系統負載 的英文怎麼說

中文拼音 [tǒngzǎi]
系統負載 英文
system loading
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : Ⅰ名詞1 (事物間連續的關系) interconnected system 2 (衣服等的筒狀部分) any tube shaped part of ...
  • : Ⅰ名詞1 (負擔) burden; load 2 (虧損) loss 3 (失敗) defeat Ⅱ動詞1 [書面語] (背) carry on th...
  • : 載Ⅰ名詞(年) year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 系統 : 1. (按一定關系組成的同類事物) system 2. (有條理的;有系統的) systematic
  • 負載 : [電學] load
  1. This thesis focuses on middleware - based load balancing supported by corba, and has made the following contributions : ( 1 ) based on the previous research, we give a method using resource utilization and harmonic mean performance to quantify the load of each node in the heterogeneous environment, which makes the loads comparable

    本文的主要研究內容就是基於corba中間件的均衡,具體的研究工作有以下幾點:探討了系統負載的衡量問題,借鑒前人的研究成果,採用以資源利用率和節點的調和性能平均值來綜合衡量系統負載的方法,量化了異構中各節點的性能,使得具有可比性。
  2. The actual delays depend on line speed and system load

    真正的延遲時間依賴于線路的速度和當時的系統負載
  3. The improvement system is made up of the pressure sensor, flow sensor, displacement sensor, electro - hydraulic proportional flow control valve, power amplifier, data gathering board and computer. the platform can carry out testing the hydraulic parameters, processing the tested data, saving the processed data and drawing, adjusting the pressure automatically

    改造后的測控主要由壓力傳感器、流量傳感器、位移傳感器、比例節流閥、功率放大器、數據採集卡和計算機組成。改造后的實驗臺具有自動採集實驗數據、自動處理實驗數據、自動保存實驗數據、自動調節液壓系統負載壓力等功能,大大提高了實驗臺的工作效率、測試精度和智能化水平。
  4. First, mathematical model of swaying system is made, which is a basis on later chapters. meanwhile, the system is simulated and designed. the effect of loaded mass, loaded suppleness, general leaking coefficient and cubage elasticity modulus on performance of system is also analyzed

    首先,作者建立了橫蕩控制的數學模型,作為以後各章節討論的基礎,同時對進行模擬和設計,並研究了系統負載質量、剛度、總漏損數和容積彈性模數對性能的影響。
  5. Ananasis on the short - eircuit current of the infinitely great electric power system

    無限大容量電力系統負載短路電流簡析
  6. When the system load over 0. 69, there are deadline dropping in the rma scheduling

    實驗表明,系統負載大於0 . 69時, rma調度中開始有死線丟失。
  7. This innovation can greatly balance the load of system and dramatically decrease the communication between the distributed checkpoints in the detected network and the central management point

    這種分佈性能夠很好地平衡系統負載,明顯地減少大型網路入侵檢測中分散的檢測點與管理點之間的通信量,顯著提高運行效率。
  8. Aiming at wide variations in loads and moment of inertia, large disturbed moment of a permanent magnet synchronous motor position servo system, and the problem of velocity limit to uniform sliding mode control, a cascaded compound slide mode controller was proposed and designed for permanent magnet synchronous motor position servo system

    摘要針對某永磁同步電動機位置伺服系統負載力矩和轉動慣量變化大、干擾力矩強的特點,以及一滑模變結構控制速度限幅的難題,提出並設計了串級復合滑模變結構拉制器。
  9. Load balancing algorithm for high - speed network intrusion detection systems

    高速網路入侵檢測系統負載均衡策略與演算法分析
  10. In the present paper, according to the characteristics of the dynamic running of the thermoelectric refrigerating devices and its components for the refrigerator is analyzed and the independent components " models are established. the entire model describing the working procedure of the refrigerating system is set up with the method of parameters coupling to combine the models of the refrigerating system, load, cabinet and air in the cabinet. the running characteristics of thermoelectric refrigerators on the effects of received current, load and ambient temperature are investigated using small - signal linearization method

    本文根據熱電製冷動態運行的特點,分析了電冰箱製冷及各個部件的熱物理過程,運用參數耦合的方法把製冷、箱體及箱內空氣模型有機地結合在一起,建立了完整的製冷工作過程模型,用小階躍信號線性化法分析了電流、功率和環境溫度波動共同作用下的熱電製冷器工作特性。
  11. Parallel and distributed systems, 1993, 4 : 175 - 186. 4 singh h, youssef a. mapping and scheduling heterogeneous task graphs using genetic algorithms. in proc

    在異構環境中,通常採用啟發式調度演算法,這種演算法利用任務執行時間和系統負載的歷史數據來調度任務。
  12. In order to instantly and real time eliminate harmonic and compensate reactive power, the definition of traditional reactive power, an integral average during a period, which is confined to apply under some circumstances. for example, when the load power varies swiftly, it will lead to can " t compensate reactive power rapidly

    為了實時、快速的補償無功功率和消除諧波,傳的基於平均值計算出來的功率因數,是以一個周期內積分而得出來的平均值,這在某種情況下就限制了它的應用,如系統負載功率快速變化時,就不能做到迅速、實時地補償無功。
  13. Microsoft has released a patch that resolves an issue where under a heavy system load, access to a floppy disk drive may result in the following error message : system process - no disk there is no disk in the drive

    Microsoft已發行一個修補程式,用來解決在系統負載過重時存取軟碟機可能會出現的問題。原本可能會出現以下的錯誤訊息:處理沒有磁片磁碟機中沒有磁片。
  14. In this chapter, it puts forward a new system about checkpoint, avoiding the domino - effect and livelock. it realizes the storage of process context and other states with the form of executing file in the diskette by using checkpoint system and applying the page switching principles in linux. consequently, when the process has wrong at the checkpoint, it can move out the process in the fault machine, then choose other normal machine, continue to execute from the interrupted point, finally achieve the process migration and load balance of the system

    同時提出一種新的檢查點機制,避免了多米諾效應和活鎖,並且利用檢查點機制,應用linux中頁面的換出原理,實現了對進程的上下文以及其他狀態以可執行文件格式保存在磁盤,從而使該進程能在節點發生故障的情況下,將故障機的進程遷出,然後選擇其他正常節點機,從斷點處繼續運行,最終達到對該進程的遷移,並且實現系統負載平衡。
  15. The server can ' t process your request due to a high load, please try again later

    后臺基本設置服務器優化開啟了系統負載控制修改為0即可!
  16. The faults in the automotive engine control systems can be reliably diagnosed by the proposed method through suitable choice of the threshold for the residual signals of the uifdos

    合理選擇殘差信號的閾值,能夠可靠地診斷汽車發動機電控系統負載不可測且存在隨機干擾時的故障。
  17. Define a service to check the load

    定義檢測本地系統負載的檢測服務。
  18. A novel method of pmsm ac servo system ' s load torque motion compensation

    永磁同步電機交流伺服系統負載轉矩動態補償方法
  19. Abstract : the application of unknown input fault detection observers ( uifdos ) to the diagnosis of electronically controlled systems in automotive engines with unmeasurable load torque and random disturbances is presented in this paper

    文摘:針對汽車發動機電控系統負載不可測且存在隨機干擾的情況,採用基於數學模型的未知輸入故障檢測觀測器方法,研究其故障診斷問題。
  20. Design of load variation compensation in the material testing machine system

    材料試驗機系統負載變化補償設計
分享友人