耐沖蝕塗層 的英文怎麼說

中文拼音 [nàichōngshítúcéng]
耐沖蝕塗層 英文
erosion-resistant coating
  • 耐 : 動詞（受得住; 禁得起） be able to bear or endure
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 塗層 : paint-coat; paintcoat; coat; coating; covering; lining; wrapping flux
  1. The surfaces adopt a series of advanced craft, such as sour wash, degrease, the turns, the static electricity sprays, etc. making the surfaces layers hard, bear the impacted the corrosion and more beautiful and meticulous

    表面採用酸洗，脫脂，磷化，靜電噴塗等十余道先進工藝，使塗層堅固，耐沖擊，耐腐蝕，美觀細致，表裡如一
  2. When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set

    當膠粘劑中填料為其它物質（未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合）時，通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時，膠粘劑的拉伸剪切強度最高；同時進行了沖蝕磨損試驗，通過比較得出，當膠粘劑塗層中有機化蒙脫土含量達到5時，塗層的耐沖蝕磨損性能最佳，並對沖蝕磨損試樣在掃描電子顯微鏡（ set ）上進行觀察。
  3. The mechanism of corrosion and erosion resistance of nicr alloy and cermet coatings were explored and their performance were compared with 20g, 20g covered by dope and the coatings of fecral, nicrti used widely at present

    並將由這些新的塗層材料和目前廣泛使用的fecral ， nicrti以及與未加以保護的20g基體和刷塗料保護的20g在抗高溫氧化、高溫腐蝕、耐沖蝕磨損和熱震性等方面加以比較。
  4. Preparation of sic nanoparticles reinforced zinc aluminium based corrosion resistance coating and its properties research

    2復合塗層在水介質中的耐沖刷腐蝕性能
  5. Methods of test for ancillary components for masonry - part 13 : determination of resistance to impact, abrasion and corrosion of organic coatings

    圬工輔助構件試驗方法.第13部分:有機塗層耐沖擊性耐磨性及耐腐蝕性的測定
分享友人
分享到 Line

分享到臉書