純增生過程 的英文怎麼說

中文拼音 [chúnzēngshēngguòchéng]
純增生過程 英文
pure birth process
  • 純 : 形容詞1 （純凈; 不含雜質） pure; unmixed 2 （純粹; 單純） simple; pure and simple 3 （純熟） skil...
  • 生 : Ⅰ動詞1 （生育; 生殖） give birth to; bear 2 （出生） be born 3 （生長） grow 4 （生存; 活） live;...
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 過程 : process; procedure; transversion; plication; course
  1. The results from x - ray diffraction demonstrated that pp / mmtome was a fully intercalated nanocomposite, pp / mmtom and pp / ommt were partly intercalated nanocomposites, but the intercalation effect of pp / mmtom nanocomposite was better ; the crystallization characteristics of pure pp and pp / mmt nanocomposites were investigated by dsc, waxd and pom. the result of these testing showed that mmt nano - layers acted as nucleating agents for the crystallization of pp, the addition of mmt had effect on the crystallization process, leading the increasing of crystallization temperature crystallization rate and crystallinity, but also the dimension of spherulite reduced. but the formation of pp crystal did n ' t change, the formation of pp crystal in three pp / mmt nanocomposites and pure pp were a - form on the whole ; influences of three sorts of mmt on mechanical properties of pp / mmt nanocomposites were studied, as a result, the addition of mmt comprehensively improved mechanical properties of pp : notched impact strength, tensile strength and flexural properties were all increasing, but the extent of increasing were n ' t large

    通過xrd分析比較這三種pp mmt納米復合材料微觀結構得到， pp mmt _ （ ome ）屬于完全插層， pp mmt _ （ om ）與pp ommt的插層程度相近，但是pp mmt _ （ om ）相對較好；通過對純pp和三種pp mmt納米復合材料的結晶性能研究發現，蒙脫土納米片層對pp結晶產生明顯的異相成核作用，結晶能力增強，使pp的結晶溫度和結晶速率提高，結晶度增加，球晶晶粒細化，但是沒有改變pp的結晶形態，三種pp mmt納米復合材料的結晶形態都屬于晶；通過對pp mmt納米復合材料的力學性能測試得知，蒙脫土的加入全面提高了pp的力學性能，缺口沖擊強度、拉伸強度和彎曲性能都有一定程度的提高，浙江{ _業大學碩十學位論文摘要但是提高幅度都不是很大，不過ommt 、 mmtom和mmtc ） me三種蒙脫土對pp力學性能有著不同的改性作用，其中pp / mmtom最好， pp月邊mto崛次之， pp / ommt最低，這種情況主要是由蒙脫土對pp結晶性能的影響和蒙脫土的納米改性作用造成的。
  2. In order to select male nucleo - sterile new genotype, a tentative idea was put forward for the nucleo - male sterility to attach a tps ( thermo - photoperiod sensitivity ) and a selection strategy of combination of selection and identification, at the same time, the spring and summer sowing method were used to provide different environment conditions of appraising sterility and tps. the results indicated that ( 1 ) sterility could be appraised under the spring sowing environment and tps could be appraised under summer sowing environment. ( 2 ) under spring sowing environment, sterility could be selected, but not maintained. thereby, lines selected could only be selected as recorded selection method in the experiment. ( 3 ) and then, selection was carried out from spring sowing line selected into summer sowing in same line with tps to select plants. these plants through the intercrossing selection had been combined with sterility and tps. in this way, a new selection protocol for selection sterile line with tps was formed. it mainly involves the spring and summer sowing method, recorded selection method and the intercrossing selection method

    為了選育新類型玉米雄性核不育系，提出了為玉米核不育性添加溫光敏感性的設想和選擇與鑒定相結合的策略，同時應用分期播種的方法為作物提供不同的生長和發育的環境條件，以鑒定玉米雄穗的育性變化和對不同環境條件溫光的反應.研究結果表明，春播環境下可鑒定和選擇玉米的不育性，夏播環境下可鑒定和選擇其溫光敏感性.針對玉米核不育性難以找到保持系的特性，結合兩種播期選擇兩種性狀.但春播環境下選擇的不育性群體難以通過選擇單株來保持其不育性，為記錄性群體選擇.通過從春播入選的雜合不育性優良株系群體轉移到其對應的夏播溫光敏感性入選的同一優良群體中進行優良單株選擇，能逐漸使不育性和溫光敏感性相結合而選育出純合溫光敏不育系.這種新的選擇程序主要包括應用分期播種法、記錄性選擇法和春夏兩季交叉式選擇法，使含有不育基因的可育株系逐步累積不育基因並增加了溫光敏感性而育成玉米溫光敏不育系
  3. The extreme values of the local steam content in steam generating tubes from the furnace side are shown in fig. 2. as is seen, the critical heat flux levels corresponding to them can reduce to real values in these cases, especially when their mentioned increase in transient processes is taken into account

    極值的地方蒸汽量蒸汽發生器管子從爐側列圖.不應純粹是見過的臨界熱流水平相應可以減少實際值在這種情況下，特別是當他們提到增加，在暫態過程中考慮進去
  4. Low grade fuels and / or polluted air can cause gum, varnish and carbon deposits to be formed in the carburetor during comustion which can result in rough idling, stalling and incrased gasoline consumption. 3 + 3 cleaner ' s superior formula will effectively remove gum, varnish and carbon deposits when sprayed directly into the carburetor, 3 + 3cleaner will clean carburetors, linkage, automatic chokes, pcv valves, heat risers, the spark plugs and the entiro system while lubricating and femoving moistuer on all moving parts, use 3 + 3 cleaner to restore efficiency, increase engine power maintain high gasmileage and have a smooth running engine

    空氣和汽油中的不純物質，在汽車使用過程中會產生污垢和炭積物，阻塞汽車的化油器（呼吸系統） ，使汽車無力及加油不暢順， 3 + 3牌化油器強力清洗劑獨有的特殊配方，直接噴入于化油器內，能迅速有效地清除洗化油器，火花塞及燃油系統的油漬污穢和炭積物，並對轉軸等旋轉部位提供潤滑及防銹保護，減少積炭的產生，使引擎起動順利及平穩運轉，增強馬力及節省燃油
  5. Low temperature membrane filtrating is the key step the filtration membrane was often blocked during daft beer production on account of raw materials, technique and staff, etc, resulting in increase of cost

    摘要純生啤酒在生產過程中低溫膜過濾是關鍵環節，由於原料、工藝、人員等的因素，常常會導致過濾膜發生堵塞，增加生產成本。
  6. It is found that the ablated surface morphologies for both the ti samples of different roughness have a similar change trend from roughening to smoothing with increasing the shot number, where the surface roughening is relatively weaker at lower ion current density

    通過輻照不同原始粗糙度的純金屬ti發現，隨著輻照次數的增加，燒蝕表面形貌均發生表面粗糙化向光滑化的轉變。離子束流密度較低時，輻照表面的粗糙化程度較弱。
分享友人
分享到 Line

分享到臉書