米粒組織 的英文怎麼說

中文拼音 [mǐlìzǔzhī]
米粒組織 英文
granule （solar physics）
  • 米 : Ⅰ名詞1. （稻米） rice 2. （泛指去殼或皮的可吃的種子） shelled or husked seed 3. （姓氏） a surname Ⅱ量詞（公制長度的主單位） metre
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  • 組 : Ⅰ名詞1 （由不多的人員組成的單位） group 2 （姓氏） a surname Ⅱ動詞（組織） organize; form Ⅲ量詞（...
  • 織 : 動詞（編織） knit; weave
  • 米粒 : rice grains; [天文學] granule
  • 組織 : 1 （組織系統） organization; organized system 2 （組成） organize; form 3 [紡織] weave 4 [醫學] [...
  1. The granulation is commonly thought to represent the overshoot of the topmost convective elements as they penetrate the stable atmosphere.

    一般認為，米粒組織代表最上部的對流元穿入穩定大氣時的超越部分。
  2. It is indicated after laser remelting, the density of the nano material infiltrated coating is improved and grain size is decreased greatly. in above researches, it is found that the nano material is distributed among general material grains to form inter - granular structure of the coating

    研究發現，在各種塗層中納米顆粒明顯填充在粗顆粒間，構成晶間型組織結構；初步測試還表明，在al _ 2o _ 3 + 13 wt
  3. The filigree, presumably by virtue of these fields, completely alters the structure of the granulation.

    大概是由於這些磁場的作用，精細網路完全改變了米粒組織的結構。
  4. The lifetime of supergranulation elements is about a day, rather than a few minutes as for the granulation.

    超米粒組織元的生存時間大約是一天，而不像米粒組織那樣為幾分鐘。
  5. Study on structure and property of the - co wc nanoparticle composite coating prepared by electro - brush plating

    納米顆粒復合電刷鍍層的組織性能分析
  6. The lath martensite nanometer structure can play the role of fine - particle strengthening and dislocation strengthening as well as coordinate the distribution of dislocation. it is hopeful that the strength and toughness of material with this structure can be increased at the same time

    板條馬氏體組織納米化結構，可起到納米晶粒的細晶強化與位錯強化的聯合作用，並可協調位錯分佈，有望使具有這種組織的材料強度和韌性同時得以提高。
  7. In this paper, nanosized al2o3 ceramic particles were chose as reinforcing phase. enhanced with ultrasonic wave the particles were covered with copper using method by electroless plating, the copper - matrix composite was developed by hot - press sintering process of the composite powder. the composition, microstructure, hardness, density and dry sliding wear property of the new material have been studied

    研究路線為：選用納米級al _ 2o _ 3陶瓷顆粒作為增強相，在超聲波的環境中用化學鍍的方法完成對納米al _ 2o _ 3陶瓷顆粒表面的金屬銅包覆，採用熱壓燒結成型技術以復合粉末為原料制備成納米al _ 2o _ 3陶瓷顆粒增強銅基復合材料，研究分析復合材料的成分、組織結構、硬度以及緻密度，對試樣進行了干滑動摩擦磨損實驗。
  8. The results of pure cu show ecap can produce bulk material of submicrometer level indeed. as the number of passes increases, the initial structure of pure cu has been refined largely. after six passes, i. e. the equivalent true strain of 4 ~ 5, the grain size gradually becomes stable and uniform

    對純銅室溫ecap晶粒超細化行為及組織穩定性的研究表明： ecap技術的確能制備出亞微米級的塊體材料，隨著ecap道次的增加，純銅的組織被大大細化， ecap六道次（即等效真應變4 5 ）后，晶粒尺寸趨于穩定，硬度基本飽和。
  9. The results showed that the in - situ formed tibi particles which had a size of about 50nm, exhibited a homogenous dispersion in the copper matrix. moreover, the interface between the nanoscale particles and the copper matrix was clean, and there was no certain location relationship. due to their reinforcement, the tensile strength and hardness of the in - situ cu - tib _ 2 nanocomposite significantly improved

    通過光學顯微鏡、 tem 、 xrd等對cu - tib2原位復合材料進行了金相組織、微結構分析，原位復合材料的鑄態金相組織中彌散分佈著團簇狀的tib2顆粒；形變態金相組織中tib2顆粒呈纖維狀排列； tem觀察表明：在基體內存在著尺寸約為50nm 、彌散分佈的tib2顆粒，且tib2顆粒與基體之間界面清晰，但由於tib2結構與銅晶體結構的差別較大， tib2顆粒與基體之間無固定的位向關系；納米tib對銅基體有良好的增強作用。
  10. On the surface of annealed 45 steel, as the pearlite in it contains cementite phase and has high crystal boundary density, the nucleation and growth of deposits prefer to occur at the pearlite at the beginning during depositioa the coating exists in form of nano - polycrystal layers composed by gathering of nano - sized crystals

    在退火態45鋼表面，由於珠光體組織中含有滲碳體相且具有比較高的晶界密度，因而在沉積初期鍍層優先在此處形核和生長；鍍層在基體表面是以納米尺度的晶粒聚集在一起形成的聚晶體形式存在的。
  11. The evolution on particle morphology, microstructure, grain size and microstrain of the mixture of ti and al elemental powders during mm has been investigated. it was found that the nanocrystalline composite powders with extremely fine ti / al alternative lamellar structure ( lamella spacing about 0. 1 ~ 0. 5 m ) could be prepared by mm using proper processing parameters

    研究了ti 、 al單質元素混合粉在機械球磨過程中的顆粒形貌特徵、組織結構、晶粒尺寸以及微觀應變的變化規律，表明在適當的球磨工藝條件下可獲得具有極細層片間距（ 0 . 1 ~ 0 . 5 m ）的納米晶ti / al機械復合粉。
  12. A key step to control the size and shape of the growing particle is dynamically to coat the particles with a closed - packed monolayer of coordinating ligand, mercaptosuccinic acid ( msa ). suitable large size nanoparticles ( several tens nanometer ) and nanorods have been made. after size selection, a certain size nanoparticles were assembled into micrometer sizable super lattice crystal

    制得的金納米粒子再經過粒經篩選，得到粒徑一定的納米粒子，然後，將其溶解成一定濃度的溶液，並加入一定量的濃鹽酸，製成微米級的自組織結晶體。
  13. The samples were characterized by x - ray diffraction ( xrd ), optical spectroscopy, transmission electron microscopy ( tem ) and scanning tunneling microscopy ( stm ). as a result, a self - assembled monolayer ( sam ) of msa on the surface of fee au particles was directly observed in atomic level

    在此基礎上，對金納米粒子和其自組織結晶體進行了一系列的x射線衍射儀（ xrd ） 、透射式電子顯微鏡（ tem ） 、光吸收譜和掃描隧道顯微鏡（ stm ）的檢測和分析。
分享友人
分享到 Line

分享到臉書