緩沖容量 的英文怎麼說

中文拼音 [huǎnchōngróngliáng]
緩沖容量 英文
buffer capacity
  • 緩 : Ⅰ形容詞1 （遲; 慢） slow; unhurried 2 （緩和; 不緊張） not tense; relaxed Ⅱ動詞1 （延緩; 推遲） d...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  1. A common data acquisition card can be used on laboratory virtual instrument engineering workbench through designing the external interface between labview and common date acquisition card on the software design ; used the idea of the double buffer and direct memory access, a real time data acquisition and logging about the succession, big capacitance leakage current is realized ; a digital filter is designed to filter high frequency signals

    在軟體設計上，設計了與普通數據採集卡的介面，實現了在labview環境中應用普通數據採集卡的功能；運用雙緩沖和內存直接映射的設計方法實現對連續、大容量泄漏電流信號的實時採集和存儲；設計了數字濾波器對採集后的原始數據濾去高頻干擾。
  2. Making use of asymptotic analysis of a queue handling many traffic sources, a method for estimating qos parameters based on measurement is presented, which takes into account the effects of the finite buffer space on the multiplexing performance

    利用大數量業務源復用漸近分析理論提出了一種基於測量的qos參數估計方法，該方法考慮了有限容量緩沖區對復用性能的影響。
  3. One side, groovy cast steel flap valves increase the head loss, waste electricity, the other side, when flap valves close, it always delay time because of it ' s low proportion. the bump load seriously threaten the safety of pumping station. through the research and development of flap valve used in the renovation practices in the design of air - filled floating flap valve in no. 1 chuhe pumping station of anhui province, the working characteristics and design methods of air - filled floating flap valve are studied in this paper

    但在拍門運行使用的同時，又時常暴露出一些缺陷，主要有：一是常規的鑄鐵或鑄鋼拍門加大了流道的水頭損失，特別是對于裝機容量較大的排澇泵站，其電能損耗相當可觀；二是拍門在自重下下落關閉時，往往由於過多考慮水頭損失導致浮重過小而延誤閉門時間，致使水體倒灌，再因緩沖裝置失靈導致閉門時門體對門框撞擊力很大，嚴重危及站身安全。
  4. In this part, the high - frequency series inverter with resonant pole capacitor is introduced mainly. the current - exchanging processes of the inverter in different working modes are analyzed, how to reduce the switching loss is discussed, and the calculating methods of snubber capacitor c, factor angle switching frequency and pulse width pw are given in optimum switching process. and results of simulation and experiment verify the validity of theoretic analysis

    接著重點研究了含有諧振極無損緩沖電容的逆變器，對其換流過程中的不同工作狀態進行分析，討論了如何減小逆變器的開關損耗，給出了最佳工作狀態下緩沖電容c 、感性角、開關頻率、觸發脈沖的脈寬pw的詳細計算方法，並通過大量的模擬和實驗波形證明了理論分析的正確性。
  5. Novel stack cache architecture and data - forwarding mechanism between it and the execution unit are also presented. the relationship between the capacity and the backup frequency of the stack cache is analyzed too

    文中還設計了一種由多體靜態存儲器構成的堆棧緩沖結構，並在堆棧緩沖和執行部件之間採用了數據重定向技術，還對緩沖容量和後援頻度的關系進行了理論分析。
  6. It takes spatial data cache technology to establish the large capacity cache area for the backstage database, and to cushion customers ’ visiting request to the database, so as to reduce the frequency of the server access. in this way, the searching efficiency of the database system shall be improved

    利用空間數據緩存技術，為后臺數據庫設置大容量的緩存區，用於緩沖客戶對數據庫的訪問請求，減少對服務器訪問次數，從而提高數據庫系統的檢索效率。
  7. Another 20 kinds of non - designed contact points are given for the first time. contact determining algorithm of all the above contact types is given using z - buffer algorithm for 3 - d observation, and simulation results show high accordance with results of vector - associated method. simulation for non - designed contact mode with random initial conditions has been done too, and statistics from the simulation indicates that it is important to predict non - designed contact points in practical rvd efforts

    全文的工作包括以下幾個方面的內容: 1 .建立了周邊式對接機構的復雜幾何外形的數學描述，描述了對接初始條件范圍內，兩對接機構相互接近、捕獲過程中可能出現的20種設計接觸模式，並針對初始接觸點首次提出20種非設計接觸模式;利用計算機圖形學中可見面判別的z -緩沖演算法原理，給出了所有接觸模式的檢測演算法，該演算法的模擬結果與輔助向量法高度一致，驗證了演算法的有效性;進行了300組確定首次接觸點的隨機模擬，統計結果表明，在飛船上實時進行非設計接觸模式的預測是非常重要的。
  8. In the dissertation ， we discribe the implementation of large capability video data acquisition system based on pci bus of computer 。 the system is composed of data acquisiton card and corresponding software 。 the data acquisiton card include two acquisition channels ， 8 - bit digitization at rates up to 13. 5mhz 。 frist ， the architecture of the video data acqusition system is studied 。 then ， the function and implementation methode of each module are introduced in detail 。 the control module of the video data acqusition card is implemented by using of the isp technology of cpld and vhdl programming technology 。 the a / d converter used assembler to implement the initialazation programe 。 and the double buffer technology is used for large capability data acqusition. because a contiously large memory is difficult to apply in windows operating system 。 finally we use broland c + + to introduced the devleoping procedure of drivers 。

    在實際的研製過程中，利用cpld的在系統可編程（ isp ）技術和基於vhdl語言的可編程邏輯器件設計技術實現了視頻數據採集卡的控制模塊。在視頻的a / d轉換模塊，用匯編程序模擬i2c總線對初始化a / d轉換晶元。針對大容量數據採集，採用了雙緩沖技術解決wndows操作系統下難以申請到大容童連續內存的間題。
  9. With the increasing of the number of parallel channels, the throughput of system can be improved and the transmission delay can be decreased. at the same time, the buffer of the receiver can be also reduced

    而且通過增加并行操作的子通道數，可以做到提高吞吐量，減少傳輸時延的作用，同時還能降低接收端對緩沖容量的要求。
  10. A hydrogen - filled supergrid would serve not only as a conduit but also as a vast repository of energy, establishing the buffer needed to enable much more extensive use of wind, solar and other renewable power sources

    充填氫的超級電力網不只是傳輸路徑，也是龐大的能源儲存庫，建立必要的緩沖容量，讓風力、太陽能和其他再生能源更加普及。
  11. Method for determination the buffering capacity of wood

    木材緩沖容量測定方法
  12. Abstract : in a network system, overflow or overwrite of message buffer will cause missing of messages. for a timed token network, message transmission time and the message buffering space allocation in a node are very important issues on network real time capability. this paper analyses the message buffering mechanism, describes the relationship of message buffering space and message transmission bandwidth allocation, and proposes a space determination method of message buffer for ltpb network. the maximum space redundancy avoiding buffer overflow for “ send ” and “ receive ” buffers has been derived. it is found that the space of “ send ” and “ receive ” buffers is equal to the message size under condition that the message gap time is greater than message latency and node response time

    文摘:在網路系統中，節點緩沖區內消息發生覆蓋或溢出會造成消息的丟失，對于限時令牌網路，節點消息發送時間和消息緩沖容量的分配是影響消息實時性的重要因素.針對令牌傳遞網路分析了節點消息緩沖機制，說明了消息緩沖容量的確定與網路帶寬分配方法的關系，並提出了消息緩沖容量的確定方法，導出了避免消息覆蓋或溢出所需的最大發送和接收緩沖容量余度.指出在消息的產生間隔大於該消息的最大允許的延遲時間和接收節點響應時間的條件下，發送和接收端的消息緩沖容量等於被緩沖消息的長度
  13. In a network system, overflow or overwrite of message buffer will cause missing of messages. for a timed token network, message transmission time and the message buffering space allocation in a node are very important issues on network real time capability. this paper analyses the message buffering mechanism, describes the relationship of message buffering space and message transmission bandwidth allocation, and proposes a space determination method of message buffer for ltpb network. the maximum space redundancy avoiding buffer overflow for “ send ” and “ receive ” buffers has been derived. it is found that the space of “ send ” and “ receive ” buffers is equal to the message size under condition that the message gap time is greater than message latency and node response time

    在網路系統中，節點緩沖區內消息發生覆蓋或溢出會造成消息的丟失，對于限時令牌網路，節點消息發送時間和消息緩沖容量的分配是影響消息實時性的重要因素.針對令牌傳遞網路分析了節點消息緩沖機制，說明了消息緩沖容量的確定與網路帶寬分配方法的關系，並提出了消息緩沖容量的確定方法，導出了避免消息覆蓋或溢出所需的最大發送和接收緩沖容量余度.指出在消息的產生間隔大於該消息的最大允許的延遲時間和接收節點響應時間的條件下，發送和接收端的消息緩沖容量等於被緩沖消息的長度
  14. Consequently a new cac scheme for cbr traffic, lv ~ ? { ~ l ~ : atm ~ iija ~ jlijf ~ linear approximation cac scheme based on the lowest rate replacing, is presented. instead of using the tail of the infinite queue length distribution as an estimate to clr, this cac scheme obtains clr by the upper bound on it, and qos can be well guaranteed in our scheme

    在此基礎上，提出了一種新的cbr業務連接允許控制機制；基於最小速率替換的線性近似cac機制，該機制能夠提供服務質量保證，並且採用了有限容量緩沖區情況下cbr業務信元丟失率的上界，而不是將clr用無限容量緩沖區排隊系統的隊長尾部分佈來近似。
  15. A cac scheme for vbr traffic based on the rate - modified model is presented. in this scheme, the source model is obtained from the source traffic descriptor ( pcr, scr, mbs ) declared by the users at connection setup time and the direct effect of the relative values of the burst length and the buffer space on the cell loss performance is taken into account, which make our scheme be consistent with the standards and improve the resource utilization

    提出了一種基於速率改進模型的vbr業務連接允許控制機制，該機制所採用的業務模型依賴于用產在呼叫連接建立階段所提交的業務源流量描述符（ pcr ， scr ， mbs ） ， n博士學位論文： atm網路連接允許控制機制的研究並且直接體現了業務突發長度與緩沖區容量之間相對關系對信元丟失性能的影響，從而保持了與現有標準的兼容，並提高了資源利用率。
  16. The vulnerability exists because a component of the snmp agent service that interprets incoming commands contains an unchecked buffer a temporary data storage area that has a limited capacity

    出現此漏洞的原因是，解釋傳入命令的snmp代理服務組件包含未檢查的緩沖區具有有限容量的臨時數據存儲區。
  17. We can ration analyze and estimate hardware configure chosen in design such as machine tool, the capacity of buffer, the route of transport system etc, and personnel deployment of product line. we can forecast the produce cycle of product, analyze and forecast produce capacity of work - flow, simulate all kinds of predictable or random malfunction, finding bottleneck of system etc. we can also forecast the capability of work - flow under different scheduling strategy

    通過對流水線的模擬，我們可以對各種設計方案進行評估，可以定量分析與評價設計中所確定的硬體配置（如機床、緩沖庫容量、運輸系統路徑等）及生產線人員配備情況，預測產品生產周期，分析與預測生產線的生產能力，模擬各種可預見的或隨機的故障，發現系統瓶頸等。
分享友人
分享到 Line

分享到臉書