繞組 的英文怎麼說

中文拼音 [ràozǔ]
繞組 英文
[電學] winding
  • 繞 : 繞名詞1. [書面語] （彎曲） bend2. （姓氏） a surname
  • 組 : Ⅰ名詞1 （由不多的人員組成的單位） group 2 （姓氏） a surname Ⅱ動詞（組織） organize; form Ⅲ量詞（...
  1. Powerformer have some changes in constract with the conventional generator ， subsequently it also have some new problems in order to have an economical ， efficient ， credible development and application the structure and the philosophy of electromagnetism of powerformer will be on speaking terms changes electrical design ， magnetism design ， thermal design and structural design are have some new changes above all ， the electromagnetism parameter and the harmonic magnetomotive force of powerformer are studied in this paper first ， it mainly utilizes analytics to deduce formula of slot leakage reactance it considers three instances ， including monolayer - slot ， multilayer isometric - slot and multilayer anisometric - slot then ， the analytics and the fem are utilized to calculate slot leakage reactance of stator winding of prototype of powerformer and compare their results second ， the theory of utilitzing fem to calculate the reactance of powerformer is simply introduced ， including stable reactance ， transient and subtransient reactance specially ， the saturated influence of the stable reactance is considered then ， the results are analysed final ， it mainly introduces the influence of harmonic magnetomotive force of stator winding and analyses the harmonic magnetomotive force of stator winding then ， it mainly analyse harmonic magneto - motive force of stator winding through arranging various arrays of stator winding and observe their influence

    基於上述原因，本文對powerformer的電磁參數以及定子繞組諧波磁勢進行了研究。首先是用解析法推導出powerformer定子繞組槽漏抗的計算公式，考慮了單層圓形半閉口槽、多層等半徑圓形半閉口槽和多層不等半徑圓形半閉口槽三種情況，並對powerformer樣機的定子繞組槽漏抗用解析法和有限元法進行了計算，並比較其結果；其次，簡要介紹了有限元法計算powerformer電抗參數的原理，包括穩態電抗、瞬態電抗和超瞬態電抗，對穩態電抗考慮飽和影響，對結果進行分析；最後，介紹定子繞組諧波磁勢對電機運行性能的影響並對定子繞組諧波磁勢進行了分析。然後通過對定子繞組進行不同排列來分析定子繞組諧波磁勢，看看繞組排列對諧波磁勢的影響。
  2. The current transformer is fully enclosed. the primary and secondary windings and iron core are insulated by epoxy resin. it has a good ability of antipollution and moisture proof

    本型電流互感器為全封閉結構，一、二次繞組及鐵芯均澆注在環氧樹脂內，耐污染及潮濕。
  3. The current transformer is fully enclosed structure. the primary and secondary windings and iron core are insulated by epoxy resin. it has a good ability of antipollution and moisture proof

    本型電流互感器為全封閉結構，一、二次繞組及鐵芯均澆注在環氧樹脂內，耐污染及潮濕。
  4. The current transformer is fully enclosed and busbar structure. the secondary windings and iron core are insulated by epoxy resin. it has a good ability of antipollution and moisture proof

    本型電流互感器為全封閉母線式結構，二次繞組及鐵芯均澆注在環氧樹脂內，耐污染及潮濕。
  5. The armature winding in no. 2 generator rewound

    重繞了2號發電機電樞繞組。
  6. General specification for printed armature dc servomotor

    印製繞組直流伺服電動機通用技術條件
  7. In this thesis, the author analyses the deficiency in detecting and controlling function of the computer detecting and controlling system utilized in present transforming station. the strategy of design of software on operation and direction of 5 00kv transformer station is presented. it points out that we can deduce the mathematic analytical formula using the current, voltage and power of two terminals of transmission line as input. on this basis, we do realtime calculation of 500kv transmission line ' s parameter. we can also deduce the linear analytical formula of three - winding autotransformer ' s resistence using its current, voltage and power as input. the corresponding software is programmed on this basis

    論文提出以輸電線路本端和對端電流、電壓、功率作為輸入量，導出了超高壓長線的波阻抗和傳播常數的數學解析式，在此基礎上進行了500kv輸電線路實時參數計算；提出以三繞組自耦變壓器的電流、電壓、功率為輸入量，導出了自耦變壓器繞組的電阻、電抗的線性解析式並進而對變壓器的實時參數進行計算；在此基礎上編制了相應的軟體。
  8. The control system with such method is simulated and a inverter is made for speed control of single - phase motor. the method presented in this paper offers such advantages as easy implementation, large range of frequency and rapid dynamic response. furthermore, using this method, the single - phase motor with symmetrical or dissymmetrical windings can operate symmetrically

    本文提出的變頻調速控制方法具有系統設計簡單易實現，調速范圍大，動態響應快等特點，而且在電機繞組對稱和不對稱兩種情況下均可實現變頻調速的對稱運行。
  9. The winding through which a current is passed to produce the primary source of flux in the machine is called the field winding

    電流通過其在電機中產生主磁通的繞組稱為勵磁繞組。
  10. The two - point to earth short fault may cause short currents whic h can lead to serious accident. so it is necessary to monitor the state of field windings of turbo - generator and detect the kind of fault and predict its inclination. thus the security level of power system will be improved

    由於發電機轉子兩點接地故障時會產生較大的短路電流，導致惡性事故的發生，因此對發電機轉子繞組進行狀態監測，判斷短路故障的形式和趨勢是十分必要，有助於提高系統安全運行水平。
  11. The time harmonics can be considered as voltages of higher frequencies applied to the windings.

    時間諧波可以看作是施加在繞組上的較高頻率的電壓。
  12. The calculation method using in factory has larger error and is n ' t used in high ignition point oil transformer. in this paper a calculation method, which has been verified by experiment results, is presented based on the fundamental theories and rule equation of heat transfer to calculate the temperature rise of average oil, top oil, coil, core and hot - point. a program has been compiled

    本課題立足於工程實際應用，根據傳熱學基本原理和經典試驗換熱準則式，通過對變壓器發熱冷卻原理進行分析和研究，提出了一套計算變壓器平均油溫升、頂油溫升、繞組溫升、鐵芯溫升和最熱點溫升的計算方法並編制了計算軟體，對影響變壓器溫升的因素進行了分析。
  13. The relations between relative measurementerror resulting from temperature and heat distensibility coefficient of coil ’ s framework andwindingcoilwerecarriedout. theinfluenceofelectromagnetisminterferenceontheaccuracyof rogowski coil, as well as the effect of temperature on integraph, were studied. somemeasures based on the above investigating results were proposed to insure the precision ofrogowski coil sensor head, such as the selection of materials and facture methods, improvment of technics and design of additional compensation

    利用建立的rogowski線圈的數學模型對溫度和外界干擾磁場的影響進行了分析，得出了溫度造成的相對誤差與線圈骨架和繞組線圈熱膨脹系數之間的關系;從兩個方向上分析了干擾磁場對線圈精度的影響;分析了溫度對積分器的影響等。
  14. Next, in order to comprehand the electromagnetic characteristics and the dynamic characteristics of the new type of magnetic micromotors, the dissertation applied the concept of the magnetic scarlar potential of the irrotational magnetic fields and set up the mathmatic model for the inner magnetic field of the new type of motors from the basic equations and the boundary conditions of the motor magnetic field. oh the basis of the mathmatic model, the dissertation analized the various qualities of the magnetic field of the air gap between the rotor and the stator and gave a detailed calculation of the air gap ' s magnetic potential, magnetic field intensity, magnetic induction, the shape of the magnetic scarlar potential level surface, the distribution of the magnetic circuit, the magnetic induction the self - inductance and the mutual inductance of the coils

    其次，為全面了解這種新型電磁電機的電磁特性和動力特性，本文從電機磁場的基本方程及其邊界條件出發，應用無旋磁場的標量磁位概念，建立了端面搖擺式電磁微電機內部磁場的數學模型，並以此為基礎，詳細分析了電機氣隙磁場的各方面性質，對氣隙磁場的磁標位、磁場強度、磁感應強度、等磁位面形狀、電機工作磁路的分佈、電機的工作磁通量以及激勵繞組的自感和相互之間的互感進行了詳細的分析計算。
  15. The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation

    二、在高頻變壓器原邊，當開關管接收控制信號脈沖列（經調制的spwm波列）導通時，在低頻調制信號的正半周或負半周內，施加在變壓器繞組上的是同一方向的電壓，變壓器磁芯中的磁通可能將級進地逐漸增加，導致磁芯飽和，造成磁偏或單向磁化，導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。
  16. Analysis of the equivalent reactance of triplex winding transformer

    淺析三繞組變壓器的等值電抗
  17. Since the secondary winding is normally operated into a high-impedance circuit, the secondary current is quite small.

    因為次級繞組通常輸入高阻抗的電路，因此次級電流很小。
  18. Two kinds of new on - line monitoring methods, which are based on measuring primary, secondary currents and voltages to calculate the short - circuit reactances of windings for detecting the deformation windings of power transformer, are proposed in the paper. the methods used for on - line measuring the short - circuit reactances of traction transformer in electric railways, are designed

    本文提出了兩種在線監測變壓器繞組變形的方法，通過在線監測變壓器繞組原、次邊的電壓和電流量，實時計算變壓器繞組的短路電抗來判斷變壓器繞組變形情況，並對電氣化鐵路主要接線型式的牽引變壓器繞組變形的在線監測方案進行了設計。
  19. However, the result of the simulation, in which all the parameters are kept constant except the primary and secondary inductance, is that 3 % higher conversion efficiency can be achieved in ccm than in dcm

    但對輸出功率和繞組電阻相同時逆變電路模擬結果表明， ccm的效率比dcm提高了三個百分點；試驗結果說明盡管ccm的繞組電阻比dcm的大，變換器效率仍提高了1 . 5 。
  20. In the next place, the paper analyses systematically high frequency coaxial winding transformer applied to the load of series resonance converter, puts up its mathematical model, and presents a optimum design

    其次，文中對串聯諧振逆變器的負載高頻同軸繞組變壓器進行了系統分析，給出了數學模型，並提出了優化設計方案。
分享友人
分享到 Line

分享到臉書