纖狀變晶結構 的英文怎麼說

中文拼音 [xiānzhuàngbiànjīngjiēgòu]
纖狀變晶結構 英文
nematoblastic texture
  • 纖 : 纖形容詞（細小） fine; minute
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  2. The microcrystalline was same to the direction of electric field. the microcrystalline orientation of the film that was obtained by melting pvdf congealing in the effect of electric field changed along electric field obviously. comparing with the film congealing without electric field their crystalline plate become thick

    發現pvdf纖維在電場作用下微觀結構變化較大，極化后微晶取向發生較大變化，極化以後微晶變化為沿電場方向取向的厚片狀，熔融態的pvdf在電場作用下凝固時變化更明顯，與不加電場直接凝固的pvdf膜相比，在電場作用下幾乎所有的分子鏈都沿電場方向取向所以出現有序的片晶結構，而且結構緻密。
  3. The results showed that the in - situ formed tibi particles which had a size of about 50nm, exhibited a homogenous dispersion in the copper matrix. moreover, the interface between the nanoscale particles and the copper matrix was clean, and there was no certain location relationship. due to their reinforcement, the tensile strength and hardness of the in - situ cu - tib _ 2 nanocomposite significantly improved

    通過光學顯微鏡、 tem 、 xrd等對cu - tib2原位復合材料進行了金相組織、微結構分析，原位復合材料的鑄態金相組織中彌散分佈著團簇狀的tib2顆粒；形變態金相組織中tib2顆粒呈纖維狀排列； tem觀察表明：在基體內存在著尺寸約為50nm 、彌散分佈的tib2顆粒，且tib2顆粒與基體之間界面清晰，但由於tib2結構與銅晶體結構的差別較大， tib2顆粒與基體之間無固定的位向關系；納米tib對銅基體有良好的增強作用。
分享友人
分享到 Line

分享到臉書