節流閥桿 的英文怎麼說

中文拼音 [jiéliúfágǎn]
節流閥桿 英文
throttle lever
  • 節 : 節構詞成分。
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 桿 : 桿名詞（桿子） pole; staff
  • 節流 : 1. （節省經費開支） reduce expenditure 2. [工業] orificing; choke; throttle down, throttle back; throttle
  1. Additionally, it has utilized the harvest of the diffluent and confluence cross experiment made by beijing university of technology, which has enhance the application of the software and be of innovation

    同時，軟體利用了北京工業大學建築環境與設備實驗室多年來在帶調節拉桿閥片的合流及分流四通局部阻力系數的實驗研究成果。這一點，將擴大了軟體的工程應用范圍。
  2. The structure and operating principle of an air - charged split - type adjustable shock absorber was described, e non - linear parameterized mathematical model of this shock absorber ' s damping characteristics was established according to fluid mechanics theory and the main structural affection factors to shock absorber ' s damping performance, such as the diameter of piston valve orifice, the diameter of adjustable orifice, the initial volume of gas chamber, the diameter of piston rod, the inner diameter of oil pipe and so on, were analyzed by simulations

    摘要通過分析一種分體式充氣可調阻尼減振器的結構和工作原理，運用流體力學理論，建立了該減振器阻尼特性的非線性參數化模型，模擬分析了活塞阻尼閥孔徑、阻尼調節孔徑、氣室初始體積、活塞桿直徑、油管內徑等主要結構參數對減振器阻尼性能的影響，通過試驗測試，得到了減振器樣件的阻尼特性及其可調范圍。
  3. When the governing valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod increased, meanwhile, it ' s time of rise, time to peak and the governing time all increased. at the same time, the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    當出口節流調速系統的回油路上串接調速閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是增加的，上升時間、峰值時間以及調整時間也是增加的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。
  4. The valve stem with its grooved rings and positioning sleeve indicates the throttled position of the valve

    閥桿及其溝槽環和定位套筒顯示閥門的節流位置。
  5. The caution message cut the flight short, but we still managed to perform some of the planned maneuver blocks, which included throttle transients and one - half stick and pedal inputs

    這個警告信息使得飛行時間被縮短了，但我們仍然安排完成了一些計劃中的飛行動作，其中包括節流閥瞬變、半桿操作和方向舵操作。
  6. Port closure directly proportional to stem travel for throttling

    埠關閉與閥桿運動成正比例，適用於節流。
  7. Problem : friction locks cause throttle levers to stick

    問題：摩擦鎖使節流閥桿卡住。
  8. Straight moving type relief valves, mainly valve disc, valve body, spring - loaded, roof, regulation pole, conditioning nut, and other integral parts

    直動型溢流閥，主要有閥芯、閥體、彈簧、上蓋、調節桿、調節螺母等零件組成。
  9. Globe pattern stop - check valves can be used in horizontal piperuns with the stem straight up

    截止閥類型的節流止回閥可以用在水平管道上，閥桿垂直向上。
  10. Used the metering - out control system in which the hydraulic cylinder was the executive element as research object in this thesis, the experimental research about the effect on the pressure p1, p2 of the hydraulic cylinder chambers when series - connecting throttle valve or governor valve on the return oil - line under the step load changing have made

    本文以單出桿液壓缸為執行元件的出口節流調速系統為研究對象，在其迴路上分別串接節流閥和調速閥，當負載發生階躍變化時，對液壓缸兩腔壓力p _ 1 、 p _ 2的影響進行了試驗研究。
  11. The swing check to stop reverse - flow is moounted in the disc - lever with little axial and radial play and held by screw nuts

    用來阻止逆流的旋啟式止回閥是安裝在閥板拉桿上，有微小的軸向和徑向活動間隙，並用調節螺母固定。
  12. Globe valve indicates that the stem drive disc along the central spindle of seat make lifting movement, it is a sort of common stop valve. which is mainly used to connect and disconnect medium in pipelines. generally, it is not used to adjust flow

    截至閥是指啟閉件（閥瓣）有閥桿帶動並沿閥座中心軸線做升降運動的閥門，是一種常用的截斷閥，主要用在接通或截斷管路中的介質，一般不用於調節流量。
  13. Accorded to the experimental research, under different flow area of flow valve and different adjusted pressure of relief valve, conclusion that the regulation of the pressure p1, p2 in the two cylinder chambers varied with the change of step load were as follows : when the throttle valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod decreased, meanwhile, it ' s time of rise, time to peak and the governing time all decreased. while the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    通過試驗研究得出系統在不同的流量閥開度、不同溢流閥調節壓力（進口壓力）下，液壓缸兩腔壓力p _ 1 、 p _ 2隨階躍負載變化的規律：當出口節流調速系統的回油路上串接節流閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是減小的，上升時間、峰值時間以及調整時間也是減小的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。
  14. The valve stem is not connected to the disc, and when the stem is in the open position then the disc is free to respond to the flow

    這種閥的閥桿並不連接到閥瓣上，當閥桿處于開啟位置時，閥瓣可以根據流體流向自動進行調節。
分享友人
分享到 Line

分享到臉書