經驗模型 的英文怎麼說

中文拼音 [jīngyànmóxíng]
經驗模型 英文
empiric model
  • 經 : 經動詞[紡織] （把紡好的紗或線梳整成經紗或經線） warp
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 經驗 : 1 （由實踐得來的知識或技能） experience 2 （經歷） go through; experience; 經驗教訓 lessons from ...
  • 模型 : 1 （仿製實物） model; pattern 2 （制砂型的工具） mould; pattern3 （模子） model set; mould patter...
  1. This empirical single-parameter model was selected for interim use because it is simple and unambiguous.

    這一單一參數經驗模型，由於其簡單明了而選作臨時應用。
  2. Mechanistic models are considerably more robust as predictive tools than are purely empirical models.

    機械模型作為預測工具，比純粹的經驗模型要完善得多。
  3. Non - linear side slip tire model in non - steady state

    考慮胎體復雜變形的輪胎非穩態轉向特性半經驗模型
  4. The impact of no - steady state tire side slip property on vihicle handling stability and simulation

    輪胎非穩態側偏特性半經驗模型
  5. Based on the data from forced oscillation tests of rigid cylindrical sections, many empirical tools were developed

    近年來出現的若干經驗模型基於圓柱體受迫振蕩實驗數據。
  6. Gully erosion, which is universal on original lands, but also the special forms, for example, hole erosion gravel erosion debris slide and debris flow, which is unusual in loess area, ( 2 ) based on a long - term fixed point experiments in proving ground of the south stackpile, the soil erosion factors have been researched quantitatively, the runoff and erosion affected factors have been made sure and the experiential models of producing water and soil have been taken in newly - constructed stage, early stage and later stage of reclamation

    確定南排土場原地貌的水蝕模數為3700 4400t km ~ 2 ? a ；在排土場新造地貌上，擊濺、面蝕、細溝侵蝕、淺溝侵蝕、沉陷侵蝕、砂礫化面蝕、土砂瀉溜和坡面泥石流等水土流失形式出現頻率和發生程度都明顯強于原地貌。 （ 2 ）以南排土場徑流試驗場長期的定位觀測為基礎，對排土場未復墾時期、復墾初期、復墾後期的土壤水蝕影響因子進行定量研究，確定了徑流和土壤水蝕的主要影響因子及其臨界值，建立了產流產沙的經驗模型。
  7. The application of empirical mode decomposition on handwritten numerals recognition

    經驗模型分解在手寫體數字識別中的應用
  8. The recent researches on observations of h line profile asymmetry in chromospheric flare are reviewed. spectral properties, the corresponding mechanisms of asymmetry, and reproduction of observational spectrum by using semi - empirical atmosphere model are dicussed in detail. at last, the main problems to be solved and further researches are put forward

    綜述了近年來太陽色球耀斑爆發時h譜線不對稱性的研究進展，著重討論了光譜特徵和與其對應的不對稱性產生機制，以及利用大氣半經驗模型再生觀測譜線輪廓不對稱性等方面，並提出尚待解決的主要問題和進一步的研究方向。
  9. With the thermodynamic theories and techniques, it is relatively easy to determine the phase equilibrium data with enough accuracy, however there still exist much more difficulties in crystallization kinetics study even for a simple binary system. that is the reason that nucleation and crystal growth rate are generally represented in form of the empirical expressions. the crystallization kinetic is important for crystallizer design, process control and optimization, and it is strongly depended upon the accurate characterization of process information concerning with multiphase flows and the further disclose of its mechanisms with suitable mathematical models

    熱力學理論和方法已足以獲得準確的相平衡關系；然而即使對于簡單的二元物系的結晶過程，晶核形成和晶體生長動力學的研究仍面臨許多困難，通常採用經驗模型表述，而動力學參數的準確性和可靠性是結晶器放大設計、過程式控制制與優化的關鍵，因此多相流信息的準確表徵、結晶機理的進一步揭示及建立起與之相適應的數學模型有著十分重要的學術研究和實際應用價值。
  10. A semi - empirical tire model of transient cornering properties with carcass elasticity considered

    考慮胎體彈性的輪胎動態轉向特性半經驗模型
  11. Accessing the data, the knowledge, the model and the relative parameter from database, knowledge - base, model - base and the interface, the expert system automatically infers and calculates the maximum depth and length of stilling basin the bantai hydraulic project and the xiangyanghe dam have been given as the example

    以班臺閘和向陽河壩為工程實例，根據數據庫、知識庫、模型庫中的相關數據、知識經驗、模型，以及人機交互界面的相關參數，進行分析推理計算，求出最大消力池深和池長，對系統的相關功能模塊進行的驗證。
  12. Abstract : the paper firstly introduces three different approaches for the kinetic modeling of supercritical fluid extraction ( sfe ) ( empirical models, models based on the heat transfer analogy, and models based on differential mass balance ), and then models kinetic process of the sfe of flavonoid compounds from cedrela sinensis leaves in the presence of ultrasonic, at last shows the defects existed in most of the contemporary kinetic models through the example

    文摘:首先介紹了三種動力學模擬超臨界流體萃取的模型（經驗模型、基於熱傳遞類推的模型以及基於微分質量平衡的模型） ，然後模擬了在超聲存在的條件下超臨界流體從香椿葉中萃取黃酮類化合物的動力學過程，最後通過該例子展示了現有大多數動力學模型的缺點
  13. The paper firstly introduces three different approaches for the kinetic modeling of supercritical fluid extraction ( sfe ) ( empirical models, models based on the heat transfer analogy, and models based on differential mass balance ), and then models kinetic process of the sfe of flavonoid compounds from cedrela sinensis leaves in the presence of ultrasonic, at last shows the defects existed in most of the contemporary kinetic models through the example

    摘要首先介紹了三種動力學模擬超臨界流體萃取的模型（經驗模型、基於熱傳遞類推的模型以及基於微分質量平衡的模型） ，然後模擬了在超聲存在的條件下超臨界流體從香椿葉中萃取黃酮類化合物的動力學過程，最後通過該例子展示了現有大多數動力學模型的缺點。
  14. Firstly the necessity of water erosion modeling on hillslopes is discussed. then existing water erosion models are generally divided into two types, formalization logic computational models and dialectical logic computational models according to the way of solving problems where the former can be further divided into four types - primarily empirically based, partially conceptually and partially empirically based, partially process based and partially empirically based, as well as theoretically based as weak points of the previous classification methods are concerned. finally characteristics of each type and their relationships are illust rated by examples

    考慮到原有水蝕模型類型的不足，對當前水蝕模型按解題方法重新歸為形式邏輯計算模型及辯證邏輯計算模型兩類。其中，形式邏輯計算模型又分為經驗模型半概念半經驗模型半過程半經驗模型以及理論模型4類。結合實例闡述這幾類模型的主要特性及相關關系。
  15. Abstract : according to characters of different research ways, the research development of thermodynamic models of metallic melts is systematically introduced, such as solution model method, geometrical model method, interaction coefficient method, analytical method and experienced model method

    文摘:根據不同研究方法的特點，綜述了溶液模型法、幾何模型法、相互作用系數法、解析計演算法以及經驗模型法等金屬熔體熱力學模型的研究進展，並對這些方法進行了簡要的評述。
  16. The river mouth delta process is affected by river dynamics and coastal dynamics. the process of river delta is estimated by empirical model, analytical model and minimum stream power method. the three models are verified with field data of the yellow river mouth. the computed results are compared with field data. the demerits of the three models are pointed out

    採用經驗模型、分析模型和最小功率方法研究河口三角洲演變過程.根據黃河河口三角洲資料，利用三個模型計算了河口三角洲岸線或沙咀寬度及岸線的平均延伸情況及對河口近口段河道水位的影響，比較分析了各模型的計算結果，指出了模型不足之處
  17. On the basis of the steady - state semi - empirical model of the tire and the concepts of the relaxation length and the effective slip ratio, a non - steady semi - empirical model to express the tire longitudinal - slip response to the low - frequency input of the transient vertical load and transient slip ratio was presented

    摘要在穩態半經驗模型的基礎上，根據鬆弛長度和有效滑移率的概念建立了能表達時變垂直載荷及時變滑移率低頻輸入下的輪胎縱滑特性非穩態半經驗模型。
  18. In chapter 2, based on the status analysis on the research of milling force, its characteristic is studied for the aero - material of aluminum alloy 7075 - t7351, and the empirical model is established by using the regression - orthogonal experimental method where the factor number is five and the standard number is four

    第二章在總結國內外銑削力研究現狀的基礎上，採用多因素正交試驗研究了航空鋁合金7075 - t7351的銑削力學特性，建立了該材料的銑削力經驗模型，為研究切削力對加工變形的影響提供了依據。
  19. Imitating strength increasing model presented before, an experiential strength decreasing model is brought forward

    摘要提出評價結構強度衰減過程的經驗模型強度衰減模型。
  20. The paper points out that different material must be imitated through different methods. in the paper, the standard material is imitated by using illumination model, and the non - standard material is imitated by using texture and illumination model. last, using the realistic image synthesis technique, material function and the rendering technique, i realize the scene modeling, projection transformation, visible - surface detection, illumination model and surface rendering in this paper

    其次，根據材質屬性的不同將材質分為標準材質和非標準材質，並且根據材質的不同屬性而採用不同的方法進行模擬，對標準材質，如銅、鐵通過光照明模型技術來模擬；對木材等非標準材質通過紋理映射技術來逼真的模擬，並分析總結出模擬各種材質的經驗模型，即一個初步的紋理生成函數，在此基礎上對函數進行了數學演變，最終建立一個比較完善的紋理生成函數，並且對函數中的主要影響因素進行了分析。
分享友人
分享到 Line

分享到臉書