管線報廢 的英文怎麼說

中文拼音 [guǎnxiànbàofèi]
管線報廢 英文
pipeline abandonment
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 報 : Ⅰ動詞1 （告知; 報告） report; declare; announce 2 （回答） reply; respond; reciprocate 3 （答謝）...
  • 廢 : Ⅰ動詞（不再使用; 不再繼續） abandon; abolish; abrogate; discard; give up Ⅱ形容詞1 （沒用的; 失去...
  • 管線 : line pipe; lead-out管線安裝 pipelining; 管線泵 in-line pump; 管線測量 pipeline survey; 管線敷設 pipelining
  • 報廢 : announce invalidated check in paper; be declared worthless; discard as useless; dumping; scrap; r...
  1. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
分享友人
分享到 Line

分享到臉書