縱肋結構 的英文怎麼說

中文拼音 [zōnglèijiēgòu]
縱肋結構 英文
longitudinal system
  • 縱 : Ⅰ動詞1 （釋放; 放走） release; set free; let go 2 （放任; 不約束） indulge; give oneself up to; l...
  • 肋 : 肋構詞成分。
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. In addition to, the fatigue crack between web and upper flange of welded steel crane beam on heavy duty service was discussed, and based on long - term observation and research, the author classified fatigue crack into bearing type and middle type crack along the horizontal direction. the causation, distributive law and mechanism of the crack were analyzed, and the precautions to take and the measures to remedy crack were presented. the main defacts including damage, crack, erosion and aging in structures, especially in concrete structure were introduced ; the defact mechanism was analyzed and the precautions to take were also given

    另外，作者對重級工作制焊接鋼吊車梁腹板與上翼緣連接焊縫的縱向水平疲勞裂縫進行了長期的觀察和研究，根據疲勞裂縫產生的不同機理，將其分為支點裂縫和肋間裂縫，並討論了兩類裂縫產生的原因、分佈規律、機理以及防治的措施；對工程中經常遇到的結構構件，尤其混凝土構件的幾種主要病害（損傷、裂縫、腐蝕與老化）進行了機理分析並提出了防治措施。
  2. Steel decks, in other words, orthodox isomerism structures, are welded with various transverse and longitudinal reinforcing ribs. this results in the complexity of forces and deformatiort of the pavement layer above the deck

    鋼橋面板焊接在各種橫向、縱向加勁肋上，橋面板為正交異性板結構，決定了其上的鋪裝層受力變形的復雜性。
  3. The prestressed continuous beam - arch composite bridges are a special structural system where the horizontal thrust of the arch rib is absorbed by a prestressed tie at deck level. in some cases, this type of structure is preferable because it does n ' t have the large thrust at the spring hi traditional arch bridges and the somewhat large bending moment and shear force in traditional beam bridges. as a result, the performances of the prestressing reinforcement can be efficiently utilized

    它利用拱肋承擔壓力，系梁預應力束抵抗拱端推力，吊桿及縱橫橋面系結構承受橋面荷載，既克服了傳統拱橋巨大的拱端推力，又改善了連續梁橋較大的彎矩和剪力的受力狀況，最大限度地發揮了拱梁混凝土和預應力鋼筋各自的特點，經濟效益顯著。
  4. These four ship ' s class societies all use two holds length finite element modal near the central section. they mesh the finite element modal mainly according to the distance of longitudinal frames, we call this fine mesh finite element modal. the elements in the modal are mainly shells and beams

    這四家船級社相同之處是都採用了船舯附近的兩艙段長的有限元計算模型，有限元模型單元的劃分主要依據縱骨間距和肋距，即所謂的細網格模型，結構單元以板殼單元和梁元居多。
  5. Because the intervals of two side girders are relatively large in the structure of the floor, it is not even and some and out of shape that its bridge of panels must be produced at the same time horizontally and crookedly and vertically except deforming wholly, level analyse can receive the satisfied result already at this moment, is it is it accord with floor structure real work state, girder of cable - stay bridge just to analyse with whole out of shape relevant non - linear space of function while being out of shape while being above - mentioned to consider only, but about this research rarely seen to report bridge worker is it understand their receive strength characteristic in an all - round way to need badly publicly

    由於肋板結構中兩個邊主梁的間距較大，其橋面板除整體受力變形外必然同時產生橫向彎曲和縱向不均勻局部變形，此時平面分析已不能得到滿意的結果，只有考慮上述變形與整體變形相關作用的非線性空間分析才符合肋板結構主梁斜拉橋的實際工作狀況，但有關這方面的研究鮮見公開報道，橋梁工作者急需全面了解其受力特性。
  6. The submarine structure is simplified to single or double infinite cylindrical shell stiffened with rings, bulkheads and stringers, focusing on underwater sound radiation from the single shell. the shell motion is described by donnell ' s theory including excitation forces and reactions of rings, bulkheads, stringers and fluid, which leads to the fluid - structure coupling vibration equation. expressing displacements by velocities, applying modal expansion circumferentially and fourier transformation longitudinally result in the shell ' s modal equations of motion

    殼體的運動方程採用較為簡單的donnell理論描述，運動方程中包括了激勵力、加筋結構（環肋、艙壁和縱骨）和流場對殼體的作用力，從而組成流場-結構的耦合振動方程，並進一步將方程中的位移用速度表示，然後沿軸線方向進行fourier變換，將速度和各項荷載沿圓周方向進行模態展開，得到了殼體振動的模態運動方程。
  7. And a parametric method is used for the modeling of the pin fin, spanwise rib, and chordwise rib after delebrately studying their regular structures

    並深入研究了擾流柱，縱向肋，橫向肋這幾種內型典型結構的參數化造型方法。
分享友人
分享到 Line

分享到臉書