結構電荷 的英文怎麼說

中文拼音 [jiēgòudiànhé]
結構電荷 英文
structure charge
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 荷 : 荷名詞（蓮） lotus
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. It revealed that hexagonal structure was easily synthesized in the neutral medium, and lamellar structure was inclined to prepare under basic condition, and from the cooperative charge density matching mechanism and function of manganese iron and template molecular, the alkalescence influence on the structure was explained, and appropriate neutral hexadecylamine ( hda ) availed to synthesis of mesophase with more ordered degree for the mediation of packing parameter

    通過水熱合成方法對錳氧有序相的合成進行初步研究，探討合成工藝對有序結構的影響：在中性的條件下，易合成六方有序結構產物；在堿性條件下，更易合成層狀結構產物。並從電荷匹配的原則及錳離子與模板劑間鍵合作用解釋了堿量的多少對合成產物結構的影響。
  2. Charge-separated resonance structures do not contribute very much to the resonance hybrid of butadiene.

    電荷分離的共振結構對丁二烯沒有很大的貢獻。
  3. In general, every structural characteristic that favors the delocalization of the electronic charge leads to an increase in stability.

    一般說來，每個有利於電荷去域性的特徵結構，都導致穩定性增加。
  4. Abstract : this paper, by analyzing the effect of differences of mineral structure of 2 1 layer minerals, the properties of their interlayer charge and changes of some properties caused by weathering on the attractive force for interlayer cation, reached the conclusion that : the fixation capacity is determined by the ratio of the total amount of interlayer charge and that of tetrahedral charges. the relationship of interlayer cation fixation and octahedral structure of secondary minerals is probably different from that of primary minerals. the oxidation and reduction of variable valence cations can greatly influence the cation fixation capacity

    文摘:分析2 1型礦物的結構差異、層間電荷性質以及在風化過程中某些性質的變化對層間陽離子吸引力的影響，對已有報道中一些矛盾的結果或不具普遍意義的結論進行了討論.得出幾個較為明確的結論：層間總電荷與四面體電荷所佔比例大小共同決定礦物對層間陽離子的固定能力；原生礦物中八面體結構與層間陽離子固定間的關系對次生礦物而言，也許並不一致；八面體中可變價陽離子的氧化還原，可導致礦物固定陽離子能力發生較大變化
  5. Based on modal analysis of piezoelectric smart laminated plates, an fem based inverse algorithm of the time history of impact loads by piezoelectric modal respondence is presented

    摘要基於對智能層合板結構的模態分析，提出由結構的壓電模態響應反演瞬態荷載時間歷程的有限元方法。
  6. Suction gas pressure goes up as the compressor run at the lower speed in the lower burthen, and this is beneficial to lower systems energy - consume. when the system is controlled by wvf, the discharge change of the evaporator is not linear ; the electronic expansion valve is adopted to regulate the system superheat degree, and the controlled object is parameter time varying, accordingly, the time varying controller should be adopted

    在負荷較小時，壓縮機採用低速運轉，吸氣壓力升高，這對系統降低能耗是有利的；變頻控制時，蒸發器製冷劑流量的變化並非線性；系統中採用電子膨脹閥進行過熱度控制，被控對象具有參數時變的特性，相應地宜採用變結構的控制器。
  7. The whole problem related to the time - variation of the load is completely solved by the proposed method, the core of which lies in the tva model structure

    整個過程中，模型結構的改進是其中的關鍵。大區電網負荷建模研究是從模型應用角度研究對不同物理地點的負荷進行建模的問題。
  8. The polymer antistatic additive forms a network throughout the polymer matrix, as a result there are conductive pathways through the polymer, over which a built - up charge could be grounded

    高分子抗靜電劑在基體樹脂中形成網路結構，樹脂中聚集的電荷通過形成的導電通路得以釋放。
  9. The main work of this thesis is to study of electronic structure of cathode material. some structure paramters, such as total energy, atomic net charge, atomic overlap population, of the model li5mn4o83 +, li5mn12o24 -, li7co6o2015 -, li7ni6o2015 -, li5mn2co2o83 +, li5mn2ni2o8 are calculated

    論文重點研究了正極材料電子結構，通過對尖晶石型錳系材料模型li5mn4o83 +和li5mn12o24 -和層狀結構的li7co6o2015 - 、 li7ni6o2015 -模型以及摻雜模型li5mn2co2o83 + 、 li5mn2ni2o8的計算，得到了各個原子簇體系的總能量、凈電荷分佈、原子重疊布居值。
  10. The effect factors of boiler steel frame are analyzed, loads composition and structural distribution, also the design code and special value norm for load classification are discussed, mainly including state and live loads, wind and level earthquake

    分析了電站鍋爐鋼結構的荷載影響因素，提出合理的結構布置和荷載取值及其工況組合。分析了設計標準中的荷載分類及取值約定。
  11. Considering special form of the boiler frame, the reconstruction and enforcement method, in addition dynamic analysis are given by particular steps : establishment of the model of boiler steel frame, determination of earthquake loads and distribution form, and anti - side force system for the frame to model and analyze, involving loads on the frame and above it, earthquake loads, damping, sway control installation, hanging bar and plate beam

    考慮鍋爐構架鋼結構的特殊形式，研究並提出了電站鍋爐鋼結構改造加固研究方法，及動力分析的具體步驟：建立了鍋爐鋼結構動力分析模型、地震荷載分析方法、建立了鍋爐鋼結構布置型式、及整個鍋爐鋼構架抗側力體系模擬分析方法。具體包括：鋼構架本體及構架上荷載、地震載荷與阻尼系數確定、制晃裝置確定、吊桿與大板梁簡化。
  12. The hybrid density functional theory at ab initio level was applied to study solvent effects on geometrical structures, charge distribution, and solvatochromic shifts of 4 - nitro - buta - 1, 3 - dienylamine molecule

    摘要在從頭計算的水平上，利用雜化密度泛函理論研究了溶劑對4 -硝基1 ， 3 -丁二烯基胺分子的幾何結構、分子內的電荷分佈和電荷轉移態的能量漂移的影響。
  13. In this paper, the effect of interface properties of sio2 / sic on performances of n - channel sic mofet are studied systematically : incomplete ionization of impurity in sic is analyzed based on the crystal structure of sic materials. the effect of incomplete ionization of impurity on c - v characteristics of p - type 6h - sic mos is researched based on charge - sheet model for sic mos inversion layers

    本文就sio _ 2 / sic界面質量對n溝sicmosfet性能的影響做了深入的研究：從碳化硅材料的晶體結構出發分析了碳化硅材料中雜質的不完全離化，採用sicmos反型層薄層電荷數值模型，研究了雜質不完全離化對p型6h - sicmosc - v特性的影響。
  14. In the first part of the paper, the explicit form of difference equation and periodic boundary condition is derived in cartesian coordinate system. secondly, the dispersive characteristic is analyzed in cylinder coordinate system for many high power microwave devices use cylinder sws. and then the method is extended to calculate the band structure of 2 - d photonic crystal, a modified yee ’ s grid is introduced to calculate the dispersive characteristic in the case of triangular lattice, so that both square lattice and triangular lattice cases can be solved in cartesian coordinate system

    周期電磁結構的一個重要應用就是用作高功率微波器件中的慢波系統，考慮到目前大部分高功率微波器件的慢波系統多採用圓柱周期結構，在論文第四章中，在圓柱坐標系下，給出了差分方程和周期性邊界條件的具體形式，同時編寫程序，分析了milosws ，盤荷慢波結構的色散特性。
  15. In the main factory building structure of large - scale thermal power plants, due to its great height and large vertical loads ( such as a furnished for arranging coal bucket between interstory, whose mass is too concentrating ), anti - seismic problem is much outstanding

    在大型火力發電廠主廠房結構中，由於其高度較大，且豎向荷載較大（如層間布置有煤斗等質量過于集中的設備） ，故抗震問題較為突出。
  16. During the high - voltage device design, the thick epitaxial layer ldmos which is compatible with current technology was researched. this device used piecewise vld and multiple region structure f reduce field layer. the using of the f reduce field layer effectively reduce the surface electric field of the device, shorten the length of its drift region, enlarge the choice of range of the ion implant dose of the p layer, and effectively restrain the disadvantageously affection on the breakdown voltage of the interface charge qss

    在高壓器件研究中對與現有工藝相兼容厚外延ldmos進行研究，該結構採用分段變摻雜多區p ~ -降場層，有效降低器件的表面電場，縮短器件的漂移區長度，增大p ~ -降場層注入劑量的選擇范圍，並有效地抑制界面電荷qss對器件耐壓的不利影響。
  17. A trend of photo - induced electron transition from p - type pc to n - type organic semiconductor was strongly supported by the data of sps and fisps measurements, the wire - like configuration of the tio2 tubule nanostructure benefited the electron - transport thereby improved the efficiency of the disassociation of the photogenerated carriers

    表面光電壓測試結果表明，復合材料中存在著強烈的從p -型酞菁材料到n -型氧化物半導體材料的光致電荷轉移。而且tio _ 2的納米管和線狀結構提高了電子的傳輸效率最為明顯，使光生電荷的分離得到顯著改善。
  18. Firstly, itis explained that the application research of smart layer. to laod detecting and simulative damage for the model of wing - box, fbg fiber smart layer and pzt smart layer are designed, and manufactured. so, those are surface - mounted respectively on the stiffened skin of aluminum alloy and carbon fiber reinforced. data acquisition system based on different signal processing technique are designed

    針對機翼盒段試件結構載荷識別和模擬損傷監測的功能要求，結合智能夾層的設計製作工藝，設計製作了基於fbg傳感器的光纖和壓電兩種智能夾層，並分別安裝在機翼盒段試件上的鋁合金和碳纖維制蒙皮上。
  19. The development of economy and electric power in the east china area is introduced, and the power demand, power consumption structure, and the load characteristics in the area are analyzed in detail, as well as the installed capacity and power supply structure of east china power grid

    摘要介紹了近年來華東地區經濟和電力發展的概況，以數據詳細分析了電力需求、用電結構、負荷特性等用電情況以及華東電網裝機規模和電源結構。
  20. In addition, the behaviors of the ptcl exciton in an applying electrostatic field were numerically explored. we came to the results that electric field has strong and interesting effects on the ptcl exciton. no dramatic polarization of the exciton is seen in weak electric field

    進一步研究激子對靜電場的響應，發現靜電場對ptcl激子的結構、電荷密度、電子能級均有明顯影響，即電場能夠降低ptcl激子的穩定性使其解離，並導致體系發生結構相變以及發光猝滅。
分享友人
分享到 Line

分享到臉書