線束孔 的英文怎麼說

中文拼音 [xiànshùkǒng]
線束孔 英文
harness inlet
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 束 : Ⅰ動詞1 （捆; 系） bind; tie 2 （控制; 約束）control; restrain Ⅱ量詞（用於捆在一起的東西） bundle;...
  1. The aperture allows the desired beam to enter the camera while all other light is intercepted.

    孔可以使所需要的光束進入照相機，而將其餘的光線遮擋住。
  2. To select a cylindrical plane cathode ; to design proper focus electrodes in order to control the formation of beam in methods of solving equations, electrobath and simulation aided by computer. to correct effects of anode hole and work out curves of designing guns ; to discuss plasma cathode guns at last

    選用圓形平面陰極;設計恰當的聚束極形狀以控制電子束的成形，並使用解析法、電解槽法和數值方法三種方法進行設計;考慮陽孔效應對電子束傳輸的影響，修正陽孔效應，給出電子槍設計曲線;最後討論一下等離子體陰極電子槍。
  3. Phase array radar can scan beams fast by controlling the phase of radiator elements in the antenna aperture surface, which shows many excellences such as agility, change celerity and multifunction. therefore, phase array radar is fit for the necessity of combat readiness

    這種雷達通過電的方式控制天線孔徑面上各輻射單元的相位變化，以實現波束的快速掃描，使其具有靈活、變化快速、多功能等優點，適應戰備需要。
  4. The parameters that influence the single photon acquisition probability are the transmitter ' s tracking - pointing error, the far - field divergence angle, the link distance between transmitter and receiver and the receiver ' s antenna aperture

    得到影響單光子捕獲概率的主要參量是發射機的跟瞄誤差、光束遠場發散角、發射機和接收機的鏈路距離和接收機天線孔徑。
  5. The position and size of the monochromator, focusing curvature radii and tilting angles of the germanium focusing monochromator under different different take - off angle, size and divergency of the second collimator and intensity loss due to the use of it were determined. the neutron flux at different wavelength, under different reflection and take - off angle of the monochromator and divergency of the first collimator, were given. the simulation on the aperture used for limiting beam size in front of the sample showed that, smaller the size of the aperture and further the distance from the aperture to the sample, greater the loss of the intensity and more serious the spread of the beam along vertical direction at the sample position which makes the practical sampling volume greater than expected

    用蒙特卡羅模擬方法對中子應力衍射譜儀的設計方案進行了優化研究，提出了一系列可供參考的數據：確定了單色器的位置、尺寸、垂直聚焦單色器在不同起飛角下的聚焦曲率半徑和傾角；討論了第二準直器的尺寸和發散，以及使用第二準直器造成的強度損失；給出了在不同單色器反射面、起飛角、中子波長和第一準直器發散度的情況下樣品處的中子注量率，以及多種組合情況下譜儀的解析度曲線；對限束方孔的尺寸、距離樣品遠近對強度損失和測量中的影響做了深入研究。
  6. The theory hypothesis of " pore restriction " is first proposed in this paper. during polymerization, one end of linear molecule inserts the channels of zeolite to form hard end through chemical bond or supermolecule acting force, the other end forms soft end through condensing or polymerizing with other monomer molecule. on the basis of the theory hypothesis, a kind of novel pattern of organic - inorganic composite materials - pu / zeolite composite materials - has been designed

    本文首次提出了「孔約束」的理論假說，即在高分子材料聚合過程中，線型分子的一端通過化學鍵或超分子作用力插入分子篩的孔道中形成硬端，而另一端則與其它單體分子縮合或聚合形成高分子材料的軟端；在此假說的基礎上，設計了一類孔約束型有機?無機復合高分子材料的新模式，即聚氨酯/沸石分子篩復合材料。
  7. Strong rectangular frame fixed by screws, an inset hole every 25cm to fix the slotting auger, guard board, bunches of cables and circuit diagram sidekicks, etc

    堅固的用螺絲固定的長方框，每隔25毫米有一個嵌孔，用來固定槽溝、護板、電纜束及線路圖插袋等。
  8. In airborne synthetic aperture radar ( sar ), antenna stabilization platform is used to isolate antenna pointing, which is stabilized through controlling the platform axis ' rotation, from the vehicle ' s varying attitude and dynamical vibration

    摘要機載合成孔徑雷達中，天線穩定平臺用於隔離載機的姿態變化和機械振動對天線指向的影響，並通過伺服系統控制平臺支承軸的轉動穩定波束指向。
  9. The paper mainly focused on the beam transport part of asipp key laboratory of ion beam bioengineering and it ' s component elements, for example, van de graff accelerator, bending magnet, magnetic quadruple lenses, beam shutter, collimator and so on. the laboratory has performed the milestone achievement that is beam passed the hole of lo ^ m diameter in experiments. many experimental results are discussed by theories according to experiments

    本文重點討論了中科院離子束生物工程學重點實驗室單粒子束裝置的束流傳輸部分，對主要部件進行了詳細的討論，如：靜電加速器、偏轉磁鐵、磁四極透鏡、束線開關、瞄準器等，實驗中已取得束流穿過10 m小孔的標志性成果，並運用相關理論結合具體實驗分析了實驗結果。
  10. Round, smooth nuclear surface, and uniform nuclear pore changed into bumping surface and expanding nuclear pore, then the nuclei broken and disappeared ; 2 ) the degenerate and disappear of cell organelle and senescence of the flag leaf were obviously faster during the ripe of grain ; 3 ) the degenerate and senescence of chloroplast was faster than that of mitochondria ; 4 ) the nuclear of leaf cells broken and disappeared faster than that of the leaf bumdles

    即核呈球形，表面光滑，核孔勻稱核表面凸凹，部分核孔變大核膜破裂，核解體，消失； （ 2 ）在籽粒成熟期小麥旗葉衰老及其細胞器退化消失明顯加快； （ 3 ）細胞中葉綠體的退化、消失比線粒體稍快； （ 4 ）葉肉細胞的細胞核比維管束韌皮組織細胞核解體消失稍快。
  11. The performance of the pbg antenna using the new pbg cover together with a pbg substrate is studied by the fdtd method together with the pml boundary treatment. the numerical results show that a more focused beam radiated in the broadside direction is achieved. the gain of the pbg patch antenna in the forward direction is improved by about 6 db. the radiation directivity is improved significantly and reaches 11. 5 db, which is 0. 4 db less than the maximum value that is allowed physically for this size of the antenna ( this difference is about 4. 1 db less than the difference achieved by thevenot et al.,

    用fdtd方法並結合pml吸收邊界條件，我們對加了這種新的覆層結構並且基底鉆孔的復合結構電磁（光子）晶體貼片天線的性能進行了研究，結果證明加了這種新的電磁晶體覆層結構以後，天線的波束收攏很多，並且向前輻射的增益大大提高，與普通天線相比，天線的e面和h面方向圖上向前輻射的增益均提高了約6db ，另外，該復合結構天線的方向性系數達到了11 . 5浙江大學博士學位論文db ，與該物理尺寸天線的方向性系數的理論極限值（ 11 . 9db ）相差0 . 4db ，該差值比thevenot等人設計的電磁晶體覆層天線的相應差值減少了約4 . 1db ，比qiu等人設計的電磁晶體天線的相應差值減少了約1
  12. Research on the linearity requirement of lfm in sar

    合成孔徑雷達線性調頻信號的線性度約束研究
  13. A collinear acoustooptic - deflector of pronton - exchanged linbo3 channel wave - guide is studied. the theoretical analysis, structure design and device fabrication of linbo3 pronton - exchanged acoustooptic wave - guided deflector have been finished in this thesis. the width of wave - guide, the width, spacing, effective aperture and width of electrode of interdigital transduces have been theoretically analyzed and designed

    本論文研究了一種質子交換linbo3溝道波導共線式聲光偏轉器，其特點是利用了溝道波導的橫向約束，限制了聲波的發散和衍射效應，使得窄孔徑電極結構得以實現，從而增加了功率密度，使總的聲場驅動功率降低。
  14. Starting with single well reservoir classification and correlation, the deposition model is firstly developed, and then detailed reservoir calibration, multiwell constraint seismic inversion and porosity constraint inversion are conducted, based on the well logs correction and the wavelet analysis

    首先從單井儲集層劃分對比入手，建立儲集層沉積模式，在測井曲線校正和子波分析的基礎上，進行儲集層精細標定、多井約束地震反演和孔隙度約束反演。
  15. Comparing frozen material with freeze - dried apple, the ice area with low grey value in the beginning became the loosen pore area with high grey value after freeze - drying

    對比凍結物料和凍干物料的灰度值曲線，可見剛開始灰度值較低的冰區，在凍干結束后變成灰度值相對較高的孔疏區。
  16. Synthesis of shaped beam antennas for airborne sar based on genetic algorithm and particle swarm optimization

    基於遺傳演算法與粒子群優化法的機載合成孔徑雷達天線賦形波束綜合
  17. Besides the theoretical analysis, we also numerically studied the relation between the beam irregularity and b integral for a special four - pass amplifying system. based on these calculations, a " red line " has been set up for the safety of the system. in addition, the variation of beam irregularity with the size of filter ' s hole has been studied

    在理論分析的基礎上，我們用數值模擬的方法研究了一個具體的四程放大系統中光束非均勻性和b積分的關系，以此確定出了系統運行的「紅線」 （安四川大之戶下員d匕論文全運行警戒線） ;同時探討了濾波小孔尺寸與光束質量的關系。
  18. Adopting the sectionalized lumped parameter method with dynamic friction, the dynamic performances of the typical segments in lineweb, i. e. short channels, rectangular elbows, forked channel, chamber of additional holes, are analyzed using the effective approach - power bond graph ( pbg ). thus the pbg model of lineweb with the sectionalized lumped parameter method i : ; iii established. this model is proven by digital simulation and physical experiment

    作為校驗線網性能約束的后續環節，本文引入包含動態摩擦的管路分段集中參數鍵合圖模型，對集成塊線網中存在的短管、直角拐彎、分支管路、工藝孔容腔等典型結構進行分析，建立起具有典型結構的線網的分段集中參數鍵合圖模型，並通過數字模擬和物理實驗得到驗大連理工大學博士學位論文證。
  19. Install distributor head and distributor lid, and plug casing line into distributor pore in a corresponded way. at same time connect assembly bundle to cars general wiring bundle

    安裝分火頭分電器蓋，並將缸線對應的插入分電器孔中，同時將總成線束接入整車線束中。
  20. A system of real time image acquisition is developed. a method based radial alignment constraint is brought forward, and it is using linear method to calibrate the camera. at the base of studying image preprocessing, edge detection, image thining, image recognition, etc, the system of image process and recognition is developed and is used to calculating the position and pose

    本論文建立了圖像實時採集系統，提出了基於徑向排列約束的攝像機線性標定方法，並在針孔模型的基礎上標定了攝像機；在研究圖像預處理、邊緣檢測、圖像細化、圖像識別等演算法的基礎上，建立了圖像處理識別系統，並計算物體的位姿。
分享友人
分享到 Line

分享到臉書