粘結接頭 的英文怎麼說
中文拼音 [niánjiējiētóu]
粘結接頭
英文
glue joint-
Adhesives - wood adhesives for non - structural applications - determination of tensile shear strength of lap joints
膠粘劑.非結構用木材粘結劑.搭接接頭拉力剪切強度的測量16. supplemental wipers owing to the assistance of supplemental wipers, the 9 - pincer toe lasting machine can prolong the length of lasting down to cover the point of sole. after being lasted through the device the toe upper will be more closely attached to the last
16 .輔助掃刀結構輔助掃刀是配合九爪式前幫,使鞋頭結幫長度加長到前中街接轉角處,經此結幫后,可使鞋頭之皮面更粘合於鞋楦。Test method for strength properties of double lap shear adhesive joints by tension loading
用拉力負荷法測定雙搭接剪切粘結接頭的強度特性的試驗方法Structural adhesives - mechanical behaviour of bonded joints subjected to short and long terms exposure at specified conditions of temperature
結構粘合劑.短期或長期暴露于特定溫度條件下的粘合接頭的機械性能Standard test method for heat and moisture resistance of wood - adhesive joints
木材粘結接頭耐熱和耐水性的標準試驗方法Test method for accelerated aging of adhesive joints by the oxygen - pressure method
用氧壓法加速粘結接頭老化的試驗方法Testing of adhesives for metals and of bonded metal joints ; torsional shear test
金屬粘合劑和金屬粘結接頭的檢驗.扭剪試驗Standard test method for fracture strength in cleavage of adhesives in bonded metal joints
粘結接頭中膠粘劑的斷裂強度的標準試驗方法Bonded insulated joint
粘結絕緣鋼軌接頭It was found that the interfacial bonding of 93w - ofc was both the joining action of ofc / w grains and that of ofc / ni - fe binders, whereas the joining of ofc to tc4 could be seen as the mutual intense diffusion effect between ofc / tc4 and as a result cu - ti intermetallic compounds were formed at the joint. the joining of tc4 - a1 and a1 - mb2 were also attributed to the result of diffusion between elements ti - al and al - mg respectively. on the other hand, residual thermal stress and stress - induced distortion were produced at the joint simultaneously due to the difference in thermal expansion coefficient of different welding " materials
研究表明, 93w與ofc的界面連接是ofc與93w中w晶粒的連接以及ofc與93w中ni - fe粘接劑的連接共同作用的結果; ofc與tc _ 4連接界面的形成是由於ofc與tc _ 4之間發生反應擴散,並由此在二者接頭處生成了cu - ti金屬間化合物的中間相; tc _ 4 - al的連接與al - mb _ 2的連接則分別是其基體元素ti 、 al之間和al 、 mg之間元素互擴散的結果,另外,由於熱膨脹系數的差異,擴散焊接后在不同焊件的接頭處存在殘余熱應力並由此引起接頭的形變。Standard specification for solvent cements for transition joints between acrylonitrile - butadiene - styrene and poly vinyl chloride non - pressure piping components
丙烯腈-丁二烯-苯乙烯共聚物和聚氯乙烯無壓管道系統構件之間轉換接頭用液態粘結劑的標準規范Standard practice for evaluating adhesion of installed weatherproofing sealant joints
評價已安裝上的防風雨的密封接頭粘結性的標準實施規程Methods of test for ancillary components for masonry - part 2 : determination of bond strength of prefabricated bed joint reinforcement in mortar joints
圬工輔助成份試驗方法.第2部分:灰漿粘結處預制床接頭增強的粘結強度測定The numerical modeling results show that the smaller the elastic modulus of adhesive in fillet, the higher the peak stress in adhesive layer at the adjacent point to the fillet when hi - adhesives used to form the fillet and bondline respectively and is higher than that of the joint made of single adhesive
結果表明,當膠瘤採用不同於膠層的膠粘劑時,隨著膠瘤彈性模量的減小,在膠層與膠瘤的連接處膠層中應力峰值顯著提高,且均高於由單一膠所形成接頭的應力峰值。Adhesives - wood adhesives for non - structural applications - determination of tensile shear strength of lap joints ; german version en 205 : 2003
膠粘劑.非結構上用木材膠粘劑.搭接接頭的抗拉伸剪切分享友人