耐濕度 的英文怎麼說
中文拼音 [nàishīdù]
耐濕度
英文
moistureproof-
Simultaneously cross - linked and quaternized 4 - vp - co - nbuma was also investigated as humidity sensing materials and showed good linearity, high sensitivity, good high stability at high humidity and high temperature, and durability to organic solvent, etc. sensors based on 4vp - co - buma ( vp / buma = l / l ) with crosslinking and quaternization reaction of 17 hours exhibited a change of three orders of magnitude ( 104 ~ 107 ) in impedance over the range of 95 % rh ~ 30 % rh, showing high sensitivity, and little hysteresis was observed
元件具有響應線性度好，靈敏度高，濕滯小、高溫高濕穩定性好、耐無水乙醇有機溶劑性能好等優點。其中，交聯季胺化17小時配料比為1 1共聚物濕敏元件，在33 rh 95 rh濕度范圍內，阻抗變化達3個數量級（ 10 ~ 7 - 10 ~ 4 ） ，響應靈敏度高，幾乎無濕滯。Highest insulation resistance and low dielectric loss under severe humidity conditions, for use in electronic insulators, telecommunications apparatus and meters. it s also suitable for cold punching, carbon printed, and vr used
高度級電氣絕緣性，耐濕性特佳，製造電氣絕緣電子絕緣器通信及電表等配件，適于冷沖打拔加工碳膜印刷電板及vr使用電木板。The studies on the effects of temperature and soil water content for the number of oribatida and collembola were made. the results indicate that there are some effects for the number of oribatida and collembola. the difference on the most preferred temperature and soil water content for the growth of oribatida and collembola is not obvious. the preferred temperature is about 24. the preferred water content is about 16 %. the toleration on low temperature and drought for oribatida obviously is capable than that for collembola
對不同溫度和土壤含水量甲蟎和跳蟲數量的關系進行了實驗觀察.結果表明，溫度和土壤含水量對土壤甲蟎和跳蟲的數量變動均具有一定的影響.甲蟎和跳蟲生長的最適溫、濕度差異不明顯，最適溫度約在24左右，最適濕度約為16 %的含水量.甲蟎耐受低溫、乾旱環境的能力明顯大於跳蟲Abstract : in this paper, a imidazole - salt was synthsised and was used with a polyphenol compound to modify the dicyandiamide curing epoxy resin system
文摘:本文針對雙氰胺固化環氧樹脂時的固化溫度高，固化產物耐濕熱性差的缺點，利用自行合成的咪唑鹽和多羥基酚類化合物，對雙氰胺固化體系進行了改進。Smart materials and structure have definite requirements of sensor components and driving components, for example, they can adhere well to the matrix and have higher strength, fatigue strength, more broad scope of frequency response and faster response speed, etc. piezodielectric ceramics have characteristic of easily preparing, heat - resistance, wet - resistance, high strength and broad scope of frequency response, etc. furthermore, it has piezoelectric effect and inverse piezoelectric effect, namely it can produce electric potential energy when it is transformed by mechanical strength and its mechanical dimension can be transformed when voltage is put on it
壓電陶瓷能與基體材料很好結合，具有制備容易、耐熱、耐濕、強度高、頻響寬等特點，另外它具有正壓電效應和逆壓電效應，即當它受到機械力變形時，能產生電勢，對它施加電壓時，能改變其機械尺寸，因此它在智能材料結構中既能用作傳感元件又能用作驅動元件。Products function : put our “ sun shine ” brand carbon steel fiber evenly seep into concrete to form steel fiber reinforced concrete and it can decrease the thickness of reinforced concrete by half, it not only shorten the project time, save the material and manpower expense, bring distinct economic benefit, but also increase the performance of crack resistance, percussion resistance, tensile strength, bend resistance. scosspr resostamce amd wear resistance of the reinforced base materials. if the weight ratio of 2 % steel fiber seep into the concrete, it can solve the brittleness problem of the concrete, in the condition of 60 % ralative air humidity, after 21days air - dry, even 520 days air - dry, it ' s difficult to find any crack by eyesight, the bend resistance for the steel fiber concrete is 140 times stronger than the concrete without steel fiber, the capability of impact resistance increase 10 times
產品功能：將本公司「雙興」牌碳鋼纖維系列產品均勻地摻入混凝土中，形成鋼纖維增強混凝土，可使工程中鋼筋混凝土的施工厚度降低一半，不僅縮短了施工工期，節省了材料和人工費用，帶來顯著的經濟效益，且增強了基體的抗裂、抗沖擊、抗彎、抗剪、耐磨擦等性能，如摻入本公司2 %鋼纖維的混凝土，不僅解決了混凝土的脆性問題，在空氣相對濕度60 %的條件下風干21天後，甚至在風干520天，肉眼很難發現裂縫，摻入鋼纖維后的增強混凝土比不摻鋼纖維的混凝土抗彎強度提高140倍，耐沖擊荷載提高10倍。Methods of test for paints - determination of resistance to humidity intermittent condensation
塗料試驗方法.第f15部分:耐濕度測定Humidity test control for colour fastness to light
耐光色牢度試驗儀用濕度控制標樣Textiles - tests for colour fastness - part c07 : colour fastness to wet scrubbing of pigment printed textiles iso 105 - c07 : 1999 ; german version en iso 105 - c07 : 2001
紡織品.色牢度試驗.第c07部分:顏料印染紡織品耐濕擦The heat is tolerable, due to very little humidity
由於濕度很小，不會悶熱難耐。Results showed that the curing temperature of this system was come down, and the mousiture - resistance of this adhesive was improved
實驗結果表明，採用上述的方法，可以大大降低固化的起始溫度，並對固化后產物的耐濕熱性有一定的提高。Carbon fiber t300 was chosen as a co - hybrid fiber, and two different kinds uhmwpe fiber / t300 hybrid composites are prepared in both inner - laminar and inter - laminar styles. the inter - laminar hybrid composites exhibited better adhesion than the inner - laminar ones. for the optimized system dc88 / t300 / ve, the ilss reached 42. 5mpa
在混雜實驗部分，研究了纖維狀況（纖維種類、處理與未處理） 、混雜方式、含膠量等對混雜結果的影響；藉助于sem以及建立的混雜模型對混雜機理進行了分析；對混雜復合材料進行了密度和耐濕熱性測試。The paper studied withstand voltage level, influence factors, breakdown process and breakdown mechanism of covered with snow or ice through some theory calculation results, many test data and phenomena. the paper got the conclusions that withstand voltage strength of insulator covered with snow or ice descended largely, and the amount of ice or snow build - up, number of flashover, string length, environment temperature and leak current etc had obvious effects on flashover voltage values of insulators
通過大量的試驗數據和現象研究冰雪條件下絕緣子的耐壓水平、影響因素及其擊穿機理，如串長的影響、環境溫度、絕緣子形狀及冰的干濕程度、閃絡次數、冠雪量和積冰量的影響、雪的密度、氣壓和濕度的影響等，並對試驗結果與理論分析結果進行了對比，分析其是否一致。Standard test method for elevated temperature and humidity resistance of vapor retarders for insulation
隔熱用蒸汽緩凝劑耐高溫和耐濕度性能標準試驗方法Paints and varnishes - determination of resistance to humidity - continuous condensation
塗料和清漆.耐濕度的測定.連續冷凝法Aerospace series - cables, electrical, aircraft use - test methods - humidity resistance
航空航天系列.飛行器用電纜.試驗方法.耐濕度Iso paints and varnishes - determination of resistance to humidity - part 1 : continuous condensation iso 6270 - 1 : 1998 ; german version en iso 6270 - 1 : 2001
塗料和清漆.耐濕度的測定.第1部分:連續冷凝作用Road vehicles - safety glazing materials - test methods for resistance to radiation, high temperature, humidity, fire and simulated weathering iso 3917 : 1999
道路車輛.安全玻璃材料.耐輻射耐高溫耐濕度耐Specification for synthetic rubber heat - and moisture - resisting insulation for wire and cable, 75 deg c operation
工作溫度為75的電線和電纜用合成橡膠耐熱和耐濕絕緣性規范The results showed that the modified epoxy resin was satisfied, and can stick well to constantan alloy. the tests of resistance to hydrothermal ageing showed that the adhesive has excellent resistance to weathering
90剝離實驗結果顯示，膠粘劑與康銅箔材具有很高的膠結強度，並具有良好的耐濕熱老化性能。分享友人