細鋁粉 的英文怎麼說

中文拼音 [fěn]
細鋁粉 英文
atomized aluminium
  • : 形容詞1 (條狀物橫剖面小) thin; slender 2 (顆粒小) in small particles; fine 3 (音量小) thin ...
  • : 名詞[化學] aluminium (13號元素, 符號al)
  • : Ⅰ名詞1 (粉末) powder 2 (用澱粉製成的粉條或粉絲) noodles or vermicelli made from bean potato o...
  1. The best technical condition of the reed pulp is in 47 sr, wipped off primary fines and added secondary fines up to 10 %, meanwhile, adding stuffings ( abietic acid, vitriolic aluminium, french chalk )

    漂白蘆葦漿抄造文化用紙的最佳工藝條件為:在打漿度為47 sr時去除一級小纖維,加入10 %的二級小纖維,同時加入填料(松香膠、硫酸、滑石) 。
  2. The equipment could mill all kinds of material which could be milled on traditional pulverizer, but also could mill powder which strictly prescribe the maximal diameter and size distribution is confined, such as kaoline, talcum powder, copycat powder, coating, mica, hormones, alumina etc

    設備都能超加工在普通碎機上能夠被碎的物料,尤其適合加工那些嚴格規限最大顆粒井要求粒度分佈狹窄的產品,比如高嶺土、滑石、復印機、塗料、雲母、生長素、氧化等。
  3. Chemical analysis methods and determination of physical performance of alumina determination of the fine particle size distribution less than 60 m - method using electroformed sieves

    氧化化學分析方法和物理性能測定方法小於60 m的末粒度分佈的測定濕篩法
  4. At last, the surface of the alumina femoral head was grade - polished with sic micropowder and diamond grinding cream, the join part was trimmed with specific instrument, which made the surface of the alumina femoral head reach the degree of approximating mirror finish and match the femoral stem well. the artificial partial hip joint prostheses was finally got by articulating the alumina femoral head with ti alloy femoral stem coated with bioactive coating

    最後,採用sic超和金剛石研磨膏對氧化陶瓷股骨頭表面進行分級拋光,用專用器械修整其聯接部位,得到表面具有近似鏡面光潔度並與股骨柄配合良好的氧化陶瓷股骨頭,並與表面塗覆生物活性塗層的鈦合金股骨柄配伍,最終獲得人工半髖關節假體。
  5. High pressure grinder brief introdction high pressure grinder. the machine is on purpose to grind the barite, h igh pressure grinder limestone, kaolinite, cerames, ahd slags, etc, below scale 9. 3 of moh, shardness and 280 - odd sorts of non - inflammable and non - explosive stuff in the trades of mining, metallurgical industrial, chemical engineering and building material for high fine powder generation and processing

    高壓微磨主要適用於常規物料的研磨碎,如高嶺土石灰石方解石滑石大理石重晶石石膏氧化鐵紅氧化鐵綠氫氧化顏料膨潤土陶土等濕度小於8 ,莫氏硬度在6級以下的非易燃易爆物料的超加工。
  6. Alumina is then extracted from the furnace and passed over vibrating sieves to obtain an extremely fine powder with a diameter of less than one micron

    從煅燒爐中提取出來。通過振動篩,篩出直徑不足1微米的超末。
  7. The aluminum may be replaced at least in part with finely particled zinc, zirconium, boron, or magnesium.

    至少可以部分地用粒度的鋅、鋯、硼或鎂所代替。
  8. Abstract : this paper dicussed the preparative parameteres synthesized mullite ultrafine powder by sol - gel and co2 scfd ( supercritieal fluid drying ) method from teos and al ( no3 ) 3 ? 9h2o as raw materials. the control parameteres of the colloidal particle size forming in sol - gel process and the gel structure and the scfd were studied by, xrd, tem and bet techmiques

    文摘:研究了以正硅酸乙酯和硝酸為原料,採用溶膠一凝膠法結合co2超臨界流體低溫乾燥技術合成莫來石超的制備參數控制,並利用xrd 、 tem和bet 、技術研究了溶膠-凝膠過程中溶膠膠粒大小的控制和凝膠結構的控制及超臨界流體乾燥技術的控制。
  9. Synthetic mullite slag dam, high - alumina salg dam and mg - alcastable for continuous cadting tundish developed by this factory has good heat stsbility, strong erosion resistance. it is produced by adopting high aluminium and super fine powder little cement casting workmanship, which has such advantages as advanced craft, stable quality and distinguished function

    連鑄中間包用莫來石擋渣堰板,高質擋渣堰板,鎂澆注料第我廠開發的適用於連鑄中間包用,具有熱穩定性好、抗耐蝕能力強等特點,它採用高,超低水泥澆注工藝技術生產,具有工藝先進,質量穩定,性能優良的特點。
  10. Infrared spectrum research on surface modification of aluminum hydroxide superfine powder fillers

    表面改性氫氧化體填料的紅外光譜研究
  11. Surface modification of ct136 to superfine alumina powder

    136對超氧化體的表面改性
  12. The results indicate that using the self - pulverized process, we can obtain a high - purity ultrafine aluminum oxide powder, so, this method has promising application perspectives

    試驗研究表明,採用自化工藝,可獲得高純超氧化體,具有廣闊的應用前景。
  13. A study on process of pellet - enveloping - roasting for pretreating refractory gold concentrate

    輕燒高礬土製備超料的工藝
  14. Inflammable fine aluminium powder

    易燃細鋁粉
  15. The technique of producing the tiny ceramic powders by ultrasonic atomizer

    超聲霧化制備超氧化陶瓷體技術
  16. Under the same experimental conditions, the reaction is more thorough and the durative time of the reaction is also longer when the quantity ratio of cuo to the other oxides is 3 : 1 than when it is 2 : 1

    在相同的實驗工藝條件下, cuo末與其它氧化物末的質量比為3 : 1時,原位反應比2 : 1時徹底,持續時間較長,所制備基復合材料微觀組織均勻小。
  17. Are produced by mixing finely divided reactive silica with a binder and then adding an aeration agent, usually in the form of al - powder

    由一種捆紮物分開的微活性的硅土製成,然後加入氣化介質,通常是以的形式。
  18. In the process of making 95 alumina ceramics, selected five kinds of alumina powder and studied the influence of different alumina powder on the sintering properties and mechanic properties of 95 alumina ceramics, moreover, selected the most agreeable alumina powder according to the apparatus for granularity analysis and scanning electron microscope ( sem ). the influence of different sintering temperature on the sintering mechanic properties, the microstructure of 95 alumina ceramics were investigated by adding y2o3 and la2o3 as two kinds of rare earth additives in alumina ceramics. the results indicated that the additive of la2o3 could improve the properties of 95 alumina ceramics more effectively and could get fine grain and tabular alumina that can enhance the strength of the material

    選用了五種al2o3料,研究了其對95al2o3瓷燒結性能和力學性能的影響,並結合粒度分析儀sem對al2o3料進行優選;通過添加y2o3 、 la2o3兩種稀土添加劑,研究了不同燒成溫度對95al2o3瓷的燒結性能、力學性能及顯微結構等的影響,結果表明:添加la2o3可以有效提高95氧化瓷燒結性能和力學性能,形成晶和板狀氧化瓷的顯微結構;通過對比不同氧化料制備氧化瓷燒成溫度曲線與燒結性能的關系,確定最佳的燒成溫度范圍為1570 ~ 1600 。
  19. An ink pigment consisting principally of finely pulverized aluminum particles that leave a silver appearance on the printed substrate

    中義在印墨中加入極,在被印物上會出現如銀一般的表面。
  20. The main purpose of the study is to prepare aluminum titanate ( al2tio5 / at ) fine powder with good thermal stability. improving the thermal stability of aluminum titanate synthesized by using single mgo additive is emphasized

    本論文研究的主要目的是合成出具有良好熱穩定性的微鈦酸體,重在提高使用單一mgo添加劑穩定鈦酸的能力。
分享友人