certain thickness of materials film theres to the lower trough of materials under the rotating cylinder. heat is transferred to the internal wall of the cylinder through pipes and misfired ahain to the external wall and to materials film, to evaporate and damnify moisture in materials film so as to dry materials

    乾燥機是一種加熱傳導型轉動連續乾燥設備。旋轉的滾通過其下部料槽,粘附著一厚度的料膜。熱量通過管道輔送至滾筒內壁,傳導到滾外壁,再傳導給料膜,使料膜中的濕度得到蒸發、脫濕、使含濕份的物料得到乾燥。
  3. ( 4 ) the tubiform petal of p. suffruticosa andr. and paeonia lactiflora pall, is a special petal which only has been occurred in the highflower of pralification flower of the above two species. the petal is similar to corolla of some family of sympetalous dicotyledon in shape, however it has a more thin base and many different lobes in form and size

    ( 4 )在對臺閣花型的研究中新發現了一種特殊的花瓣一狀花瓣,它具有狀結構,外形類似於一些合瓣花類植物的花冠,但的基部更細,向上變粗,口部邊緣變化較大,具形狀和大小各異的裂片,有的呈喇叭形,有的呈鐘形,筒內壁上有時具一頂部游離的芒狀物。
  4. Under the assumption that the inner surface of stator sleeve and outer surface of rotor are smooth, taking the fact into account that the temperature of stator sleeve of evaporation cooling motor keeps almost the same, horizontal evaporation cooling motor is simplified as a physical model of two coaxial sleeves, with outer sleeve ( the stator ) holds still and keep at constant temperature and inner sleeve ( the rotor ) is rotating and heated

    本文通過數值和實驗手段研究了臥式蒸發冷卻電機楔形氣隙中的流體流動、傳熱現象。本文在定子套和轉子表面光滑的假設下,針對蒸發冷卻電機定子套壁面基本恆溫的特點,將實際蒸發冷卻電機簡化為同軸套筒內加熱旋轉、外簡靜止定溫的物理模型。
  5. In order to open the cover of a concentric canister launcher ( ccl ) automatically with the jet during its launching, four schemes are put forward, viz. fracturable cover, eccentrically positioned interior and exterior launching tubes, jet guides of assymmetric construction, and covers made of heterogeneous materials

    摘要為實現導彈自力發射時同心發射前蓋自動向一側開啟,討論了4種燃氣開蓋方案:易碎蓋方案、偏心蓋方案、半導流錐方案和各向異性材料發射蓋方案,並用數值方法模擬了各種方案的筒內復雜三維流場。
  6. The storage of lead oxide can be done in individual metal drums.

    鉛氧粉可以放在單獨的金屬筒內儲存。
  7. On september 23, the found property office of post office informed police that a cardholder belonged to the deceased was found inside a postbox in kowloon area

    郵政署失物認領處於九月二十三日通知警方,在九龍區一個郵筒內發現死者的卡片套。
  8. 2 miniaturized vacuum arc quenching chamber which is with cucr25 contact material, cup shape and longitudinal magnetic field contact structure, intensive interrupting ability is used. vacuum arc quenching chamber is laid in a sealed insulating cylinder, which significantly improve the ability of enduring environment and phase - phase insulation character

    2 、設計了採用cucr25觸頭材料、杯狀縱磁場觸頭結構、開斷能力很強的小型化真空滅弧室;真空滅弧室布置在封閉的絕緣筒內,提高了環境耐受能力,同時使相間絕緣性能顯著提高。
  9. According to the principle of filte, dust granules in the ak are caught and collected into a collective cylinder

    依過濾原理將懸浮在空氣中的灰塵粒子捕捉收集在一臺集塵圓筒內
  10. Fall velocities are usually measured by observing individual grains settling in a column of still fluid.

    沉速通常是由觀測單個顆粒在圓柱筒內靜止的液體中沉降來測定的。
  11. Internal vents are usually tubes that carry gasoline vapor from above the fuel in the float bowl to the carburetor airhorn.

    部通風口通常是些管子,它們從浮筒內的燃燒上面將汽油蒸氣攜帶出來,輸送到化油器的空氣腔里。
  12. Tsh style heat cylinder is crooked, avoid the material fall into and cause the heat tube burm down

    Tsh型發熱管彎型設計,避免因原料落入筒內而引起發熱管捐損壞。
  13. The model of variability of submergence depth is established based on the law of volume balance, and the changing trends of parameters like submergence depth etc are analyzed. according to the principle of supply and discharge balance, the method to predict oil yield is presented. subject to different objective functions, the corresponding optimum combinations of suction parameters are analyzed, and the importance of choosing objective function to optimum combination of suction parameters is emphasized

    本文研究了油井流入動態關系,根據井筒內液量平衡原理,建立了沉沒度變化的數學模型,分析了沉沒度等參數變化規律;根據油井供、排平衡原則,得出了抽油泵排量系數相對穩定狀態下產量預測的關系;分析了不同目標函數下,油井抽汲參數的組合效果,指出了目標函數選取對參數合理組合的重要性。
  14. How to measure exactly the coal mass of pulverizer in fossil power plant ? it is one of primary causes that the efficiency of milling control is low and the automation is difficult to running. in this paper a method of solving uncertainty problem - evidential theory was studied principally from the view of the multiple sensor information fusion

    火電廠中鋼球磨煤機筒內存煤量的測量問題一直是制粉控制效率低和自動控制難以投入運行的主要原因之一,本文從多傳感器信息融合的角度出發,重點研究了一種解決不確定性問題的有力方法? ?證據理論方法。
  15. Slice the chicken, pork and fish, put into a bowl with the skin side down, pour seasoned soup stock into the bowl, steam till tender

    加調料米粉熟豬油拌勻,腌5分鐘,裝入竹筒內加蓋上籠蒸30分鐘上桌即成。
  16. After a search, 2. 64 kg high - graded ketamine was found being concealed in food packets, toothpaste tubes and containers of personal hygiene products in a piece of luggage

    64公斤的高純度氯胺酮毒品,分別藏於包裝食品袋、護理用品容器及牙膏筒內
  17. The research on vertical conduit flow of gas - liquid two phases in wellbore aims at the classification, transition and judgement of flow pattern, according to the pressure distribution of oil - gas - water mixture in wellborne, by which the reliable basis will be provided for understanding of well performance, rational control / monitoring and regulating of well flow regime and the design of gas lift

    摘要井兩相管流研究的主要目的是用於井筒內流體流型的劃分和流型的轉變與判斷,其基本依據在於井筒內油氣水混合壓力的分佈狀況;在了解了井混合流體的壓力分佈狀況之後,能夠為掌握油井生產規律、合理控制和調節油井式作方式及氣舉設計提供可靠的依據。
  18. Empty the water out of the syringe and needle, and then repeat ( step 5 & 6 ) once

    把針注滿清水,來回搖勻數次,讓清水清洗針筒內外。
  19. Brush squid with cornflour. stuff with filling until 60 % full

    魷魚筒內抹上生粉,將餡料放入魷魚筒內至六成滿。
  20. Intellectual protection : the torch is installed protective apparatus to reliably protect battery and extend torch ' s service life ; intellectual charger is also installed with short circuit protection and charging display apparatus

    智能保護:電筒內配置有過放、過充及短路保護裝置,有效地保護電池、延長電使用壽命;智能型充電器設有短路保護和充電顯示裝置
分享友人