粘貼槽 的英文怎麼說
中文拼音 [niántiēcáo]
粘貼槽
英文
splice tray-
A small piece that is placed over the write protect notch on a diskette to prevent the recording of data so that prerecorded data will not is erased
粘貼在軟盤寫保護槽上的薄片,用於阻止對磁盤的寫入,以保護軟盤上原有的數據不被抹去。According to the special shape and operate requirements of the torpedo, the structure and moulding process of the torpedo shell are established, in which the body and overlay block with grooves are moulded by fiber winding, and close moulding respectively with the adhesive by limited stop compression. in the light of the selection of raw material system, composite system with outstanding performance are defined, based on which the mechanical properties are tested., with the overall consideration of structural characters and design demands, the main factors which may have effects on the strength and stability ( including stiffness section dimension, stiffeners space, skin thickness and skin lay angle ) is optimized one by one for the structure design parameters on the base of the fem model of skin, stiffness and layover block by fem. as a result, the prototype with 1 : 1 proportion and its structure and lay optimization design are completed. the moulding technology for polyurethane foam moulding the stiffened shell is obtai ned in terms of the design, manufacture moulding, experimental mould and tooling
依據在研產品特殊的外型結構和使用要求,確定了該型號水雷復合材料殼體的具體結構形式和復合成型工藝路線,即由纖維纏繞工藝成型主體異形件,閉模成型帶通槽外貼塊,用限位加壓工裝實現粘接的工藝路線;通過對原材料體系的篩選,確定了綜合性能較好的復合材料體系,以此為基礎進行了力學性能測試;運用有限元方法,建立了蒙皮、筋條和外貼塊的分析模型,綜合考慮結構特點和設計要求,對影響結構強度與穩定性的主要因素(包括筋截面尺寸、筋間距、蒙皮厚度、蒙皮鋪層角度)分別進行了結構設計參數的優選,最終完成了復合材料異形耐外壓殼體1 : 1樣件和縮比實驗件結構及鋪層優化設計;完成了聚氨酯泡沫胎成型內置加筋殼體的成型工藝技術研究;對縮比件進行外壓性能測試,並給出了應力、應變測試結果。Conclusion : the curative effect of the light - cure veneer bonding group was obviously better than the direct bonding group
結論氟斑牙光固化貼面粘結托槽組的療效明顯好於氟斑牙直接粘結托槽組。Objective : the purposes of this study were to compare the expulsion rates of orthodontic brackets bonded by different methods to series fluorotic teeth and to find a effective method for increasing bonding strength of orthodontic bracket bonded to fluorotic teeth
摘要目的通過正畸臨床上重度氟斑牙採用光固化貼面粘結托槽技術和托槽直接粘結技術的臨床效果的比較,為臨床氟斑牙的托槽粘結提供一種有效的方法。分享友人