約束扭轉 的英文怎麼說

中文拼音 [yāoshùniǔzhuǎn]
約束扭轉 英文
restrained torsion
  • 約 : 約動詞[口語] （用秤稱） weigh
  • 束 : Ⅰ動詞1 （捆; 系） bind; tie 2 （控制; 約束）control; restrain Ⅱ量詞（用於捆在一起的東西） bundle;...
  • 扭 : 動詞1 （掉轉; 轉動） turn round 2 （擰; 旋轉） twist; wrench 3 （擰傷） sprain; wrench 4 （走路時...
  • 轉 : 轉構詞成分。
  • 約束 : keep within bounds; restrain; bind; bound; boundage;tie; restraint; restriction; engagement; repr...
  1. The 4lh part is the innovation and conclusion of the dissertation. it puts forward freshly three aspects on the base, precondition and circumstance of risk prevention, especially researches for the risk foundations - " transition period " and hinese characteristic market economy ". it brings out five entries to risk prevention : retortion of the direction of macroscopically adjustment, market financing, system innovation, the decentralization and recombination of the state property right, reformation of organizational system in the state commercial bank and the establishment of inspiritment - obligation system

    第四章是全文的創新和結論部分，通過對風險防範的基礎、前提條件和環境三方面的創新論述，特別是對「轉軌時期」和「中國特色的市場經濟」兩個風險基礎的研究，提出了風險防範的五個切入點：扭轉宏觀調控方向、市場觸資制度創新、國有產權的分散重組、改革國有商業銀行組織制度和激勵? ?約束機制的建立。
  2. The connection between the torque and the polarized charges is established. on the base of mathematical model of torsional effect, using multivariate unrestrained nonlinear optimization method, we research cutting angles and parameters of crosssection to get best torsional sensitivity

    在建立石英晶體扭轉效應模型的基礎上，應用多變量、無約束非線性優化方法對于晶體切型、截面形狀等參數進行了優化，以獲得最佳扭轉靈敏度。
  3. When analyzing skew support continuous curved box girder bridge, curved grid girder analyzing method considering warping effect is applied. matrix displacement method is applied in analyzing skew support continuous curved thin - walled box girder bridge with restrained bearing. in order to convert original rigidity equations to structural rigidi ty equations that can be solved, bearing nodal displacement matrix can be introduced, then unknown quantities at the edge of beams can be consistent with the restrained directions of skew bearings, unit rigidity matrix and unit nodal forces can be gained. structural rigidity matrix can be composed according to matrix displacement method, so nodal displacements and inner forces on the end of the rod that are unknown can be gained calculating equations of inner forces on any cross - section can be solved

    分析斜支承連續曲線箱梁橋時，採用考慮翹曲作用的曲線格子梁分析方法，應用矩陣位移法對具有約束支承形式的斜支承連續曲線薄壁箱梁橋進行分析，考慮到支座的約束條件並不與梁端彎曲角位移和扭轉角位移的方向一致，引入支座節點坐標矩陣，使得梁端的位移未知量與斜支座約束方向一致，來計算單元剛度矩陣和單元節點力，然後按照矩陣位移法組集總剛並建立結構剛度方程，根據結構剛度方程即可求解未知的節點位移及桿端力，推導出任意截面處的內力計算公式。
  4. The total elastic coupling is the sum of the restraints due to the bending of the tapes and the twisting of the wire.

    總的彈性耦合是張力帶彎曲及張力線扭轉所產生的約束力矩之和。
  5. As the basis of stochastic torsional analysis, a stepped thin - walled beam model with complex cross - sections of arbitrary shapes ( open, closed or mixed ) is established in this paper, which takes into account the effect of secondary shear flow resulting from warping restraint

    摘要具有復雜斷面形狀的階梯精密梁模型作為扭轉隨機分析的基礎，可以計及翹曲約束引起的二次剪流。
  6. The aims of this thesis are buckling and ultimate strength. its main content is as follows : emphasizes the significance and purpose of the research in buckling and ultimate strength, and reviewing the status in this field, and puts forward the research task ; analyzes and discusses the design formulations for the buckling strength of the ship plating, in which the influence of residual stresses, lateral pressure, cut - outs and rotational restrains is taken into account

    本文以船體板的屈曲和極限強度為研究目標，主要內容有： ?指出研究船體板屈曲和極限強度的意義和目的，簡要回顧了國內外的研究現狀。並提出本文的研究內容； ?考慮殘余應力、側向壓應力、開孔和扭轉約束對于板格的屈曲強度的影響，討論了各個因素影響下的板格的屈曲強度計算公式。
  7. According to the classical theory of thin - walled members this paper presents the derivation of energy equation under restrainted conditions, and a elastic restrainted stiffness matrix of thin - walled members is derived. continuous restrants and discrete restraints are considered in the energy equation. euler - equation of the derived energy equation is testified

    根據薄壁構件彎曲與扭轉理論，對彈性約束條件下薄壁構件的能量方程進行了推導，再根據總勢能最小值原理推導出彈性約束條件下薄壁構件的單元剛度矩陣。能量方程中考慮的約束情況有連續的線彈性約束和離散的彈性點約束。
  8. As a result, it is suggested that distortion should be taken into account to calculate the thin - walled bar with restrained torsion

    因此建議，對薄壁桿件作約束扭轉分析時一定要考慮截面畸變的影響。
  9. Constrained twisting deformation

    約束扭轉變形
  10. Because of its simplicity of the critical moment and the good precision, the solutions based on gjelsvik theory are used in the elastic - plastic phase. the ultimate load carrying capacity of box section beams are calculated considering the effect of plasticity and residual stresses

    其次，運用基於gielsvik約束扭轉理論推導了箱形偏壓桿的彈性彎扭屈曲荷載，同時給出了壓彎桿在彈性彎扭屈曲的軸力和彎矩相關關系。
  11. First, the stability of box section beams under pure bending is studied based on two different torsion theories on members with closed cross - section by umansky and gjelsvik in the elastic phase, and the critical moments are obtained. comparisons show that these two different theories give nearly the same critical moments

    文章首先對箱形梁進行研究，分別基於umansky約束扭轉理論和gielsvik約束扭轉理論推導了箱形梁在純彎作用下的彈性臨界彎矩，並進行了比較，發現基於gielsvik約束扭轉理論的臨界彎矩具有較好的精度且形式簡單。
  12. Steady state response of the coupled lateral - torsional vibrations of geared rotor system under a holonomic constraint

    完整約束下齒輪嚙合轉子系統的彎扭耦合振動穩態響應
  13. The analysis of creep buckling of compressed column with initial imperfection and torsional elastic restraint

    具初始缺陷兩端扭轉彈性約束壓桿的蠕變屈曲分析
  14. The results of analysis show that : 1 ) doi of the pin - axis errors, especially the crank - pin - axis errors, is bigger than other axis errors ; 2 ) from the calculating results of doi of the errors of the different kinematic pairs, doi of rotate - completely pairs is bigger than that of oscillate pairs ; 3 ) the forced coupler - deformations resulted from the constraints out of motion plane consist of twisting and bending deformation, and the deformations are variat

    （ 4 ）首次提出了運動副誤差對平面連桿機構約束不確定性影響度的評判指標和單因素定量分析方法，得到了機構中不同運動副的不同平面內的誤差對機構性能的影響程度。本文的分析計算結果表明，平面連桿機構中的非平面約束所造成的連桿強制變形中既有扭轉變形又有彎曲變形。
  15. Experimental studies of torsional characteristics of bellows with or without outer barrel constraint

    無約束條件下波紋管扭轉特性的實驗研究
分享友人
分享到 Line

分享到臉書