縱載構件 的英文怎麼說

中文拼音 [zōngzǎigòujiàn]
縱載構件 英文
axial load member
  • 縱 : Ⅰ動詞1 （釋放; 放走） release; set free; let go 2 （放任; 不約束） indulge; give oneself up to; l...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  1. The main components of the latter are multi - rib sandwich panels, including floor slabs and wall slabs. reinforced concrete conformation columns are set where the longitudinal walls and latitudinal walls intersect and copulative beams are set where floor slabs and wall slabs intersect. they play a role of linking and transferring loads, bearing a small part of loads at the same time

    無骨架體系的主要承重構件是密肋夾芯板（包括樓板和墻板） ，縱、橫墻相交處設鋼筋混凝土構造（連接）柱，墻板和樓板相交處設連系（圈）梁，連系梁和柱主要起連接和傳遞荷載作用，也承擔少部分荷載。
  2. The corbel ' s dimension should be ascertained as the manipulative condition of diagonal section. the amount of longitudinal reinforcement be ascertained on the basis of the flexure model, is obtained according to static for balance condition, the calculative expression of the load is obtained. and in terms of the design method in ultimate state the maximum load

    我國規范對于牛腿的設計規定，牛腿尺寸的確定以斜截面抗裂作為控制條件，縱筋用量的確定以彎壓破壞模型為基礎，根據靜力平衡條件得到承載力的計算公式，按照極限狀態設計方法計算得到，箍筋用量則按照構造要求確定。
  3. 3. a space bond slip relation of reinforcements in either end of a member is proposed, based on one - dimensional bond slip model of reinforcements proposed by teng zhiniirmg from tsinghua university, the first - time loaded ascending stage ? curve of which model is modified as the line which parameters are not changed so as to simply the computation. the bond, slip is regarded as the boundary nonlinearity of a member

    3 、採用清華大學滕智明建議的一維鋼筋粘結滑移恢復力模型，但從簡化計算的角度出發，將首次加載的上升段曲線改為直線，並假定構件端部的諸多縱向鋼筋的滑移服從平截面假定，考慮由節點錨固區粘結滑移引起的構件端截面軸向和兩轉角附加變形。
  4. The experimental result has shown that the ultimate bearing capacity and ductility of eccentrically loaded columns have a certain increase when they are strengthened with transverse cfrp. in addition, the excessive eccentrically loaded columns have a more notable effect as a result of strengthening with the combination of longitudinal and transverse cfrp. the increasing degree of strengthening columns ’ bearing capacity reduces while the volume of cfrp increases

    試驗結果表明，碳纖維布橫向加固偏壓柱時，其承載力和延性均有一定程度的提高;對于大偏心受壓柱，縱橫向聯合粘貼碳纖維布的加固效果非常明顯;隨著cfrp加固層數的增加，構件承載力的提高幅度減小。
  5. Firstly, for the system of moulding board and support frame in construction the side pressure and screws are analyzed. the material and structure form of support frame are discussed. the design of support frame uses the method of limited state, and also it analyses the integer stability, part stability, and single stability, and then proposes the load analysis of multi - level support frame

    首先，針對轉換層梁模體系及支撐架施工，重點分析了轉換層結構現澆混凝土對模板側壓力值及模板對拉螺桿的計算；討論了轉換層支撐體系的形式及構造，詳細論述了基於極限狀態設計的支撐架計算方法，包括縱橫向水平桿的強度驗算、立桿的整體穩定性、局部穩定性、單肢桿件穩定性等驗算，並提出了多層支撐架的施工荷載計算方法。
  6. Then the coupling beams with new reinforcement layout were made an inquiry into, and the improvement on the seismic behavior by coupling beams diagonally reinforced with a few rows in end regions was found out at last, based on the observations of the experimental phenomena and the analysis of the measurement result, and by the comparison of seismic behavior by making use of hysteretic response, ductility and energy dissipation behavior, a conclusion is presented : the code for design and construction of reinforced concrete high - rise structures ( the draft asked for advise hi 2000 ) ca n ' t ensure that the coupling beams have fairly good seismic ductility ; the result of improvement of the seismic ductility of the coupling beams by the increase hi stirrups besides the strengthen of longitudinal detailing reinforcement was n ' t obvious ; the coupling beams diagonally reinforced with a few rows in end regions have fairly good mechanisms, and the ductility and the behavior of energy dissipation are better than conventionally reinforced concrete coupling beams, so it is suitable to te tised in short coupling beams

    本文通過對三根小跨高比（均為l h = 1 . 0 ）剪力墻洞口連系梁在低周反復荷載作用下的試驗，了解了嚴格按《鋼筋混凝土高層建築結構設計與施工規程》 （ 2000年徵求意見稿）設計的連梁具有的抗震性能，研究了採取增大連梁配箍量同時加強縱向構造筋的方案對抗震性能的影響，並進一步對新的配筋形式的連梁進行了探討，了解了在連梁梁端配置多排交叉斜筋方案對連梁抗震性能的改善。通過對試驗現象的觀察和量測結果的分析，利用荷載?位移滯回曲線、延性和耗能性能等指標對各個試件的抗震性能進行了比較，最後得出結論： 《鋼筋混凝土高層建築結構設計與施工規程》 （ 2000年徵求意見稿）不能保證小跨高比連梁具有較好的抗震延性：通過增大連梁配箍量同時加強縱向構造筋的方案對改善連梁的抗震延性的效果不太明顯；梁端配置多排交叉斜筋的連梁具有相對較好的受力性能，其延性和耗能性能等各項性能指標均優于普通配筋連梁，宜在深連梁中採用。
  7. Taking the traffic load as moving point load, the deformation characteristics of longitudinal section of pavement and composite foundation under moving point load are analyzed, considering the effect of pore pressure, traffic velocity, parameters of pavement structure and subgrade. finally, two examples of pavement section and soft subgrade, longitudinal section of airport runway and composite foundation are calculated

    將交通荷載簡化為移動的集中荷載，計算分析了單次移動加載和循環移動加載條件下道路縱截面與復合地基共同變形特交通荷載作用下道路與軟土復合地基共同作用性狀研究性，探討了孔壓、行車速度及道路結構層和地基參數對道路變形的影響。
  8. Through the experimental and theoretical analyzing results, the conclusion can be summarized as follows. 1 ) the yielding load and ultimate bearing capacity of the beam are not affected by the value of the load under that load the cfrp sheets were retrofitted, but the value will affect the stiffness of the beam, especially the average tangent stiffness after rebar yielding. 2 ) the stiffness of cracked beams retrofitted with cfrp sheets is larger than that of the normal rc beams

    通過試驗結果分析發現，採用cfrp加固的鋼筋混凝土梁的剛度較普通鋼筋混凝土梁的剛度有明顯提高，纖維布對承受以抗彎為主的構件具有增強剛度、控制撓度的作用；纖維加固時梁所承受的荷載大小，即加固時梁內已存在的彎曲裂縫的寬度對梁的屈服荷載及極限承載力影響不是很大，但對梁的剛度有較大影響，特別是對縱筋屈服后的剛度影響較大。
  9. First1y, in this paper, the testes about tensi1e resistance of masonry components in different period are processed and re1ated suppositions and formu1as are brought forward : the formu1a about maxima1 shear stress of top side in high or tier masonry bui1dings is deduced. it can be found easi1y that the factors affect ing the maxima1 shear stress are vertica1 resi stance coefficient 1oad magnitude wa11 geometry dimensions and its modu1us of e1asticity

    首先，進行了不同齡期下的砌體試件抗壓力學性能試驗，提出了相關的假定和公式，推導出了縱橫墻荷載差影響下的多、高層砌體結構房屋頂層的最大剪應力公式，從中可以看出影響最大剪應力的因素有豎向阻力系數、荷載大小、墻體的幾何尺寸和墻體的彈性模量等。
  10. Performance test for prefabricated reinforced components made of autoclaved aerated concrete or lightweight aggregate concrete with open structure under predominantly longitudinal load vertical components

    主要為縱向負載下的敞形結構高壓蒸養加氣混凝土或輕集料混凝土預制加筋元件的性能試驗
  11. Guarantee the safety of this project. this experiment focus on the failure mode and the ultimate bearing capacity of these columns. besides, this experiment also study the rule of the development of the deflection, the crack, the strain and the stress with the process of this experiment.

    通過此次試驗重點研究重慶大劇院縱向框架細長柱的破壞形態（是強度破壞還是失穩破壞）和極限承載能力，同時研究構件的變形、裂縫、應力應變隨加載的發展變化規律及其破壞過程，為本工程及今後此類細長柱結構體系的設計提出一些有益的建議。
分享友人
分享到 Line

分享到臉書