粘固用樹脂 的英文怎麼說

中文拼音 [niángùyòngshùzhī]
粘固用樹脂 英文
anchoring resin
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 固 : Ⅰ形容詞（結實; 牢固; 堅硬） firm; hard; solid Ⅱ副詞1 （堅決地; 堅定地） firmly; resolutely 2 [書...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 樹 : Ⅰ名詞1 （木本植物的通稱） tree 2 （姓氏） a surname Ⅱ動詞1 （種植; 栽培） plant; cultivate 2 （樹...
  • 脂 : 名詞1. （動植物所含的油質） fat; grease; tallow 2. （胭脂） rouge 3. （姓氏） a surname
  • 樹脂 : resin; jaffaite; peucine
  1. It is suggested that the introduction of ethanol as solvent not only decrease the viscosity of composites allowing the easy mass transfer of resin and curing agent during curing, but also weakens the intermolecular interaction of novolac resin resulting better miscibility of resin and clay

    研究表明，乙醇的加入可以減小體系的級度，利於酚醛樹脂和固化劑擴散到粘土層間；同時又減弱了酚醛樹脂自身的相互作用，改善了酚醛和粘土的相容性。
  2. Study on the preparation and relationship between micro - structure and mechanical properties of epoxy / rubber / clay composites epoxy / rubber / clay composite has been prepared by the melted intercalation of octadyl ammonium exchanged montmorillonite ( c18 ) with dgeba and carboxyl - terminated butadiene - acrylonitrile random copolymers ( ctbn ), and piperidine as the curing agent

    環氧樹脂橡膠粘土三元復合材料採用熔融共混法制備了環氧樹脂橡膠粘土三元復合材料，就ctbn 、 c18含量、加料順序和固化工藝等制備工藝對c18在三元復合材料結構以及材料的力學性能的影響進行了研究。
  3. Used for producing polyester resin, polyimide resin, water soluble, alkyd resin, water soluble polyurethane resin, plasticizer, water soluble amino - alkyd resin, curing agent for epoxy resin, aeroengine oil, electric capacitor maceration oil, binder, sizing agent, smoke suppressor, instant binder, etc.

    ：用於製造聚酯樹脂及聚酰亞胺樹脂水溶性聚脂樹脂水溶性聚氨酯樹脂增塑劑和水溶性氨基醇酸樹脂環氧樹脂固化劑以及高級航空潤滑油電力電溶器浸漬油粒料粘結劑施膠劑消煙劑瞬時粘結劑等
  4. In addition, it is found that dc electric field weakens the effect of release agent and strengthens the binding strength between epoxy resins and anode in the condition of the existence of release agent. but this effect of electric field is not discovered between epoxy resins and cathode

    另外，本文通過實驗研究還證實：在有脫模劑存在的情況下，固化過程中直流電場的存在會弱化脫模劑的作用進而強化環氧樹脂固化物與金屬正電極間的粘接強度，但直流電場對環氧樹脂固化物與金屬負電極間的粘接強度沒有明顯影響。
  5. Recently, an advanced composite material named carbon fiber reinforced plastic ( cfrp ) has emerged as an alternative to traditional strengthening materials. many advantages such as lightweight, non - corrosive, simple construction, and high tensile strength make it widely used in strengthening field

    碳纖維布（ cfrp ）加固修補混凝土結構技術是一項新興的結構加固技術，它是利用樹脂類膠結材料將碳纖維材料粘貼于混凝土表面，從而達到對結構構件補強加固及改善結構受力性能的目的。
  6. The main conclusions and original results are summarized as follows. the manganin ultra - high pressure sensors for gas gun were made by two - step thin film techniques, namely, manganin thin films were first deposited by magnetron sputtering on fused silica substrates, and then covered by a layer of sio2 thin films by electron beam evaporation. consequently, the manganin sensing elements were " cleanly " encapsulated in inorganic solid matrix and the high - pressure shunt effect was eliminated radically

    上述技術的主要優點在於可以採用高壓絕緣性能更好的無機物作為絕緣封裝材料，如本研究中所採用的sio2 ，而代替在箔式錳銅計中所使用的ptfe ；並可實現敏感元件「清潔」地無機固態封裝，即將整個敏感元件是包封在無機物中，而不與高壓力下絕緣性能相對較差的有機物，如粘接劑、樹脂等直接接觸，從而在根本上消除了高壓旁路效應。
  7. Study on the optical properties of transparent epoxy / clay nanocomposites a new type transparent epoxy based nanocomposites has been prepared by the reaction of alkylammonium exchanged montmorillonite ( amt ) with diglycidyl ether of bisphenol a ( dgeba ) and triethylamine as the curing agent. the morphology of amt in the epoxy matrix was characterized with x - ray diffraction ( xrd ), scanning electron microscopy ( sem ) and transmission electron microscopy ( tem )

    光學透明環氧樹脂粘土納米復合材料光學性能採用十八烷基伯胺鹽、十六烷基三甲基溴化胺處理na基蒙脫土製備出兩種不同的有機土，以三乙胺為固化劑，有機土與雙酚a型環氧樹脂熔融插層聚合后制備出剝離型和插層型兩種結構的環氧樹脂粘土納米復合材料。
  8. National key laboratory of advanced composites ( lac ) in beijing institute of aeronautics materials ( biam ) has developed a new medium temperature curing epoxy resin system, of which the glass transition temperature is 119. 88, for resin transfer molding ( rtm ). in order to investigate the relation between viscosity and time - temperature, the rheological behavior of the system was studied by dsc and viscosity experiments. a rheological model based on the dual - arrhenius equation was established and used to simulate the rheological behavior of the resin, which was in good agreement with experimental data

    本文表徵了北京航空材料研究院先進復合材料國防科技重點實驗室樹脂組新開發出的rtm用中溫固化環氧樹脂體系3266 （玻璃化轉變溫度為119 . 88 ）其粘度隨時間、溫度的變化關系，在粘度實驗和dsc熱分析實驗的基礎上，對用於rtm工藝的該環氧樹脂體系的化學流變特性進行研究，並根據雙阿累尼烏斯方程建立樹脂體系的流變模型。
  9. Resin for strengthening and restoring structures with fiber laminate

    纖維片材加固修復結構用粘接樹脂
  10. The bonded magnets with excellent magnetic properties were manufactured by wetly - mixed epoxy and prfeb powders, which granularity was 100 to 140, and under the pressure of 600 to 800 mpa. then the magnets were solidified 2 hours, under the temperature of 160c

    結果表明，當環氧樹脂與磁粉採用溶劑濕混，成型壓力選為600 ? 800mpa ，磁粉顆粒在100 ? 140目之間，磁體在160 ~ c真空固化2小時，粘結prfeb永磁合金的磁性能達到最佳。
  11. The main results are summarized as follows : first, formulation tailoring and curing process of epoxy resin adhesive have been studied, and the peel strengths were tested. the curing temperatures are obtained following the result of curing reaction heat flow tested by dsc

    主要研究內容和結果如下:首先，研究了作為基底材料基體的環氧樹脂膠粘劑的配方，利用差示掃描量熱儀（ dsc ）確定了膠粘劑的固化溫度，並對膠粘劑進行了性能測試。
  12. The results from basic properties, shear resistance, pressure strength and point film test show that different low molecular polyamide may affect extrodinary by the properties of cured expoxy resin the higher viscosity, the lower cured activity ( rate ) ; the higher amine number, the stronger cure construction. the cured expoxy resin will prossess unfavourable mechanics when it is cured by the polyamide with both too high viscosity and amine number

    用基本性能、剪切強度、抗壓強度、塗膜性能測定等方法研究了3種不同胺值及粘度的低分子量聚酰胺對環氧樹脂固化物性能的影響.結果表明，聚酰胺粘度大使固化交聯變難，胺值過高易造成固化收縮；同時粘度過大、游離胺含量過高的產品將對固化物各項力學性能不利
  13. As a new building material for reinforcement and strengthening, the supply and application of epoxy resin structural adhesive are more and more, but standard structural adhesive itself has the disadvantages such as worse working performance, low bond strength, brittleness, low elastic ratio. so it is necessary to modify the structural adhesive

    環氧樹脂建築結構膠作為一種加固修復的新型建築材料的需求量變得越來越大，應用的范圍也越來越廣，但目前環氧樹脂結構膠存在工作性能不好、粘接強度不高、脆性大、彈性模量較低等缺點，所以有必要對其進行改性研究。
  14. Solid epoxy resin with the low epoxy value is better than liquid epoxy resin to the magnetic performance, and the content is 2 % wt will do good to improve the magnetic characteristics of the bonded ndfeb magnet

    粘結劑選用固態環氧樹脂（ e - 12 ）且在ndfeb粘結磁體中的含量為2 3為最好。
  15. Strengthening of concrete beams with externally bonded carbon fiber reinforced plastic ( cfrp ) materials appears to be a feasibe way of increasting the load - carrying capacity and stiffness characteristics of existing structures. cfrp strengthened cocrete beams can fail in involve steel yield - cfrp tenside rupture and steel yield - concrete crushing

    用碳纖維復合材料（ cfrp ）加固修復混凝土結構，增強體（碳纖維）和基體（環氧樹脂）應有良好的界面粘結強度，這是一種行之有效的加固方法，它可以提高現有結構物的承載能力和剛度。
  16. Diacetone acrylamide is an important kind of refined chemical industry product. it is widely used in coating, adhesive, epoxy resin curing agent, light - sensitive resin auxiliary agent, textile auxiliary agent, medical sanitation as well as many other fields

    雙丙酮丙烯酰胺是一種重要的精細化工產品，廣泛應用於塗料膠粘劑環氧樹脂固化劑感光樹脂助劑紡織助劑醫療衛生等領域。
  17. Abstract : the reasearch on flame retardant of organic adhesive was described in this paper. the fire retardant organic adhesive is compounded with fire retardant resin, rubber, curing agent and plasticizer, diluent, filler, coupling agent and solvent. it can avoid fire loss and ensure the safety of life and property

    文摘:論述了有機膠粘劑的阻燃問題，以阻燃性樹脂、橡膠、固化劑、增塑劑、稀釋劑、偶聯劑、溶劑等配製阻燃型有機膠粘劑，用於電子、電器、建築、汽車、化工等行業的粘接與修復，可以防止火災發生。
分享友人
分享到 Line

分享到臉書