米制氣壓 的英文怎麼說

中文拼音 [mǐzhìqìyā]
米制氣壓 英文
metric atmosphere
  • 米 : Ⅰ名詞1. （稻米） rice 2. （泛指去殼或皮的可吃的種子） shelled or husked seed 3. （姓氏） a surname Ⅱ量詞（公制長度的主單位） metre
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 壓 : 壓構詞成分。
  • 米制 : [力學] metric system米制噸 tonne; millier; 米制公約 metric convention; 米制馬力 [物理學] metric horsepower
  • 氣壓 : [氣象學] pressure; atmospheric pressure; barometric pressure; gas pressure; air pressure
  1. Apply computer chip to control the circuit ; omron opto - elecrtonic control - ler and panasonic and mitsubishi inverter have stable performance, high precision, rapid reaction and long life - span ; the controlling plate applies tactile operation board which is handled easily ; vertical structural screen is easy to adjust the vertical printing pressure so as to ensure the quality of printing ; the frame lift is driven by electrical motor and installed with imported linear guide rails, of which the speed - adjust device, scraper and scraping blade can be adjusted within15 to 45 and can be set for many times so as to repeatedly printing with good precision and output, the flat bed is made of 2mm stain - less steel plates which are flat, smooth and indeformable ; it is also equiped with micromatic setting device in order to ensure the precision of multi - color overprint and auto air - intake device to ensure strong adsorption

    採用電腦板控制電路，歐姆龍光電控制器，松下，三菱變頻器，行直穩定.精度高，反應快，壽命長，控制面板採用觸摸式操作面板，操作方便，六式結構型網版垂直升降印刷壓力可調保證印刷質量，機架升降採用電機驅動安裝進口直線導軌，刮刀、回墨刀可在15一45角調整，可設置多次，重復印刷保證產品精度.平臺板採用2毫米不銹鋼板製作，平整光滑不變形配有微調裝置，確保多色套印精度，配自動吸氣裝置，確保強有力的吸附。
  2. Then, by annealing, the si / sic / sich nano - composite films are prepared. the influence of the post - heating on the microstructure of the films has systematically been studied by the means of the measurements of hrem. the nano - crystals are found embedded in the amorphous matrix in the unannealed sample and the crystallinity is not high

    以硅烷和乙烯為原料氣採用常壓化學氣相沉積制備得到si / sic復合薄膜，並使用退火處理方法對該薄膜進行后處理，最終得到si / sic / slo ：納米鑲嵌復合薄膜。
  3. The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper

    本文研究了用igc （惰性氣體蒸發凝聚原位溫壓法）制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅（冷軋紫銅、電解銅）在酸性硫酸銅溶液和中性含氯溶液中，在自腐蝕狀態和陽極極化狀態下的腐蝕性能。使用了動電勢極化、電位測定、循環伏安法（ cv ）和電化學阻抗譜（ eis ）等方法。 x -射線衍射（ xrd ）的方法用來估算納米晶銅晶粒尺寸。
  4. The tensile and compression experiment on bulk nanocrystalline ag prepared by igc method was carried on mt810 with different grain sizes and zwick 10tn2s machine at different strain rates under normal temperature respectively. the stain rate sensitivity m was found to be 0. 025, which was extremely lower than the ordinary values. also the work hardening exponent is very low

    本文從用惰性氣體蒸發冷凝和真空原位壓結法（ igc ）制備得到的直徑80mm ，厚度7 . 6mm的大尺寸納米晶金屬ag樣品上切割得到符合力學實驗要求的拉伸和壓縮試樣，在mts810和zwick精密力學測試機上分別精確測定了拉伸和壓縮應力?應變曲線與晶粒尺寸和應變速率的關系。
  5. We introduced advanced italy slutty - injection machine, owing a 90 - meter auto computer control tunnel kiln, two shuttle kiln

    公司引進義大利先進的高壓注射生產線三條，擁有90米長的現代化全自動電腦控制燃氣隧道窯一座，梭式窯爐二座。
  6. Pneumatic fluid power - five - port directional control valves, sizes 18 mm and 26 mm - part 2 : mounting interfaces with optional electrical connector

    氣壓流體. 18毫米和26毫米規格的五孔口定向控制閥.第2部分:帶光學電接頭的安裝面
  7. By changing the negative bias current density, gaseous ratio and total pressure, nanocrystalline diamond film is prepared by ion - assisted bombardment method at the substrate temperature of 700 ? 00 ? and mixture gaseous of ch4 and h2 the effect of growth parameters on the diamond film is studied. the diamond film presents very low compressive stress and excellent field emission character

    採用離子輔助轟擊法，以ch _ 4 、 h _ 2為源氣，襯底溫度為700 900 ，通過改變襯底負偏壓、 h _ 2和ch _ 4氣體比例以及工作氣壓，制備出納米金剛石薄膜，並對工藝參數對金剛石薄膜沉積的影響進行了研究。
  8. The size of the nanoparticles prepared with the flow - levitation method can be controlled by controling the gas pressure in the action tube, the velocity of cooling gas flow and the temperature in the melt metal globule

    自懸浮定向流方法制備納米鋁粉和銅粉的過程中，通過控制反應管內的氣體壓力、冷卻氣體的流速、熔球的溫度等因素可以對粉體的尺寸分佈進行控制。
  9. Carbon nanotubes were produced in an electric arc discharge with an anode composed of carbon. the productions were studied in different current, voltage, helium pressure and diameter of anode and cathode sticks. oxygen and steam in helium were discussed. the proper condition of producing carbon nanotubes is included to make purification easy. 2figs., 2tabs., 6refs

    採用石墨電弧法制備碳納米管，研究了不同電流、電壓、氦氣壓力以及不同陰陽極棒徑條件下碳納米管的生成情況，並討論了氧氣和水蒸氣的存在對碳納米管制備的影響，總結出制備碳納米管的條件，給以後的純化工作帶來方便.圖2 ，表2 ，參6
  10. I think it ' s important for the world to know that we, too, have aspirations. " andy elson and colin prescot, the british pilots leading mr singhania ' s technical team, have designed the 40 - tonne balloon, which is fired by propane and paraffin, and the pressurised aluminium cabin

    這個重40噸的熱氣球在英國製造，充氣后容積達160萬立方英尺約合4 . 53萬立方米，高度接近30層樓，依靠燃燒丙烷和石蠟提供浮力，並裝有鋁制耐壓艙。
  11. Railway rolling stock. compressed - air brake. coupling head for 25 mm automatic brake pipe

    鐵路車輛.壓縮空氣制動.毫米自動制動裝置導管聯結頭
分享友人
分享到 Line

分享到臉書