耗散熱 的英文怎麼說

中文拼音 [hàosǎnrè]
耗散熱 英文
burn-off
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 散熱 : heat radiation; radiating; thermolysis; abstract heat; heat dissipation; cooling散熱風門 throttle...
  1. On the basis of expound the theory of building exterior - protected construction energy consumption and the gene of influence the building energy, set up mathematics model, this article discuss the mechanism of dispelling the heat of the buildings " thermal bridge and the complication that influence it, and then synthetic analysis and calculate the influence range of building thermal bridge in exterior - protected construction column thermal bridge to the building outer wall get the conclusion that when the construction column can satisfy the building stress - area, in bulgy construction column dispel less heating than out bulgy construction column. but if the pole stuck out more than 100mm, in bulgy or out bulgy make no difference

    本文在闡述建築圍護結構耗熱原理以及影響建築能耗因子的基礎上，採用數值模擬方法，探討了建築熱橋傳熱的基本機理和影響建築熱橋傳熱的因素，進而對建築熱橋在圍護結構傳熱中的影響范圍進行了綜合分析和計算，研究了構造柱熱橋型式對建築外墻能耗的影響，得出了構造柱在滿足建築受力面積要求的情況下，內凸構造柱較外凸構造柱略能減少散熱量的結論，但是凸出過大（ 100mm ）無論內凸還是外凸對建築耗熱都沒有大的差別。
  2. Aimed at the high temperature at furnace roof and wall, great lost of body heat radiation, poor leading heating ability and long soaking time, the compound ceramic fiber coating is used to hold temperature of furnace roof and wall, make the heating loss dropped, shorten soaking time, improve heating ability and reduce evergy consumption

    摘要針對環形爐爐頂爐墻表面溫度高、爐體散熱損失大、導致加熱能力低、待溫時間偏長的問題，選用了復合陶瓷纖維保溫塗料，使爐體散熱損失減少，待溫時間縮短，加熱能力提高，且能耗降低。
  3. This paper introduces that the diffuse heat heating furnace is reduced the consumption of fuel is debased and the preferable effect is got, using the multicrystal mullite fibrous stickup lump to heat preservation in heating furnace wall

    摘要採用多晶莫來石纖維貼面塊對加熱爐爐內壁保溫，減少了爐體的散熱損失，降低了爐子燃耗，取得了較好的效果。
  4. This experiment focuses on the characteristic of green refrigerant r600a in a small parallel flow aluminum closed two - phase thermosiphon and measures all the quantity of injected mass and heat dissipation, the speed of air and the difference of temperature of the electronic element ( cpu simulate chip ) surface and environment

    處理速度達到g數量級，功率消耗更達幾十瓦。如何解決cpu散熱問題，成為關注的焦點。本實驗首次研究了綠色環保工質r600a在一種鋁質重力熱管中的工作特性。
  5. It will provide us to further study the function of xanthophyll cycle in photoprotection. the major results are as following : two cdna sequences encoding violaxanthin de - epoxidase were cloned from japonica rice ( jrvde ) and indica rice ( irvde ) with the full - length of 1887bp and 1647bp, respectively. the homology of the open reading frame is 98 % identity between two rvde genes, and more than 60 % identities with those of other species

    本論文從水稻和菠菜中克隆了編碼vde酶的基因，並通過轉基因植物進一步研究了葉黃素循環在熱耗散方面的作用，主要獲得了以下結果：首次從兩個水稻亞種（秈稻和粳稻）中克隆了rvde基因（分別命名為irvde和jrvde ）的全長cdna序列，分別長1647bp和1887bp ，兩者開放閱讀框的同源性為98 ，與其它已知vde基因的同源性在60以上。
  6. Xanthophyli cycle has been widely concerned since the finding that it has the function in heat dissipation. with the trans - thylakoid ph gradient, zeaxanthin ( z ) together with antheraxanthin ( a ) can absorb excess energy from chlorophyll and release it as heat, thus protect the photosynthetic apparatus from photodamage by high light. violaxathin de - epoxidase ( vde ) is the key enzyme in xanthophylls cycle

    目前普遍認為葉黃素循環的色素定位於天線色素蛋白復合體上，在跨膜質子梯度（ ph ）形成后，玉米黃質（ z ）和環氧玉米黃質（ a ）能夠從葉綠素中吸收過多的激發能，並以熱能的形式耗散到體外，從而保護光合器官免受強光的破壞。
  7. The average pmv value indoor by ceiling heating is higher than the other two be used for room heating under same energy consumption, and the vertical distribution of indoor temperature results by either of the method in a heating room is different from that in a closed room

    頂棚輻射供暖墻體具有一定蓄熱能力，使其節能性優于散熱器供暖和熱風供暖。在相同的能耗條件下，輻射供暖比散熱器供暖和熱風供暖的pmv值要高。
  8. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能耗加大，頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同，形成的室內熱環境特徵不同，通風換氣時產生的通風熱損失也有所區別，為了提高大換氣量房間的供暖節能效果，必須對不同供暖方式在大換氣量情況下的熱舒適性與節能效應進行研究。
  9. Experimental study of measurement for dissipation rate scaling exponent in heated wall turbulence

    壁面加熱湍流耗散率標度指數測量的實驗研究
  10. While the benefits of overheating are specific to the module, the cost ? heat buildup ? is cumulative to the rack that the module resides in, which has a fixed heat dissipation rate

    過熱的副作用具體到模塊（裝備） ，熱量的消耗、產生和堆積在機架的內部有一個固定的散熱率。
  11. And the results of calculation and numerical simulation indicate, without increasing the intrinsic collector - junction area of power devices, collector - combed structure helps to raise the intrinsic heat - dissipating area and base ' s perimeter, improve heat - dissipating method of each cell of the chip, enhance the distribution uniformity of junction temperature and current of each cell of the chip, reduce the thermal resistance and raise the dissipation power pd and output power p0, fairly well relax the contradiction among frequency, out - put power and dissipation power of the devices, and further improve the devices " property against second breakdown

    而計算分析和二維數值模擬分析結果表明：梳狀集電結（基區）結構在不增加器件本徵集電結面積的條件下，增大了器件的本徵散熱面積和基區周長，改進了每個子器件單元內的散熱方式，提高了單元內結溫和電流分佈的均勻性，降低了器件的熱阻，增大了器件的耗散功率和輸出功率，較好地緩解了目前傳統結構中頻率與功率、功耗的矛盾，並有利於改善器件抗二次擊穿的性能。
  12. The temperature rises and the dc voltage are proportional to the power dissipated, which is equal to the power of the source being measured if the input impedance is suitably matched to the source impedance

    熱偶冷熱結之間的溫度差和熱電勢均正比于耗散在ta2n電阻上的微波功率，如果熱偶的工作電阻與同軸傳輸系統電阻匹配適當，該功率就等於被測源的功率。
  13. The type of packages and the methods in which it is possible to mount the finished semiconductor chip ( depending on factors such as heat dissipation, size, etc. )

    封裝的類型和方法（它們取決于熱耗散和尺寸大小等因素） ，用此種方式即可安置經過精製的半導體晶元。
  14. Especially, the locus of photoinhibition and its expression, its causes, possible manners and functions of thermal dissipation in photoinhibition were introduced in detail

    由於葉黃素循環在水稻耐光抑制、增加熱耗散中起著十分重要的作用，也總結了葉黃素循環的功能。
  15. The calculations axe based on the equation of current motion with temperature and field - dependent critical current density, and the heat dissipation produced by flux motion in the normal state region and the superconducting state region

    此計算基於電流運動方程，考慮到電流密度是溫度和磁場的函數，考慮到在正常區和超導區由磁通運動產生的熱耗散。
  16. The photosynthetic characters of super - high - yield rice ( oryza sativa ), its photoinhibition and genetic law of photosynthetic traits and screening of high photosynthetic efficiency materials etc. were reviewed in this paper

    摘要綜述了超高產水稻的光合特性、光抑制、光合性狀的遺傳規律和高光效材料的篩選等內容，比較詳細地介紹了光抑制部位及其表現，光抑制的原因以及光抑制中熱耗散的可能途徑及作用等。
  17. Abstract : the affects of crystal absorption for heat radiation on crystal growth, which include : the heat loss of the hot grower, the chara - cteristic of temperature - time of crystal growth, the pattern of fluid flow and the shape of interface, the interface inversion of crystal, the temperature distribution and the thermal stress distribution, are reviewed in this paper

    文摘:本文綜述了晶體對熔體熱輻射吸收對晶體生長的影響，包括對熱腔熱耗散的影響；對晶體生長溫度時間特性的影響；對液流形態和固液界面形狀的影響；對晶體界面反轉的影響；對晶體中溫度分佈和應力分佈的影響。
  18. Owing to having the advantages of large size, good thermal conductivity, high precision of manufacturing and assembling, the all - metal slow - wave structures are widely used in the wide - band, high power traveling wave tube ( twt ) and relativistic twt. furthermore, the disc - loaded cylindrical waveguide is one of the most important slow - wave structures in the all - metal slow - wave structures ( sws )

    全金屬慢波結構因其尺寸大、熱耗散能力強、整體性能好等優點被廣泛應用於寬帶、大功率行波管和相對論行波管中，而膜片加載慢波系統正是全金屬結構中最重要、應用最廣泛的一大類結構。
  19. The two basic theories of non - equilibrium thermodynamics, the minimum entropy production and the dissipative structure, are introduced. it will be shown that, by using the relationship between the entropy production and the rate of energy dissipation, the minimum entropy production is equivalent to the minimum rate of energy dissipation

    本文首先介紹了非平衡態熱力學的兩個基本理論?最小熵產生原理和耗散結構理論，並根據熵產生與能耗率關系，得出最小熵產生原理與最小能耗率原理二者等價的推論。
  20. It possesses not only the self - learning ability and adaptability, but also the function of self - adjusting factors. based on fuzzy set, neural network theory, the fuzzy control model and fuzzy neural network control model of multi variable system are presented. based on the automatic core - welding line of shop floor control system in yangzhou radiator plant computer integrated manufacturing system ( ys - cims / sfcs ), the fuzzy logic theory was applied to the controlling device and established the main heating room fuzzy temperature controller and finally was put into practical use

    本文採用了基於神經網路技術的智能pid控制策略，設計了一類具有自學習和自調整比例因子功能的神經元網路自適應pid控制器的結構及演算法；為解決結構不確定性的復雜多變量系統的控制，基於模糊集及模糊系統、神經網路理論，建立了多變量系統的模糊控制模型及模糊神經網路控制模型；針對揚州水箱廠計算機集成製造系統車間管理與控制系統（ ys - cims sfcs ）中的實際工程問題，設計和開發了散熱器芯子烘焊自動線主烘腔溫度模糊控制器，解決了生產中長期存在的老大難問題，提高了產品質量，降低了單產能耗。
分享友人
分享到 Line

分享到臉書