粉末固結 的英文怎麼說

中文拼音 [fěnmògùjiē]
粉末固結 英文
powder consolidation
  • 粉 : Ⅰ名詞1 （粉末） powder 2 （用澱粉製成的粉條或粉絲） noodles or vermicelli made from bean potato o...
  • 末 : Ⅰ名詞1 （東西的梢;盡頭） tip; terminal; end 2 （非根本、非重要的事物） nonessentials; minor detai...
  • 固 : Ⅰ形容詞（結實; 牢固; 堅硬） firm; hard; solid Ⅱ副詞1 （堅決地; 堅定地） firmly; resolutely 2 [書...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 粉末 : powder; flour; stive; smalls
  1. Powder metal is often used instead because it is undesirable or impractical to join the elements through alloying or to produce parts by casting or other forming consists of producing small particles, compacting, and sintering. the squeezing pressure with added heat bonds the metal powder into a strong solid. powdered metals can be ferrous, nonferrous or a combination of ferrous and nonferrous elements

    金屬合金一般是無孔隙固體；因為煉制出的合金的實際效果不理想，或者通過鑄造和其他成型方式對小的顆粒進行壓制，燒結出來的產品零件無法滿足需求，因而人們常常使用粉末金屬來代替金屬合金。
  2. In this paper, presentation is given of psc being prepared by solid sintering process as employed in powder metallurgy and ceramics industry and measurements are made of its pl and electrical resistivity

    本文採用粉末冶金和陶瓷工業中常用的固相燒結方法制備psc ，並測試了其光致發光譜（ pl ）和電阻率。
  3. The influence of nano - al2o3 on the sintering and the properties of the si3n4 ceramics was researched in this paper. the samples with different amount of nano - al2o3 were obtained by using pressureless sintering at 1600, 1650, 1700 in the nitrogen atmosphere. the microstructure and the composition of the ceramics were determined by the means of x - ray, sem, micro - hardness meter etc. it is show that the sisty ceramics can be densified at 1650c to % percent of the theory density through the addition of nano - al2o3 ( the value could be 90 percent by other technique ). the crystalline growth of the cylindrical - si3n4 and the ratio of its longitude to its diameter are increased with the addition of nano - al2o3. a uniform microstructure and an fined crystal as well as more sialon phases can be obtained in the si3n4 ceramics through the addition of that

    實驗結果表明：在碳管爐中、氮氣保護下進行燒結，添加劑為納米al _ 2o _ 3粉末時，由於納米粉末的高活性、高燒結驅動力，在1650就可使si _ 3n _ 4完全地燒結，並使其緻密度可達理論密度的96以上（比其它工藝高6左右） ；同時，納米al _ 2o _ 3地加入大大促進了長柱狀? si _ 3n _ 4的生長和發育及柱狀晶長徑比的提高，使微觀結構均勻、細化，形成了更多力學性能優異的固體? sialon相，減少了不利於陶瓷材料性能的晶間玻璃相，凈化了晶界。
  4. To make cds / k4nb6o17 powder on the base of the k4nb6o17 powder which by the courses of ion exchanging, amine intercalation, sulfuration etc. to obtain cds / k4nb6o17 thin film through the same course of making cds / k4nb6o17 powder on the base of k4nb3o17 thin film on the quartz which made by the spin coating and after heat treatment. to make experiments with additives ( na2so3, 0. 1mol / l ) of photocatalytically decomposing water into h2 and o2 to evaluate the photocatalytic activities of the catalyst knb6o17 powder, cds / k4nb6o17 powder, k4nb6o17 film, cds / k4nb6o17 film. the crystalline structures of the midst powder and film productions were investigated by using the x - ray diffraction ( xrd )

    本課題的主要內容是：高溫固相反應合成具有層狀結構的k _ 4nb _ 6o _ （ 17 ）晶體材料，然後以此為母體材料，通過離子交換、層間胺插入、硫化處理等過程制備出cds / h _ 4nb _ 6o _ （ 17 ）粉末形式的光催化材料；通過旋轉塗覆法在石英玻璃基片上制備了k _ 4nb _ 6o _ （ 17 ）薄膜，採用一定的熱處理制度后對薄膜分別進行離子交換、層間胺插入、硫化處理等處理過程制備了cds / h _ 4nb _ 6o _ （ 17 ）薄膜形式的光催化材料。
  5. Thermoplastic phenol - formaldehyde resin bond synthesized by solution po1ymeization is commonly used in making diamond grinding wheel, which has disadvantages such as : absorbing moisture, difficult mixing, can not being long term store, needing curing agent, and giving off dangerous gas

    目前，金剛石樹脂砂輪普遍採用溶液聚合熱塑性酚醛樹脂作結合劑，此結合劑存在著易吸潮結團、混料困難、不易長期存放，需加固化劑才能固化，且固化過程中有大量的有害氣體溢出，使用時需要加工成粉末等缺點。
  6. The tight plastic - lining technology is to adhere plastic powder inside steel pipe smoothly with method of metallurgical powder. comparing to common plastic - lining, tight plastic - lining with good intensity, has avoided the trouble of dropping and cracking. specially, the tight nylon - lining pipe can be used carrying particulate medium matter and solidpowder with excellent wearability

    緊襯塑工藝採用粉末冶金法將塑料粉末均勻地附著在鋼管內表面，融熔流平、緊密地和鋼管本體結合在一起，與普通襯塑相比，塑料與鋼管的結合強度好，避免了普通襯塑管與鋼材基體結合力差容易脫落、開裂的毛病，特別是緊襯尼龍管道，具有優異的耐磨性，可輸送各類含固體顆粒介質、及粉體。
  7. The fluorescence intensity of tb observed in pt / tb sol was stronger than that in powders. the network made of o, ti, such as sol and noncrystalline powders, determined the fluorescence intensity of pb

    Pb離子的熒光與pb所處環境相關，既可出現在液相體系，又可出現在固相粉末體系中，也即處于o ， ti等離子構成的無規則網路結構狀態下的溶膠、凝膠或非晶固態時。
  8. Moreover, the investigation for the ma of cu - cr indicates that : with using of protective atmosphere, active carbon has a good effect on the oxidation control during milling ; the structure refining and increasing of interface and defect result in the formation of non - equilibrium phase

    此外，對cu - cr難互溶體系的ma研究表明：粉末的結構細化及界面、缺陷的產生導致了ma過程中亞穩相（氧化物非晶、過飽和固溶體）的轉變與形成；與保護性氣氛相比較，活性炭對ma過程中的氧化現象有良好的控製作用。
  9. Unlike many products that are sold as environmentally friendly cleaners that are not that effective, oxygen bleaches really do work and for some stains even do a better job than traditional bleaches or cleaners

    過氧碳酸鈉為白色結晶粉末狀或顆粒狀固體，由於碳酸鈉與過氧化氫以氫鍵聯接，其在水中有很好的溶解度，並隨溫度的升高而上升。
  10. For the powder milled to amorphous state, because of its very fine structure, it is easy to occur phase transformation and has good size stability when sintered

    研磨到非晶態的粉末由於元素達到原子尺度混合，大大縮短了擴散距離，不僅易於發生固態相變，而且燒結體尺寸穩定性好。
  11. The use of a bonding will fix diamond powder or cbn powder which is a summary of diamond abrasion wheel and diamond grinding wheel

    系利用結合劑將鉆石粉末或cbn粉末固定作為工具使用者，是鉆石磨輪鉆石研磨輪的總稱。
  12. Compared with the htped beryllium material with the same particle size, the hot - pressed beryllium material has lower mys, . value because its higher consolidation temperature will cause grains to grow

    在用相同粒度粉末成形固結時，由於熱壓溫度較高，晶粒有所長大，因此，熱壓鈹材_ （ mys ）較靜壓鈹材低。
  13. The effects of reactive conditions on the products were discussed and the proper conditions are determined. we primarily synthesize a series of ba1 - xsrxti1 - ysnyo3 solid solutions nanopowder by low - temperature / low - pressure hydrothermal method under the condition of 150, 0. 5mpa

    採用低溫一低壓水熱合成法，在150 ， o . smpa以下合成了一系列bal一xsrxtil一ysnyo3固溶體納米粉末，由於摻雜離子均勻進入母體晶格以及材料的結晶更完整，使得介電性能明顯改善，不僅t 。
  14. The influence of dopants amount on thermoelectric properties of mg2si specimen was researched. the p - type mg2si based thermoelectric materials was synthesized first time by solid - state reaction

    研究結果表明，用低溫固相反應可以在制得mg _ 2si粉末的基礎上摻雜而對純mg _ 2si的熱電性能進行改進。
分享友人
分享到 Line

分享到臉書