線圈測試器 的英文怎麼說

中文拼音 [xiànjuāncèshìqì]
線圈測試器 英文
coil comparator
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 圈 : 圈名詞1. （養豬羊等牲畜的建築） pen; fold; sty 2. （姓氏） a surname
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 線圈 : [電學] coil
  • 測試 : test; testing; checkout; measurement
  1. Guide for a test procedure for the measurement of loss tangent of coils and bars for machine windings

    機器繞組線圈和棒的切向損耗測量用試驗方法指南
  2. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  3. Under windows nt and labview development environment, using the linear fit module, exponential fit module > general polynomial fit module of labview to design a method for fitting the experiment data, the results of curve fitting indicate that the purpose of general polynomial fitting is better than the rest. separating the equivalent input impedance of magnetostrictive transducers without stimulate current from input impedance of it with stimulate loop based on the results of curve fitting, and determining the syntony frequency and electric simulation network parameters of magnetostrictive transducers by this input impedance. finally, with labview network functions, realizing magnetostrictive transducer electric simulation system based on web server and discussing a scheme for this system network by datasocket. the method of this paper can more accurately determine the syntony frequency and electric simulation network parameters of magnetostrictive transducers than the testing method of syntony & anti - syntony. at the same time, discussing virtual instrument measurement system and how to realize magnetostrictive transducer electric simulation network system by labview network functions of network virtual instrument measurement development environment

    在windowsnt系統環境和labview虛擬儀器技術開發平臺下，首次利用labview中的直線擬合模塊、指數擬合模塊以及多項式擬合模塊，設計了一種對實驗所得數據進行曲線擬合的方法，對三種擬合方法進行了比較，曲線擬合結果表明，多項式擬合方法相對于其它兩種擬合方法效果更好；根據曲線擬合的結果可從帶激勵線圈的磁致伸縮換能器的輸入阻抗中分離出磁致伸縮換能器鐵芯在無激勵電流時機械振動形成的等效輸入阻抗，並由此輸入阻抗確定了磁致伸縮換能器的諧振頻率及其電氣模擬網路參數；最後通過labview提供的網路功能，實現了基於web服務器的磁致伸縮換能器電氣模擬虛擬儀器測試系統，並探討了通過datasocket技術實現該系統網路化的方案。
  4. Bearings roller bearings and other components. bearing ring precision rolling production line ; a high - precision, super efficient grinding automatic production line ; bearing assembly line ; signal processing equipment ; blank processing equipment ; crowning roller grinder ; end - grinder ; coordinate precision grinder ;, cylindrical grinder ; surface grinder ; spherical roller processing equipment ; raceway grinder ; heat treatment ; needle processing equipment ; polishing processing equipment ; roller - seiki ; rolling auto - sorting machine parts bearing hardness sorting machine bearing cleaning equipment ; contact angle measuring instrument ; contour meter ; bearing life experimental device ; bearing packaging equipment ; roundness instrument ; dynamic vibration noise analyzer ; noise vibration test equipment ; printing machine measuring instrument ; roughness tester ; scanning electron microscope ; finish detector ; inverter ; spindle, wheel, whetstone and other grinding materials

    軸承套圈精密輾擴生產線高精高效磨超自動生產線軸承自動裝配線球加工設備毛坯加工設備凸度滾子磨床雙端面磨床高精度坐標磨床內外圓磨床平面磨床球面滾子加工設備溝道磨床熱處理生產滾針加工設備光飾加工設備滾道超精機滾動體自動分選機軸承零件硬度選別機軸承清洗設備角接觸測量儀輪廓測量儀軸承壽命實驗裝置軸承包裝設備圓度儀振動噪音動態分析儀振動噪音測試裝置印字機加工測量儀粗糙度測試儀掃描電子顯微鏡光潔度檢測儀變頻器電主軸砂輪油石和其他研磨材料
  5. Dc testing, applying to transformer and inductor winding copper resistance 、 relay contact resistance 、 switch and socket contact resistance 、 lead resistance 、 compenent solder resistance 、 pcb line and hole resistance 、 metal detection, ect

    直流測試，適用於變壓器及電感線圈銅阻、繼電器接觸電阻、開關、接插件接觸電阻、導線電阻、元件焊點接觸電阻印製板線條及焊孔電阻、金屬探傷等。
  6. Coil insulator tester

    線圈絕緣測試器
  7. In the eddy - current testing, testing coil is the sensitive component connecting the specimen and the instrument, so it is called transducer. the information of the test specimen is reflected by the variation of the coil impedance ( or induced voltage )

    在渦流檢測中，檢測線圈是用來連接測試儀器和被測試件的敏感元件，它是渦流檢測中的傳感器，被檢試件的信息是通過線圈阻抗（或感應電壓）的變化反映出來的。
  8. In the primary experimental study, the microwave power, the microwave frequency, and the mode are measured, hie relations among the microwave radiation, the intensity of the magnetic field, the position of the magnetic coil, the amplitude of the beam current, and the a - k gap are investigated

    在初步的微波實驗中，測試了微波的功率、頻率和模式，測試了磁場強度和線圈位置對微波輻射輸出的影響，測試了束流大小和陰陽極間距對微波輻射輸出的影響。實驗結果發現微波的功率和模式基本與模擬結果吻合，器件工作穩定，重復性良好。
  9. Acquisition and examination of image data from a phantom ( inert test sample ) to investigate image intensity non - uniformity, spatial and temporal noise from instrumental sources, and rf receive coil properties

    用假體（無生命的測試樣品）來取得影像並檢視資料，以探討諸如影像信號不均勻、儀器產生的空間與時間雜訊，以及射頻接收線圈特性等現象。
  10. Initially, the company has engaged in the development and manufacture of testing instruments primarily for the said governmental institutes, later expanding its activities toward the field of electrical industries in general. taking advantage of technological prestige, the company has in the meantime developed unique instruments one after another which have successfully met the demand of major electrical machine manufacturers for rationalization and increase of production efficiency, thus enabling the company to realize steady growth and maintain continual business relations with more than 400 domestic and overseas customers

    本測試儀可用作繞組線圈電阻及溫升測試外，也可用作為普通的數字型電阻儀測試未加交流電壓狀態時的電阻值。本儀器在電機或變壓器等繞組設備的機械加壓的工作狀態下，可隨時連續檢測其線圈電阻和溫度的變化，而且在切斷電源后，亦可連續測量，測量安全數據準確。
  11. Ganfa has over 50 years experience of designing and manufacturing and has many items of patent techninque. the synchronous generators and permanent magnet generators which are manufactured with advanced technology and excellent machining equipement, will be able to meet the requirement of different technical condition which matched with various type turbines. ganfa has manufactured the generators of 0. 1 to 20mw in capacity which have been put into operation at present and owns the capability to manufacture the following generators : the capacity per unit up to 180mw, the stator outer diameter of generator up to 9, 000mm, the speed of vertical type generator up to 750r min, and thespeed of horizontal type generator up to 1, 500r min, both the b - grade and f - grade insulation class, the terminal voltage can up to 13. 8kv. ganfa manufactured 34, 500kw water turbine generator sets for the donghewan power station, yongchang, gansu, china which is located in 2. 868. 5m height above sea level, and has successfully solved the difficult problems such as plateau corona - shielding. ganfa is equipped with the generator test station and insulation material laboratory which are advanced test facilites and testing means to make each item electrical performance of products meet designing requirements from purchasing to delivering

    公司具有50年的設計製造經驗，擁有多項專利技術，生產的同步發電機永磁機技術工藝先進，製造精良，能滿足與各式水輪機配套的不同技術條件要求。目前公司已製造投產的發電機容量范圍為0 . 120mw ，具備生產單擊容量50mw的能力，發電機機座號最大可達9000mm ，立式機最高轉速750r min ，臥式機最高轉速達1500r min ，絕緣等級有b級和f級，圈式線圈最高電壓達13 . 8kv ，公司製造的甘肅永昌東河水電站34500kw水輪發電機組，海拔為2868 . 5m ，成功解決了高原防暈等難題。公司擁有電機試驗站絕緣材料試驗室等先進的實驗室設施和測試手段，使產品從原材料進產，到成品出產的各項電器性能測試均能滿足設計要求。
  12. Elements of electrical and optical connection - test methods - electrical elements - measurement of turns ratio on a transformer used in a coupler

    電氣和光學連接元件.試驗方法.電氣元件.耦合器用的變壓器的線圈系數的測量
  13. The fast development of power system has made it more and more imperative to measure transient parameters, such as over voltage test, trial engagement test of switches, reactors and transformers, harmonics elimination test of arc elimination coils and trial operation of high voltage transmission lines

    隨著電力系統的飛速發展，對于暫態參數的測量需求越來越迫切，例如：過電壓試驗；開關、電抗器、變壓器投切試驗、消弧線圈消諧試驗、高壓線路的試投等。
  14. Testing methods for low frequency transformers and inductors

    低頻變壓器和電感線圈的測試方法
分享友人
分享到 Line

分享到臉書