節流閥片 的英文怎麼說

中文拼音 [jiéliúpiān]
節流閥片 英文
throttling valve disc
  • : 節構詞成分。
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  • : 片構詞成分。
  • 節流 : 1. (節省經費開支) reduce expenditure 2. [工業] orificing; choke; throttle down, throttle back; throttle
  1. Additionally, it has utilized the harvest of the diffluent and confluence cross experiment made by beijing university of technology, which has enhance the application of the software and be of innovation

    同時,軟體利用了北京工業大學建築環境與設備實驗室多年來在帶調拉桿的合及分四通局部阻力系數的實驗研究成果。這一點,將擴大了軟體的工程應用范圍。
  2. Our main products are micro barometer low pressure gauge low pressure capsule gauge vacuum pressure with low pressure gauge pressure gauge with electrical contact shock - proof electric contact gauge stainless steel pressure gauge dry and glycerin filled pressure gauge normal pressure gauge freon pressure gauge oxygen - acetylene pressure gauge stainless steel vacuum pressure gauges series diaphragm seal pressure gauge diaphragm pressure gauge with electrical contact pp diaphragm seal pressure gauge shock - proof pressure gauge with electrical contact diaphragm seal pressure gauge explosion - proof electric contact pressure gauge minitype pressure gauge accurate pressure gauge test pressure gauges as well as pressure gauge switch pressure separator tube pressure gauge radiator double - metal thermometer all the products can meet both national and international stands,

    一般壓力表氣壓表抗震壓力表充油壓力表全不銹鋼壓力表膜盒微壓表電接點壓力表冷媒壓力表真空壓力表壓力真空表隔膜壓力表微型壓力表差壓表微差壓表絕壓表精密壓力表耐高溫壓力表蒸氣壓力表汽車燃氣壓力表醫用壓力表遠傳壓力表衛生型壓力表壓力表緩沖管壓力表冷凝散熱器壓力表翅散熱器壓力表開關不銹鋼連接彎管不銹鋼連接軟管轉換接頭油壓連接頭壓力表針及過壓保護附件濾油網加油口油溫油麵計雙金屬溫度計等。
  3. The components of this system are a cross - flow finned - tube evaporator, cross - flow finned - tube gascooler, a reciprocation compressor, a gas - liquid seperator, a double pipe internal heat exchanger and a throttling valve

    系統由一個叉管式蒸發器、一個叉管式冷卻器、一臺往復式壓縮機、一個氣液分離器、一個套管式回熱器、一個組成。
  4. Analysis is made on structure characteristics of the finned - tube, and analysis has been made on the special heat and mass transfer principle of every micro - unit under both dry and wet conditions. appropriate hypothesis is made and based on the energy, mass and momentum equivalent, the evaporator models of dynamic distributed parameters are set up. in addition, the gascooler and internal exchanger models of dynamic and distributed parameters, the throttling valve models and the compressor models are set up, too

    本文的內容如下: 1對翅管蒸發器的結構特點進行分析,選取適當的微元體,對于干、濕工況下每個微元分別進行傳熱傳質分析,通過適當的假設,利用質量守恆方程、能量守恆方程和動量守恆方程建立了蒸發器的分佈參數數學模型;對回熱器劃分微元建立了分佈參數數學模型;對氣體冷卻器建立了分佈參數數學模型;對壓縮機建立了數學模型;建立了的數學模型,為系統模擬奠定了基礎。
  5. The cooling system for engine adopted hydraulic drive and control technology to control the speed of the fan : the chip adjust the control - current of the proportional value, which used in the engine cooling system, to control the speed of the fan. and the size of the control - current is according to the coolant temperature, coolant temperature change rate and target temperature. as for as the hydraulic cooling system we used a motor to drive and control the fan ’ s work or stop according to the temperature of the hydraulic oil

    該系統的特點及其實現的功能為:電液混合驅動方式改變了工程機械冷卻裝置驅動方式單一的缺點,發動機冷卻系統採用了電液比例技術控制風扇轉速;單機可以根據冷卻液溫度、冷卻液溫度變化率和目標冷卻液溫度調液壓驅動系統中電液比例的控制電,進而控制液壓油的量,即可以實現冷卻風扇轉速的連續調;液壓油冷卻系統採用了電動機驅動,然後由單機根據液壓油的溫度控制電動機的起動和停止。
  6. Wafer type rubber - seated butterfly valves

    形橡膠座
  7. Based on advanced technology, this thesis bring forward the optimal scheme and set down general system - drawings and flow charts. using step7 - micro software, we achieve the auto - control aim in drinking water treatment. in practice, the complexity and non - linaerity exit in the system of water treatment, so we apply fuzzy control in water treatment and design a kind of controller which structure can be altered according to the using - rate of ozone and the variety of water quality

    實際飲用水處理系統由於存在復雜性、非線性、時變性,本文根據臭氧生物活性炭水處理工藝存在復雜性、非線性、時變性等特點,將模糊控制應用在水處理這一不確定的非線性時變系統,針對不同水溫下臭氧利用率及水質的變化,設計一種基於系統過程狀態的變結構的模糊控制器,以單機作為主要控制硬體,按查表方式設計軟體,對進水門開度進行在線控制,調臭氧氣體與進水的比例(臭氧量及濃度不變) ,達到氣水比最優化。
  8. Analyzed the influence of elastic modulus to the valves parameters, the influence coefficients of elastic modulus to the valves parameters is founded

    定量分析彈性模量對系設計參數的影響,確定厚度和縫隙的彈性模量影響系數,利用該系數可對系參數進行推算設計。
  9. Characteristic analysis and test on superposition throttle slices of damper

    減振器多疊加節流閥片特性分析與試驗研究
分享友人