純磁鐵 的英文怎麼說

中文拼音 [chúncítiě]
純磁鐵 英文
pure magnetic iron
  • 純 : 形容詞1 （純凈; 不含雜質） pure; unmixed 2 （純粹; 單純） simple; pure and simple 3 （純熟） skil...
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 鐵 : Ⅰ名詞1 （金屬元素） iron （fe） 2 （指刀槍等） arms; weapon 3 （姓氏） a surname Ⅱ形容詞1 （形容...
  • 磁鐵 : [物理學] magnet; ferromagnet; magnetic-iron
  1. Edge of the granule image by video is the key of its image partition, the article tries to carry through a deeper research on image partition at the same time. granule is made up of savageness mater and industry material ( including of rock, sand, earth, atomy, steel, china, concrete, ink powder, magnetism powder, light fine and tiny powder used silicon, cell etc. )

    顆粒是構成天然物質和工業材料（巖石、礦石、沙子、泥土、塵埃、鋼鐵、陶瓷、水泥、墨粉、磁粉、光纖和料封裝材用高純硅微粉、細胞等）的基本單元，顆粒尺寸（粒度）是顆粒的首要特徵和粉體材料的第一指標。
  2. The interstitial net and aggregates may be of solid sulfide but most contain magnetite and silicate in widely varying proportions.

    粒間網線及集結體可以是純硫化物，但大多數含有不同比例的磁鐵礦及硅酸鹽礦物。
  3. Technical requirements for magnetic iron hot - rolled plates

    電磁純鐵熱軋厚板技術條件
  4. Technical requirements for magnetic iron bars

    電磁純鐵棒材技術條件
  5. Magnetic iron cold - rolled sheets

    電磁純鐵冷軋薄板
  6. The raw materials, the composition, the time of milling, the calcining temperature, the different additives, the sintering temperature and the sintering parameters were investigated. the result showed : it was advantaged to obtain high initial permeability mnzn ferrite with stable frequency characteristic using high - purity raw materials ; in order to obtain mnzn ferrite with high properties, we must control strictly the composition ; it could improve the properties of mnzn ferrite by optimizing calcining temperature. the lower calcining temperature made the permeability higher, and the higher calcining temperature could promote the frequency characteristic of permeability ; we chosen the right time of milling according to the requirement of power diameter ; in order to improve the properties of mnzn ferrite, it is necessary to add effective additives. in this dissertation, the influence of bi2o3 、 moo3 、 k2co3 、 co2o3 were investigated ; the sintering temperature, the time of heat - retaining and sintering parameters were the key factors of preparing high permeability mnzn ferrites

    研究結果表明:採用高純度的fe2o3有利於獲得高起始磁導率且頻率特性優良的鐵氧體;為了制備所需性能的鐵氧體，需要嚴格控制配方中各種原材料的含量，優化配方;由於粉體活性受預燒條件的影響，所以對不同要求的鐵氧體選擇的預燒條件就不一樣，適當降低預燒溫度有利於獲得較高的起始磁導率，而為了獲得良好的頻率特性可以適當地提高預燒溫度;根據對粉體顆粒粒徑的不同需求，可以選擇不同的球磨時間;而有效的添加劑是改善材料性能的必要條件，本文在添加劑的研究中主要對bi2o3 、 moo3 、 k2co3 、 co2o3的影響分別作了詳細地討論;燒結溫度、保溫時間和燒結氣氛是高磁導率mnzn鐵氧體制備最關鍵的工藝，適宜的燒結工藝可以獲得理想微結構和組成，從而得到高性能的鐵氧體材料;而從材料的微結構上來看，要提高材料的截止頻率，就要適當地細化晶粒、增加晶粒內部的氣孔。
  7. By successful solution of non - linear magnetic fields and revision of the program, we can reach following conclusions : in the computation of nonlinear magnetic fields, if iteration method is used, under - relaxation is necessary when amending the permeability distribution in soft magnetic materials ; and when < wp = 5 > calculating the equivalent current density in permanent magnets, under - relaxation is not a necessity ; when searching for permeability values by interpolation method on the demagnetization curve of soft magnetic materials, if a fixed saturation point is set, around this point an abrupt change of permeability values will be obtained ; this sudden change may cause a little problem in the smoothness of magnetic field distribution ; because the magnetic circuits of microwave tubes are too complicated, in the author ' s view, to describe the working state of a magnet system, the working points of magnets can not do it properly but average energy production of magnets will serve ; as to indicate the quality of a magnet system design for microwave tubes, the efficiency of magnetic energy utilization will be a very good criterion

    由此得出結論，在非線性磁場計算中：採用迭代法的情況下，在各迭代循環之間進行磁導率修正時，一個欠鬆弛迭代過程是必需的；對永磁體中的等效電流修正時可以不作欠鬆弛迭代；在純鐵的磁化曲線上指定某一個固定的磁感應強度為磁飽和值，會使得插值求出的磁導率在該磁飽和值附近有一突變，這一突變對計算結果中磁場分佈變化的光滑性稍有影響。在微波管磁系統設計中，由於微波管磁路比較復雜，作者認為磁體的工作點並不能很好地反映磁體的工作狀態，而採用平均磁能積為衡量磁體工作狀態的標準更加符合微波管磁系統的實際情況；要表示磁系統設計好壞的程度，則用磁能利用的效率為標準更好。
  8. Measurement methods of magnetic properties of electrical iron

    電工用純鐵磁性能測量方法
  9. Specifications for sintered iron soft magnetic materials

    燒結純鐵軟磁材料.技術條件
  10. The main steel gradesare stainless steel, eletromagnetic pure iron, silicon steel, gearsteel, die steel, cold heading steel and high quality carbon steel etc

    主要品種有不銹鋼電磁純鐵硅鋼輪鋼模具鋼冷鐓鋼優炭鋼等。
  11. Color purity magnet

    色純度調節磁鐵
  12. The standard model predicts that electrons and quarks behave as microscopic magnets with a specific strength and that their behavior in an electric field is determined purely by their electric charge

    標準模型預測，電子與夸克的行為就像是微小的磁鐵，有明確的磁矩，而且它們在電場里的行為純然由其電荷大小決定。
  13. Precision forged claw poles are made of purified iron bars and steel 08 with better magnetoconductivity absolutely preceding the previous casting parts

    精鍛「爪極」原材料採用純鐵棒料和08號鋼棒料，導磁性能絕對優于原有的精鑄件。
  14. At this year ' s march meeting of the american physical society, the group reported that this gossamer substance is ferromagnetic ( like iron ), the only type of pure carbon that has that property

    在今年3月舉行的美國物理學年會中，該研究群發表了這種薄紗狀的物質能擁有像鐵一樣的鐵磁性，這可是純碳物質中唯一具有這種特性的例子。
  15. Meanwhile, in the experimental work, the scope of the equation that reveals the relation between the magnet force and the working distance is defined definitely. different materials of the magnet core are compared in terms of their influence to the valve. however, it is only initiatory, more work needs to be done in the future

    同時，還採用試驗研究的手段深入分析了電磁閥工作間隙與電磁吸力之間的關系，明確了吸力公式的應用范圍，同時，在不同材料的對比試驗中，分析了磁性能較好的鐵氧體和鐵鉻合金以及工業純鐵對電磁閥工作性能的影響，對合理確定電磁閥鐵芯的製作材料進行了初步的探討。
分享友人
分享到 Line

分享到臉書