耐摩擦性 的英文怎麼說
中文拼音 [nàimócāxìng]
耐摩擦性
英文
frictional resistance-
Ptfe has many excellent properties such as : bonzer self - lubrication ^ low fricatiom chemistry stabilization and thermal stabilization, but its wear resistance is very low to improve the wear resistance of ptfe a lot of researches have been down by means of adding fillers to it, there are still less report on nano - inorganic filler filled ptfe composites to change properties. in this paper, experimental study was made to question above problem
Ptfe具有優異的自潤滑、低摩擦、化學穩定性和熱穩定性，但耐磨性較差，因而人們在利用不同種類的填料對ptfe進行填充改性，提高耐磨性方面作了大量研究工作，但在使用納米無機填料填充改性ptfe方面研究很少，因此本課題主要探討這一方面的問題。Semimetal non - asbestos environmental protection automobile brake shoe with stable friction indexes, contractible heat fade, excellent performance in high temperature, strong friction resistance, long working life and stable brake, small noise, fine energy absorption, no asbestos, no pollution, ect characteristics. complied with international standard, it s a ideal brake article for users
本公司研製生產的半金屬無石棉環保型汽車剎車片，具有摩擦系數穩定，熱衰退縮小，高溫段穩定性能好，耐磨性強，使用壽命長，制動平穩，制動時噪音小，能量吸收效果好，無石棉，對環保無污染等特點，符合國際規范，是廣大用戶的理想的剎車製品。Sepiolite has low shrinking rate, plasticity is good, alkali - resisting and easy to dissolve, absorb the peculiar industry performance such as being strong of performance, in addition, also absorb, decolouring, hot stability is anticorrosive, resist radiation and insulate against heat, the characteristic such as being insulating, is used in the non - asbestos jointing sheet, various of brake shoes, paint, sound insulation of the building mainly, thermal insulator
海泡石具有收縮率低，可塑性好，耐堿易溶解，吸附性能強等特有的工業性能，除此之外，還具有吸附，脫色，熱穩定，抗腐蝕，抗輻射及隔熱，絕緣等特性，主要用於密封產品如非石棉橡膠板，摩擦產品如各式剎車片，油漆、塗料，建築隔音、隔熱材料。Sepiolite has low shrinking rate, plasticity is good, alkali - resisting and easy to dissole, absorb the peculiar industry performance such as being strong of performance, in addition, also absorb, decolouring, hot stability is anticorrosie, resist radiation and insulate against heat, the characteristic such as being insulating, is used in the non - asbestos jointing sheet, arious of brake shoes, paint, sound insulation of the building mainly, thermal insulator
海泡石具有收縮率低，可塑性好，耐堿易溶解，吸附性能強等特有的工業性能，除此之外，還具有吸附，脫色，熱穩定，抗腐蝕，抗輻射及隔熱，絕緣等特性，主要用於密封產品如非石棉橡膠板，摩擦產品如各式剎車片，油漆、塗料，建築隔音、隔熱材料。The result of those studies as follow : ( 1 ) an composite layer of definite thickness on the casting was gained by cast - sintering technique, and it has well wear - resistance. ( 2 ) the reinforcement of the composite layer is tic or vc, which was exiguous and is well distributed
同時利用干滑動摩擦磨損實驗，對表面復合層的耐干滑動摩擦磨損的性能進行了研究。研究表明： （ 1 ）利用鑄造燒結技術可以在鑄件表面獲得一定厚度耐磨性能良好的表面復合層。Standard practice for determining the waterfastness of images produced by ink jet printers utilizing four different test methods - drip, spray, submersion and rub
用四種不同的方法測定用噴墨印表機製作的圖像耐水性的標準實施規范.滴注噴射浸水和摩擦1. 5 m in diameter ) were dispersed in n46 engine oil with different concentrations using ultrasonic respectively in order to study their tribological properties. the tribological experiments were carried out by mq - 800 four - ball tribometer and mm - 200 ring - on - block tribometer, in which extreme pressure properties, wear scan diameter, friction coefficient and wear volume loss were measured. the results showed that oil containing mos2 nanoparticles had a better wear resistance, friction - reducing and extreme pressure than the oil containing common mos2
將上述制備得到的納米二硫化鉬顆粒和普通二硫化鉬粉末（ 1 . 5 m ）以不同濃度分散在n46機械油中，在mq - 800四球摩擦磨損試驗機上考察它們的最大無卡咬負荷（ p _ b值） 、耐磨性能和摩擦系數；並在mm - 200摩擦磨損試驗機上，通過環?塊摩擦副，比較和分析了它們的摩擦學特性。Moreover, it is a compatible raw material under the terms of the food sanitation law. also, through the use of newly developed complex technology, we have given this coating excellent non - adhesion, low friction and sliding capabilities, etc. thanks to these capabilities it has become possible to adjust the surface treatment performance to match a wide range of application purposes, equipment, etc
聚氨酯本身具有耐磨損性，高摩擦系數特性，還有防止靜電的導電特性，保證工廠安全的自動溶解特性，亦可用作食品衛生法對應的原料，此外通過最新開發的復合技術具備了無粘性，低摩擦性，光滑性等諸多優點，用途更廣泛，可適用於各種器械的表面處理施工。And also, the wear resistance at ambient temperature and of za27 alloyed with mn when lightly loaded is desirable but becomes worse at high temperature. the wear mechanism of the one mixed with both adhesive and abrasive wear under sliding friction conditions ( at high temperature )
Si的加入量為1 - 3時， za27合金的磨損量最少，高溫摩擦性能最好；加入mn后， za27合金在低溫輕載下耐磨性能較好，高溫耐磨性能不理想；在滑動摩擦條件下（高溫）的磨損以粘著磨損和磨料磨損兩種方式共同存在。But when heavyly loaded, the former is far better than the latter. the wear resistance of za27 alloyed with mn is no obviously better than that of common za27 alloy. under the sliding friction conditions, the wear resistance at high temperature of za27 is improved by alloyed si and reaches the highest level when the content of si is 1 - 3wt. %
裂紋主要始於脆性相si相和mn相，裂紋沿晶界擴展；在滑動摩擦條件下（常溫） ，含si的za27合金在載重較小時，耐磨性與普通za合金相比沒有明顯提高，但在載荷較大的情況下，其耐磨性遠高於普通za27合金材料；加mn的za27合金與常規za27合金相比，耐磨性沒有明顯提高；在滑動摩擦條件下， si的加入提高了za27合金的高溫摩擦性能。We built a test road and after one year, we used surface wave exploration to test. the result is that the repaired layer felt old road well and have no empty spot. we used the pendulum friction tested and the results are the wear - resisting property is better than cement concrete pavement and pendulum friction is higher than cement concrete pavement
此種材料同原有水泥混凝土路面的粘結性能強，強度上升快，韌性大，抗凍性好，防水抗滲；通過試驗路運營一年多的檢測結果表明：通過面波儀測定修補層與原路面粘結良好，沒有脫空點；利用擺式摩擦儀測定其耐摩耗性能優于原水泥混凝土路面。The testing results showed that the material with good friction stability and high dynamic mechnical properties was an idea brake friction material
經檢測，該材料力學性能較高，摩擦性能穩定，摩擦因數在0 . 45 ~ 0 . 60 ，同時具有較好的耐磨性。Tribological properties and mechanism of fe - cr - ni coating
耐磨塗層的摩擦性能及作用機理Featuring shock resistance about ten times that of glass together with high abrasion resistance, these plastic optical lenses are at the heart of our swans brand products, which include special glasses for fishing, golf, baseball, marathon running, etc. as well as ski and swim goggles
作為鏡片來說採用了超輕量，耐震性是玻璃強度的10倍，耐摩擦性強的光學優質不變形高精密度鏡片來作為運動眼鏡。同時用swans品牌展現了釣魚，高爾夫，棒球，馬拉松等專用鏡片和滑雪，游泳的護目鏡。The surface strength of flexo print was discussed from paper smoothness, paper glossiness, and print dot percentage. it was put forward that the surface strength is determined by rub resistance
摘要從柔印所用紙張的平滑度、光澤度以及印品網點面積百分比等3方面，探討了柔印印品的表面強度問題，表面強度是通過耐摩擦性能來衡量的。Standard test method for resistance of transparent plastics to surface abrasion
透明塑料軟片表面耐摩擦性的標準試驗方法Feature for good anti - impact intensity, low friction index, good wear resistance, light weight, anti - aging, anti - corrosion, self - lubricating, antistatic, electricity
具有抗沖擊強度、摩擦系數小、耐摩擦性好，重量輕，耐老化、不腐蝕、自潤滑、抗靜電。Upon the application background of solid lubricants and wear resistant materials, the microstructure and tribological property of carbon nanostructure synthesized on the porous anodic aluminium oxide ( aao ) template were investigated
本文以固體潤滑耐磨材料為應用背景，對在多孔陽極氧化鋁（ aao ）模板上生成的納米碳結構薄膜的組織結構及其摩擦性能進行了研究。Furniture - assessment of the surface resistance to abrasion
傢具.表面耐摩擦性評定Excellent antifriction capability against chips ; good tensile strength against deformation
耐摩擦性強，不易掉屑，抗張強度大，不易變形。分享友人