聚硅氧 的英文怎麼說

中文拼音 [jùguīyǎng]
聚硅氧 英文
polysiloxane
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 硅 : 名詞[化學] silicon （14號元素符號 si）
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  1. Mechanistic study of the hydrolytic oligomerization of - aminopropyltriethyoxysilane and characterization of the products

    氨丙基倍半硅氧烷的水解聚合機理研究及產物結構表徵
  2. With regard to the protection system of inorganic zinc - rich primer + epoxy micaceous iron oxide intermediate + polysiloxane finish having been used for major bridges for the first time and the anti - rust and anti - slip inorganic zinc - rich coating used for the bolted and welded surfaces of the bridges, the paper describes the protection system and coating workmanship in considerable details from aspects of the material properties, construction methods and coating inspection

    針對在大型橋樑上首次應用的「無機富鋅底漆環氧雲鐵中間漆聚硅氧烷面漆」的防腐體系和栓接面採用的無機富鋅防銹防滑塗料，從材料特性、施工方法及塗層檢驗等幾方面做了較詳細的論述。
  3. Polyurethane aqueous dispersions modified with siloxanes

    硅氧烷改性聚氨酯水分散液
  4. Using the semi - batch synthesis techniques, a grafting reaction mechanism is adopted to prepare a core - shell composite latex of siloxane / acrylate based copolymer

    利用接枝反應和種子溶脹半連續滴加技術合成了聚有機硅氧烷聚丙烯酸酯復合乳液。
  5. The experimental results further demonstrate that the combination of incompatibility polydimethylsiloxane and polyacrylate by co - vulcanization improves the both compatibility and broadens the low temperature and high temperature functional region. while in sin, to improve microphase structures and damping properties, the design to increase compatibility between two compositions and modulate crosslinking density as well as relative reaction rate of two compositions, is also effective

    以上實驗結果表明，在復合橡膠阻尼材料中將聚硅氧烷與聚丙烯酸酯通過共混硫化相結合，改進了二者的相容性，拓寬了其阻尼功能區的低溫和高溫溫域；而在sin中通過改善組四川大學博士學位論文分間相容性，調節交聯密度控制其微相結構和兩種組分相對反應速度的快慢，進而控制材料阻尼性能的設計是行之有效的。
  6. Abstract : by modifing epoxy resin with functional polysiloxane, the reduction of the internal stress of encapsulant made from polysiloxane - modified epoxy was realized. the thermal and mechanical properties of the modified epoxy encapsulant were introduced

    文摘:綜述了用功能性聚硅氧烷對環氧樹脂封裝料進行改性從而實現環氧封裝料低應力化的幾種方法；並對改性后封裝料的結構、熱性能和機械性能作了詳細介紹。
  7. At the same time, especially in air two peaks turned little and became a continuous process at low heating rate ( 5 c / min ). the residue was 15 % in air compared to 3 % in n2, because pdms turned into sio2 of solid state in air, but ds of gas state in na

    發現在氮氣氣氛中的殘留物重為3 ，而在空氣下為15 ，這是因為聚硅氧烷在氮氣中分解成環三硅氧烷揮發了，而在空氣中形sio _ 2 。
  8. Zss920 is a two - component, high - solid, high - gloss, polysiloxane enamel with excellent gloss and colour retention

    Zss920是一種雙組分、高固含、高光澤的聚硅氧烷面漆，具有非常優異的保色保光性。
  9. Using the dynamic mechanical analyzer ( dma ), pdms / pma ipn was investigated at temperature of 5 - 180 c. the initiator, the component ratio, the type of pdms and the filler effected the damping properties. the result showed that the damping ability varied with the parameter and there was an optimal value. the excellent damping material in the papers was ipn, where tan man was 0. 735, and the damping functional temperature ranged with tan 8 > 0. 3 was 46 c. the micro - morphology and structure of pdms / pma ipn were characterized by two kinds of sem

    高分子阻尼材料的有效阻尼功能區是在ipn材料的t _ g區間內，而研究常溫條件下的阻尼性能更具有重要應用價值，運用動態熱機械分析（ dma ）儀對ipn阻尼材料進行表徵，在5 180內對其損耗因子（ tan ）進行研究，發現引發劑和交聯劑的用量、聚硅氧烷的用量和分子量等參數對ipn阻尼性能的影響較大，存在一個合理配比值，當pma與粘度為3300pa ? s的pdms之比（質量比）為1 . 17 ： 1 、交聯劑用量為1時， tan最大值為0 . 735 ，大於0 . 3的溫域差達到46 。
  10. Abstract : the synthesis, molecular structure and modification of amino modified polysiloxane, a softening agent for textile, are summarized, and softening agent of different structure are also describe briefly

    文摘:綜述了以氨基改性聚硅氧烷為主的織物用柔軟劑的合成、分子結構及進一步的改性。
  11. Study on synthesis and particle size of polysiloxane modified polyurethane latex

    聚硅氧烷改性聚氨酯的合成及乳液粒徑的研究
  12. Results of study show that inception voltage of electrical tree, breakdown voltage, environmental stress cracking, tensile strength and elongation at break of low density polyethylene are improved after grafting

    研究結果表明：接枝聚硅氧烷后，改性的低密度聚乙烯的樹枝引發示性電壓、擊穿場強、耐環境應力開裂性、拉伸強度及斷裂伸長率都得到提高。
  13. In this paper, interpenetrating polymer networks ( ipn ) based on polysiloxane ( pdms ) and poly ( methyl acrylate ) ( pma ) were prepared by using ma monomer and two types of pdms, which viscosities were 3300pa s and 7000pa s respectively. pdms was crosslmked by tetraethyl orthosilicate

    本論文制備了聚二甲基硅氧烷與聚丙烯酸甲酯的序列半互穿聚合物網路，其中聚硅氧烷為交聯結構，採用粘度分別為3300pa ? s和7000pa ? s兩個品種，聚丙烯酸甲酯為線性聚合物。
  14. Synthesis and characteries of side - chain liquid crystalline - polymethylhydrosiloxane containing two mesogenic units

    側鏈含有兩種介晶基元的聚硅氧烷類液晶聚合物的制備與性能
  15. Separation properties of a new polysiloxane - anchored - cyclodextrin derivative as gas chromatography stationary phase

    一種新的環糊精接枝聚硅氧烷毛細管氣相色譜固定相的分離性能
  16. Synthesis and hemocompatibility of liquid crystalline polysiloxane with cholesterol in side chain

    膽固醇改性聚硅氧烷的合成和血液相容性
  17. This product which is odourless, safe and concentrated, can offer you the best convenience and prolong the using lifetime of machine

    本品是濃縮乳聚硅氧烷乳劑，對消除各類清洗機械操作中所產生的泡沫有良好的效果，並能延長機械使用壽命。
  18. Organosilicon polymer ( silicone ) has the potential application in many industry areas as new material owing to its excellent properties

    摘要以聚硅氧烷為基礎的有機硅材料作為一種新型材料，具有特殊的物理化學性能，在許多工業領域中得到了廣泛應用。
  19. The vulcanization reaction of the ipn and pdms was determined by the fourier transform infrared ( ft - ir ). the mechanism of the vulcanization did ' t change, no chemical reaction between the ma and the pdms appeared

    紅外光譜儀對聚硅氧烷和ipn固化前後的化學結構的分析表明，反應按照各自機理進行，丙烯酸甲酯與聚硅氧烷之間沒有發生化學反應，說明反應具備ipn形成的基本條件。
  20. In terms of some unique idea, a series of novel damping materials based on polydimethylsiloxane / polyacrylate, with a gradually broadened damping function region, have been successfully prepared by using five technique approaches

    依據創新性的構思，圍繞著制備寬溫寬頻阻尼材料，本文採用五條技術路線，成功地制備出一系列阻尼功能區逐漸拓寬的聚硅氧烷聚丙烯酸酯新型阻尼材料。
分享友人
分享到 Line

分享到臉書