線響應函數 的英文怎麼說

中文拼音 [xiànxiǎngyīnghánshǔ]
線響應函數 英文
line response function
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • : 應動詞1 (回答) answer; respond to; echo 2 (滿足要求) comply with; grant 3 (順應; 適應) suit...
  • : 名詞1. [書面語] (匣; 封套) case; envelope 2. (信件) letter 3. (姓氏) a surname
  • : 數副詞(屢次) frequently; repeatedly
  • 函數 : [數學] function函數計算機 function computer; 函數計算器 function calculator; 函數運算 functional operation
  1. Diagrammatic method of transfer function idenlified by step - up response curves

    由階躍辨識傳遞的圖解方法
  2. In the process of solving, poles are obtained from recurrent formula, modal vector are obtained from superposition formula not residuary. decoupled equation is derived when vibration source is part correlation, severely coupling appears in the process of input and output then frequency response function cannot directly get according to method mentioned above, decoupling is first problem

    當輸入完全相關時,頻無解,可繞過頻,直接運用性系統的迭加原理來求,極點由遞歸公式得出,模態矢量由疊加公式求出,而不是由留求得的相的公式。
  3. This paper focuses on the research of the stress mechanism of the ribbed shell structure in statics, dynamics and under the explosive load on the basis of the engineering practice of cave depot of single aircraft. in this paper, according to the classical shell theories, the basic differential equilibrium of the ribbed shell structure and the finite element analysis of 3d rippled plate are established, in which the function of annular ribs reinforcement bars and 3d ripped steel plates are distributed in the range of the steel, and the functions along the longitude direction of tension, bending, and torsion are neglected ; applied with dynamic analytical theory, the dynamic model of ribbed shell structure and the analytical theory model of elastic - plastic are set up ; the triangle series method is used to solve the displacement and stress under the distributed load and the concentrated load of the ribbed shell structure

    本文以軍用機場地面單機掩蔽庫工程建設為工程背景,首次對內襯三維波紋鋼板混凝土拱型復合結構的受力機理進行了靜力、動力和爆炸荷載的分析研究。根據將橫肋、鋼筋及三維波紋鋼板的作用均勻分佈在殼體范圍內的情況,忽略橫肋、鋼筋及三維波紋鋼板沿殼體母方向的抗拉、抗彎及其抗扭作用,首次推導出了內襯三維波紋鋼板混凝土殼體的微分平衡方程,建立了有限元計算模型,並採用三角法,求解了三維波紋鋼板混凝土拱型復合結構在分佈荷載和集中荷載作用下的位移,並與普通殼體進行了比較。
  4. Aiming at the study actuality of fan performance monitoring system and analysis of fan performance curve changes affected by inlet - box and the different fixed - angles of guide blades in the course of installation, a fan flow monitoring model based on rbfnn in whole flow zone was established in this thesis. in the model, the method of no throttle and fan performance curve were used as basis. and on the basis of that model, fan performance curves of 4 - 73no. 8d were approached with experimental data of different speed, different opening - angles of guide blade and different resistance of pipeline, the precision and the error law of model were studied

    本文針對電站風機性能監測系統研究較少的現狀,在實驗的基礎上分析了現場加裝進氣箱和由於安裝造成的導流器葉片開度不一致對風機性能曲的影,並在此基礎上採用無節流方法測量流量,以風機調節性能曲為依據,建立了基於徑向基( rbf )神經網路的風機流量全程監測模型;以實驗室4 - 73no . 8d離心風機為研究對象,探討了rbf神經網路差壓模型在變轉速、變導流器開度和變管網阻力等工況下的用精度和誤差分佈規律;最後用visualc + +語言開發了風機性能在監測系統。
  5. In this paper the response surface method ( rsm ) is introduced into the structure optimization of linear fire work departing installation, which make the target fuction explicit, adopt the big finite element procedure to numerically simulate the departing process of the fire work departing installation instead of the expensive substance experiment, establish reasonable optimization model and resolve it, the final result is satisfied, and analyse the question presented during optimization process in detail

    本文把面方法引入到性火工分離裝置的結構優化中,使得優化模型中的目標顯式化,採用大型有限元軟體對性火工分離裝置的分離解鎖過程進行值模擬,代替了代價昂貴的實際試驗,建立了科學合理的優化模型並求解,最終得到令人滿意的優化結果,並對優化過程中出現的問題進行了細致的分析。
  6. In the last, the modern control theory and simulink in matlab have been integrated together, and it has been applied in active control of the platform structure elastically supported ; a mechanical model and an equation of motion in state space have been established. based on coc, dynamic response of the platform structure elastically supported has been studied under simple harmonic load ; the influence of different values of weight function to the active control efficiency of the structure has also been discussed

    本文還將現代控制理論與matlab的simulink動態模擬軟體包相結合,將其用於彈性支承平臺結構的主動控制中;建立了彈性支承平臺結構主動控制理論的力學模型和狀態空間內的運動方程;用經典性最優控制演算法對彈性支承平臺結構在簡諧荷載作用下的動力進行閉環控制;分別從理論和值計算兩個方面討論了狀態權矩陣q和控制權矩陣r的不同取值對控制效果的影
  7. The artificial neural network is used to tackle an ill - posed problem of the parameter identification and to approximate nonlinear function relationship between the vibration responses of the hydraulic generator and model parameters

    利用人工神經網路具有解決參識別反問題不適定性的能力,建立了水輪機系統與模型參之間近似的非關系。
  8. A method of fuzzy optimization design based on genetic algorithm is presented as a new method of parameter optimization design for dc double closed loop speed adjusting system. the method covers three steps. firstly, speed overshoot rate and settling time are chosen as performance indice according to the demand of engineering. these indice are normalized by using fuzzy membership function and then weighted to form objective function of optimization model of the system. secondly, the dynamic response curve of the system with corresponding parameters and peoformance indice are obtained by computerized numerical calculation and simulation. finally, parameters of engineering design are expanded as searching space ; and parameters of speed regulator and current regulator are taken as genes in chromosome. these genes in searching space are optimized to get best solution by way of genetic algorithm. as shown by experimental results, the parameters designed by this method are capable of significantly improving performance indice of the system, which proves that it is a practical and effective method

    提出一種基於遺傳演算法的直流雙閉環調速系統參優化設計方法.根據工程技術的要求,選用速度超調量和過渡時間作為參優化性能指標.將該指標用模糊隸屬度歸一化,再加權平均形成系統優化模型的目標.採用計算機值計算方法,通過模擬獲得系統對的動態及其性能指標.最後以工程設計的參為搜索范圍,以速度調節器和電流調節器的參為染色體中的基因,通過遺傳演算法在搜索范圍中優化這些基因,獲得優化解.實驗結果表明,所設計的參能使系統性能指標有顯著提高
  9. It is demonstrated that the vertical response function of nuclear logs is inconsistent with the inherent vertical response function of the instrument

    結果證實核測井曲的縱向與儀器的固有縱向不一致。
  10. The integrated response function of nuclear logs depends not only on the response function of the instrument, but also on the logging velocity, sampling rate and recording instruments

    核測井曲的綜合不僅取決于儀器的,而且受測量速度、采樣率,地面儀器記錄方式等因素的影
  11. In fifth century kubo derived his theoretical linear formula for calculating non - local response function

    Kubo早在50年代就導出了計算非局域性理論公式。
  12. The author insists that the proposition on bmp contains numberous precondictions, the reference values of the qulitative papers are limited as they cannot answere exactly what on earth the bmp is. so this dissertation systematically studied the bmp of china according to the clue of monetary supply which is the immediate target of monetary policy. of course, the stress is to attempt to apply the newest econometric approaches, such as impulse response function and cointegration test, to develop the topic on bmp to a new regime and draw some valuable conclusions

    因此,本文在國內外學者已有的研究基礎上,以我國貨幣政策的中介目標? ?貨幣供量為索,就有關我國貨幣政策的宏觀調控效果進行了系統的理論與實證研究,重點是用國外時間序列經濟計量學的最新研究成果,如脈沖、預測方差分解模型等進行探索性地定量分析,並得出有價值的實證結論。
  13. The 2 - point self - energy and 3 - point vertex correction in < j ) 3 theory are calculated in this rule, and the fluctuation - dissipation theorem for 3 - point nonlinear response function is verified

    運用這套新法則,我們分別計算了兩點自能和三點頂角修正,並驗證了三點非的漲落-耗散定理。
  14. This paper presents the means of obtaining the parameter of signal converter and formulas for achieving the value of every parameter through math illation. the design means for band - pass filter involved in this subject is discussed and particularly, the steps and formulas for designing butterworth band - pass filter are expounded and the transfer - function of band - pass filter used in this subject are also given

    通過神經網路的曲面擬合,很好地解決了本課題中所涉及的多個相互耦合的被測參的解耦問題和標度變換問題,同常規s型非bp神經網路據擬合相比,減小了計算量,節省了檢測系統在檢測過程中的計算時間,擬合結果表明。
  15. Fluorescence power transfer function, three - dimensional point spread function ( 3d - psf ) and three - dimensional optical transfer function ( sd - otf ) for the various fluorescent wavelength of the two kinds of fluorescence confocal scanning microscopy are calculated in this paper by using fourier imaging theory. the results show that the fluorescent wavelength has influence on imaging property of confocal microscopy such as spatial cut - off frequency, resolution and 3d - otf. there is a different missing - cone in the 3 - d space of otf when the ratio of excitation wavelength to fluorescent wavelength decreases

    本文在sheppard和gumin等人的理論基礎上,利用fourier光學成像理論,討論了不同熒光波長對單光子和雙光子共焦顯微鏡成像特性的影,導出了單光子和雙光子共焦顯微鏡的熒光功率傳輸、三維脈沖和三維光學傳遞,得到了它們在不同激發波長與熒光波長比值時具體的表達式,並且通過值計算,得到了它們的曲圖,結果表明:隨著激發波長與熒光波長比值的增加,焦斑的橫向分佈和縱向分佈變窄,橫向解析度和縱向解析度提高,系統的成像效果變好,當激發波長與熒光波長的比值下降到一定程度時,可以看到不同程度的失錐現象。
  16. Integrated log response function can be derived from the change rate of logs over boundary

    在地層界面處的曲變化中提取出測井曲的綜合縱向
  17. First, the methods and procedures of general three orders nonlinear identification are summarized and the results are frequency functions described by basic and high order spectral density functions and frequency response functions

    首先,系統總結了使用一般三階非性模型辨識的方法和步驟。得到的結果是用基本的和高階的譜密度以及基本的和高階的頻率表示的頻率
  18. Based on the transform of coordinate and principle of superposition, a generalized integral formula dealing with moving load problem is established. an impulse response function used in the integral is obtained by means of laplace and hankel transform

    在論文中,基於性系統的疊加原理和坐標變換,建立了求解移動荷載作用下粘彈性地基板的動力積分公式,把運動荷載問題轉化為獲取位移脈沖
  19. Based on the equation of general frequency response functions ( gfrf ) of the non - linear dynamic systems, in this paper, the difference is applied to detect the non - linear element positions in a complex structure

    本文在研究非性系統廣義頻率表達式的基礎上,導出一種適用於復雜結構中非性元件位置分佈的判斷方法。
  20. When a series of different levels of sine excitation force is imposedon a non - linear testing structure, the response data vary with the force

    性系統在不同力幅的正弦激勵時,其頻率將隨力幅而變化。
分享友人