耐溫性的 的英文怎麼說

中文拼音 [nàiwēnxìngde]
耐溫性的 英文
durothermic
  • 耐 : 動詞（受得住; 禁得起） be able to bear or endure
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 溫性的 : humoral
  1. Characters and main use : camouflage printed, light and flexible, good low temperature resistance, air tightness and heat welt. suitable for making air bed, air cushion and water bag

    特點及主要用途：迷彩印花，織物結構比較輕、薄，具有優異的耐低溫性、氣密性、高周波焊接性。適合做氣床、氣墊等充氣產品及儲水袋類產品。
  2. Characters and main use : light weighted, flexible, good low temperature resistance, air tightness and heat welt. suitable for making lifejacket, airbag, air bed, air cushion and water bag

    特點及主要用途：輕、薄，富有彈性，具有優異的耐低溫性、氣密性、高周波焊接性。適合做救生衣，氣墊，氣床等充氣產品及儲水袋類產品。
  3. Results show that : ( 1 ) for each particle size of andalusite, variation tendency of the properties of the material is generally the same : the maximum of bulk density, compressive strength and rupture strength appears in the range of 5 % - 10 % content of fiber, these properties of the material remarkably decrease as the fiber content exceed 10 % ; while at the same fiber content, the properties of the material increase with the increase of firing temperature

    結果表明： （ 1 ）對于不同粒度的原料，性能變化規律大致相同：在同一燒成溫度下，體積密度、常溫耐壓強度、常溫抗折強度在5 10之間出現峰值，加入量超過10之後材料的性能明顯下降；在相同的纖維含量下，隨著燒成溫度的提高，試樣的各項性能均有所上升。
  4. It focuses on the theory of the mineral functional materials " improving the anti - chloride permeability and the chloride binding. the main achievements of this article include : 1 ) use the technology of xrd, sem, bet, laser particle size distributor etc to test the component, the construction, particle size distributor, specific surface etc of micro - silica, ultra - fined slag, high quality fly ash, meta - kaolin clay, four types of the mineral functional material, theoretically analysis the functions which the four mineral functional minerals act on cement concrete, namely pozzolanicity effect, filling effect, micro - aggregate effect, surface adsorption effect and so bring into play the affect of plastification, lowing of temperature, reinforcement, improvement of durability. base on this analysis we can conclude that the proper diameter of the mineral functional material is 5 m - 15 m, that is blain fineness 4500cm2 / g - 7500cm2 / g

    本論文的主要成果包括以下幾個方面： （ 1 ）採用xrd 、 sem 、 bet 、激光粒度分析儀等多種測試手段，探明了以硅灰，超細磨粒化高爐礦渣，優質粉煤灰及偏高嶺土超細粉等4種超細礦物功能材料的組成、結構、粒度分佈、比表面積等基本性質；從理論上分析了礦物功能材料在混凝土中的4種效應，即火山灰效應、填充密實效應、微集料效應、表面吸附效應，並由此發揮出增塑、溫峰削減（降熱） ，增強及耐久性改善等作用；通過相關理論分析，推導出礦物功能材料的合理粒徑范圍在5 m 15 m ，即勃氏比表面積為4500cm ~ 2 g 7500cm ~ 2 g 。
  5. In trpsin tolerance assay. this virus could resist to 1 % trpsis at 37 in an hour. in acid tolerance assay, this virus was resistant to ph3. 0 and ph5. 0 at 37 in 2 hours, and the average infection litre of the virus decreased little. in heat assay, at 50, the virus was processed from 5 minutes to 150 minutes and at each condition the viral virulence reduced to some certain degree. among these conditions, when at 50 in 30 minutes. the average infection litre of this virus decreased over 2 tilre. and when al 50 in an hour, cpe of ihis virus disappeared. when time was set for an hour. but with processed in different temperature as 50 60 70, 80, the virus losl the multiplication capacity complelely. in biological assay, we selected different cell lines to cultivate this virus by laking advantage of possesional cells at that time in our laboratory. then we found that fcwf cell line was the most sensitive to dxmv and mdck was the second. with f81 cell line, after passaged for 12 times continuously with low concentration of fcs. the virus could produce cpe. however, with vero cell line. the virus could not procuce any cpe after many passages. the hemagglutination and lumadsorption reaction test proved that this virus had no any reaction to erythrocyte of pig, fowl and cavy. by neutrolizaion assay, dxmv could be identified as a kind of ccv

    理化學研究表明，該病毒為rna病毒，對氯仿、乙醚敏感；胰酶試驗中，經37 、 1小時處理的病毒，仍然能夠在貓源細胞fcwf細胞上生長，並且毒力基本保持不變；耐酸性試驗中，病毒分別在ph5 . 0和ph3 . 0經37作用2小時，毒力僅下降一個滴度；耐熱性試驗中，該病毒在恆定溫度50 ，設定不同時間，從5分鐘到150分鐘，毒力均有不同程度下降，其中， 50作用30分鐘，病毒平均滴度下降2個單位； 50 ， 60分鐘， cpe消失；恆定時間1小時，設定不同溫度（ 50 - 60 - 70 - 80 ） ，病毒在細胞上完全喪失增殖能力， cpe消失。生物學試驗，利用實驗室現有條件，選擇不同的細胞系對該病毒進行培養，發現該病毒對貓源細胞fcwf最敏感； mdck細胞次之； f81細胞經多次傳代，亦可出現cpe ；而vero細胞則不敏感。血凝試驗表明，該病毒對豬、雞、人及豚鼠的紅細胞均無血凝性。
  6. Testing method for heat resistance under temperature gradient

    溫度梯度下耐熱性的測量方法
  7. The effect of borided layer at low temperature on wear resistance and brittleness of borided layer for steel 45 was studied by means of wear test, brittleness test and anode polarization measurement

    通過磨損試驗、脆性試驗和陽極極化曲線的測試，研究了低溫滲硼對鋼滲硼層耐磨性、脆性和耐蝕性的影響。
  8. In the present study, the grass carp ( ctenopharyngodon idellus ) cell line zc - 7901 and the colossoma brachypomum cell line cbs were used as in vitro model systems to study the effects of cold stress on the cell membrane fluidity, the level of cacium ion, the contents of malondialdehyde ( mda ), the level of c > 2 and the system of antioxidative enzymes in the fish cells

    本文以培養的草魚（ ctenopharyngodonidellus ）吻端細胞系zc - 7901和淡水白鯧（ colossomabrachypomum ）吻端細胞系cbs為模型，研究低溫脅迫對其細胞膜流動性、鈣離子水平、 atp酶、丙二醛（ mda ）含量、超氧化物陰離子（ o2 - ' ）水平以及抗氧化酶系統的影響，以期探討它們與細胞耐寒性的關系。
  9. This paper discusses the surface etching of polyester thread through application of plasma and alkali deweighting to enhance the size adhesion to polyester thread and improve the abrasion - resistance of the sized polyester thread

    摘要探索了應用堿減量、低溫等離子體處理方法對滌綸股線表面進行刻蝕處理，以改善上漿前滌綸表面界面，增強漿液對滌綸股線的黏附性，提高上漿后滌綸股線的耐磨性的研究。
  10. Effect of temperature on incubation and thermal tolerance of the chinese forest frog

    溫度對中國林蛙卵孵化和孵出熱耐受性的影響
  11. Feature ： excellent adhesion, high temp resistance, good tensile strength. no staining residue, applied to be toasted many times under the environment of high temperature

    特性：有極侍的粘性，耐溫性好，抗拉強度佳保持力好、無殘膠，能在高溫環境下進行多次烘烤。
  12. Feature : excellent adhesion, high temp resistance ， good tensile strength ， no staining residue. applied to be toasted many times under the environment of high temperature

    特性：有極佳的粘性、耐溫性好、抗拉強度佳、保持力好、無殘膠，能在高溫環境下進行多次烘烤。
  13. Testing method for wear resistance of fine ceramics by ball - on - disk method at elevated temperatures

    高溫下用盤球法測定細陶瓷耐磨性的試驗方法
  14. High - temperature stress is a major constraint to higher and stable productivity and super quality of rice, there is of great theoretical and practical significance in investigating heat tolerance in rice

    摘要高溫脅迫是水稻高產、穩產、優質的一個重要限制因素，水稻高溫脅迫與耐熱性的研究具有重要的理論與實踐意義。
  15. Bond with pp high service temperature

    與pp有優良接合性能優良的耐溫性
  16. Their resistance to environmental extremes, mechanical resilience and safety features make them perfectly suited for critical applications in transportation equipment, communications and electrical enclosures, electronic products and components, industrial machinery and appliances

    硅海棉擁有卓越的防火耐溫性能，適合應用於各式惡劣的環境，是墊圈，防震墊子，熱遮蔽材料及高溫應用的理想材料。
  17. To mend small damaged holes, place a patch of pe packaging film on the hole, put and iron a second patch of heat - resisting cellophane paper or other materials on the first patch so that the hole can be sealed. to store spare membranes, it d better immerse membranes in clean water and dry them sheet by sheet

    離子膜如遇損傷有小洞時，可將此膜涼干后，修補只須用聚乙烯食品包裝袋剪一小塊覆蓋在洞口上，然後襯上耐溫性好的玻璃紙或其它材料，再用電鉻鐵燙合使之粘合即可。
  18. It is noe kind of high - qulity knot with fine lubrication, high pv value, good heat resistance and long service life, applicable to pump axle and valve shatr of all medium

    本品具有較高的pv值和很廣泛的耐溫性，用來密封所有介持和泵軸和閥桿，是一種性能穩定使用周期長的盤極。
  19. The wear rate increased with the increase of load, and it decreased with the increase of the nanosized al2o3 content. the parameters of hot - press sintering process, the temperature and the pressure, affected the wear resistance of cu - ( al2o3 ) n composite, that is, the high temperature and the high pressure had increased the wear resistance of cu - ( al2o3 ) n composite

    隨著載荷的增加，復合材料的磨損率隨之增加；復合材料的耐磨性與增強相含量有關，隨著增強相含量的增多，抗磨損性能增加；復合材料耐磨性的高低與熱壓參數有關，熱壓溫度高、熱壓壓力大，燒結好的材料的耐磨性能好。
  20. ( 2 ) the influence of content of sbs on the temperature sensitivity, performance under high temperature, anti - crack ability under low temperature, elasticity, anti - aging ability of substrate asphalt is studied. the influence of content of sbs on the water - stability, property under high temperature and anti - crack ability under low temperature of asphalt mixture is also researched. the suitable content of sbs is 6 %

    （ 2 ）研究了改性劑用量對瀝青的溫度敏感性、高溫特性、低溫抗裂性、彈性及耐久性的影響，同時研究了改性劑用量對瀝青混合料的水穩定性、高溫特性和低溫抗裂性的影響，認為6 %的sbs加入量比較適合。
分享友人
分享到 Line

分享到臉書