聚苯乙烯 的英文怎麼說

中文拼音 [běn]
聚苯乙烯 英文
polystyrene; verelite; polystyrol (高頻絕緣材料); dylene; bextrene聚苯乙烯薄膜 polystyrene film; plasticon; 聚苯乙烯 (絕緣)電纜 polystyrene cable; 聚苯乙烯電容器 polystyrene capacitor; 聚苯乙烯漆 polystyrene varnish; 聚苯乙烯軟電纜 [訊] styroflex cable; 聚苯乙烯樹脂 polystyrene resin; styrol resins
  • : 動詞(聚集; 聚積) assemble; gather; get together
  • : 名詞[化學] (有機化合物的一類) alkene; olefince
  1. Study on waste polystyrene emulsion grafted with acrylic acid

    酸接枝改性廢聚苯乙烯乳液的研究
  2. Xps foamed board, has a perfect closed - pore alveolate structure

    Xps擠出聚苯乙烯發泡板材,具有完美的閉孔蜂窩狀結構。
  3. Carboxylated polystyrene resin

    羧化聚苯乙烯樹脂
  4. Chiral quaternary ammonium salts were synthesized from cinchonine in cinchona alkaloids using chloromethylated polystyrene - polyethylene glycol, diethylene glycol, triethylene glycol and glycol as polymer - supported phase transfer catalysts, finsl products were characterized by ftir, elemental analysis, scanning electron microscopy, x - ray photoelectron spectroscopy ( xps )

    摘要以金雞納生物堿中的辛可寧為原料,氯甲基化聚苯乙烯二醇、一縮二二醇、二縮三二醇、二醇等為載體合成了幾種合物負載的手性季銨鹽,並對它們的結構用紅外光譜、元素分析、掃描電鏡和x射線光電子能譜等測試手段進行了表徵。
  5. Crystallization behavior of single or pauci chain congeries of isotactic polystyrene

    單鏈和寡鏈等規聚苯乙烯集體的結晶行為
  6. Phenolic foam is a new generation heat preservation prevent fire soundproof material and polystyrene together ammonia ester foaming rubber etc, material to compare, and it is good that its biggest characteristics is a heat - proofound the low temperature contractility is smatt, and have te special prevent burning wit the size stability under 2000 heat, not burning, not melt not contract constant form not poisonous spirit hove no thick smoke, just surface formation layer

    信息內容:酚醛泡沫為新一代保溫防火隔音材料與聚苯乙烯氨脂發泡橡膠比,其最大特點是耐熱性好,低溫收縮性小,具有獨特的阻燃和尺寸穩定性,在焊槍火焰下,不燃燒不收縮不變形,無毒氣無濃煙,只是表面炭化,性質穩定,耐化學腐蝕抗老化。
  7. The thermodynamic free energy on mixing and the spinodal equation in ternary homopolymer blends were obtained by making plausible approximation based on flory ' s equation of state theory. because of the non - linear behavior of the spinodal equation, a numerical solution approach was used and succeeded in solving the problem. spinodal of polystyrene ( ps ) / poly ( vinyl methyl ether ) ( pvme ) / poly ( 2, 6 - dimethyl - 1, 4 - phenylene oxide ) ( ppe ) were simulated over a wide temperature range and the calculated result was coincidence with that of the literature

    將上述方法用於已知狀態方程參數的二元均共混體系聚苯乙烯( ps ) /甲基基醚( pvme ) ,三元均共混體系聚苯乙烯( ps ) /甲基基醚( pvme ) /2 , 6 -二甲基1 , 4 -撐氧( ppe ) ,得到一系列不同溫度下的spinodal相圖,預測結果與文獻報道吻合,在此基礎上進一步研究了合物的分子量對體系相行為的影響。
  8. Waterproof paints from waste polystyrene foam plastics

    聚苯乙烯制取塗料的研究
  9. Firstly, the surface characteristic of polystyrene particle is changed from water detesting to water intimity by using special techniques and admixtures so mat the compound quality with inorganic materials is insured. secondly, the contradiction between the weight and strength is solved through optimizing the particle size and using composite fiber and the best heat conductivity is achieved under the condition that the necessary strength is met. in the research process, the author solved the problem of fiber dispersing in insulating materials so that the contraction of the material is controlled

    課題研究中,首先採用特殊的改性工藝及外加劑實現對聚苯乙烯顆粒表面的成功改性,使其表面由憎水轉化為完全親水,確保與無機材料的復合質量;其次,通過採用優化骨料級配及使用復合纖維等措施解決了保溫材料的輕質與強度的矛盾,使保溫材料在滿足必要的強度的前提下,導熱系數降至最小;並且,課題研究中成功解決了纖維在保溫材料中均勻分散的問題,達到了抑制保溫材料收縮的目的;最後,通過採用復合外加劑、合適的膠凝材料及合理的配比等措施確保該保溫材料具有良好的和易性,滿足施工的要求。
  10. Initial study on the preparation of microencapsulated osmium tetraoxide from gpps

    通用聚苯乙烯制備四氧化鋨微膠囊的初步研究
  11. The sensor exhibits a linear response to c3 in the concentration range 6. 5ng / ml to 75ng / ml, correlation coefficient 0. 973. 4 ) a novel enzyme - link fluoroimmunoassay system using 2 - chloro - 10 - [ 3 - ( 4 - methyl - l - piperazinyl ) propyl ] 10h - phenothiazine ( prochlorperazine ) as substrate to determine the goat anti - igg was developed by using polystyrene ( ps ) as carrier. the hrp - labled goat anti - igg can catalyze the oxidation of prochlorperazine to cause the increasing of fluorescence

    4 )以聚苯乙烯( ps )製成史持體,通過疏水性非特異吸附將igg固定在其表面,然後與gaigg和酶標gaigg進行競爭免疫反應,以雙氧水和甲哌氯丙嗪混合溶液為熒光底液,通過測定395nm處熒光增強的多少來測定gaigg的濃度,熒光響應與gaigg濃度在2n留ml到60n留ml之間呈準線性關系。
  12. Gypsum plaster boards with polystyrene or polyurethane rigid foam as insulating material

    聚苯乙烯醋酯硬質泡沫作絕緣材料的石膏灰粉夾
  13. Polystyrene and polypropylene are the two plastic materials generally used for battery parts.

    聚苯乙烯是一般用於電池部件的兩種塑料。
  14. Different grades of crystal polystyrene molding pellets range from 150, 000 to 350, 000 weight average molecular weight.

    不同牌號的結晶聚苯乙烯模塑粒料平均分子量范圍從150,000-350,000。
  15. Moulded polystyrene foam board for thermal insulation

    絕熱用模塑聚苯乙烯泡沫塑料
  16. Cellular plastics. polystyrene foam for thermal insulation

    隔熱用聚苯乙烯泡沫塑料
  17. Specification for toughened polystyrene for sheet extrusion

    板材擠壓用韌化聚苯乙烯規范
  18. Study on making adhesives from waste polystyrene foam

    聚苯乙烯泡沫塑料制取塗料及膠粘劑
  19. Preparing cementing agent by using the waste polystyrene foam

    用廢聚苯乙烯泡沫制備膠粘劑
  20. On the preparation of coatings from waste polystyrene

    聚苯乙烯泡沫塑料回收制備塗料的研究
分享友人