聯丙烯 的英文怎麼說

中文拼音 [liánbǐngxī]
聯丙烯 英文
bipropenyl
  • 聯 : Ⅰ動詞（聯結; 聯合） unite; join Ⅱ名詞（對聯） antithetical couplet
  • 丙 : Ⅰ名詞1. （天乾的第三位） the third of the ten heavenly stems2. （姓氏） a surname Ⅱ數詞（第三） third
  • 烯 : 名詞[化學] （有機化合物的一類） alkene; olefince
  1. Calciferous salt is ideal coagulants which decrease the electric potential. the experiment also showed a new method to treat the coal dressing wastewater by using calcium cinder carbide and pam together

    通過對各種降低動電電位的混凝劑的測試，得出鈣鹽是較理想的混凝劑，並確定了電石渣與聚丙烯酰胺聯用治理煤泥水的最新方法。
  2. Chemical transformation is one of the methods for the preparation of nonaqueous dispersion. in order to meet the need of practical work in conservation, we managed to transform room - temperature self - curing acrylics latex to nad. the transformed material can be used in the conservation of culture relics

    採用化學轉化法將水乳液轉化為非水乳液是制備非水分散體的一種方法。根據實際需要，將常溫自交聯丙烯酸樹脂乳液轉化為非水分散體，這種材料可用於文物保護工作。
  3. The main results of this work are summarized as follows : 1. for the first time, biomimetic bulk acoustic wave ( baw ) sensors based on the molecularly imprinted polymers ( mips ) were fabricated and applied to the determination of phenobarbital and pyrimethamine in organic and aqueous solution, respectively

    採用非共價印跡技術以-甲基丙烯酸為功能性單體、乙二醇二甲基丙烯酸酯為交聯劑首次制備了液相分子印跡體聲波仿生傳感器，並分別在有機相和水相中測定了藥物苯巴比妥和乙胺嘧啶。
  4. And the adsorbability of this novel adso rbent for ldl was determined. in order to prepare the solid supports in accordance with with the request of adsorbent for ldl, paam beads were synthesized by inverse suspension polymerization. the composition of the polymerization system is shown as follows : the concentration of monomer and dispersant are 12 % and 0. 65 % respectively, the volume ratio of oil / water isl : 3, the mole ratio of aam and mba is 18 : 1

    本文用反相懸浮聚合法合成符合ldl吸附劑載體要求的聚丙烯酰胺微珠，經實驗篩選出反應體系所需的最佳單體濃度（ 12 ） 、最佳分散劑用量（ 0 . 65 ） 、最佳油水比值（ 1 ： 3 ） 、最佳單體（ aam ）與交聯劑（ mba ）的物質的量之比（ 18 ： 1 ） 。
  5. The experimental results further demonstrate that the combination of incompatibility polydimethylsiloxane and polyacrylate by co - vulcanization improves the both compatibility and broadens the low temperature and high temperature functional region. while in sin, to improve microphase structures and damping properties, the design to increase compatibility between two compositions and modulate crosslinking density as well as relative reaction rate of two compositions, is also effective

    以上實驗結果表明，在復合橡膠阻尼材料中將聚硅氧烷與聚丙烯酸酯通過共混硫化相結合，改進了二者的相容性，拓寬了其阻尼功能區的低溫和高溫溫域；而在sin中通過改善組四川大學博士學位論文分間相容性，調節交聯密度控制其微相結構和兩種組分相對反應速度的快慢，進而控制材料阻尼性能的設計是行之有效的。
  6. We selected styrene as monomer, diethylene glycol dimethacrylate as cross - linking agent. the copolymerization technique was used in preparing the probe. the ph fluorescent indicator was immobilized in the probe as the sensitive element

    我們選擇苯乙烯為聚合單體，雙甲基丙烯酸一縮二乙二醇酯為交聯劑，採用交聯共聚技術制備氨多孔塑料傳感探頭，並將ph熒光指示劑固定於共聚體中作為氨的敏感元素。
  7. The results indicated that montmorillonite was intercalated by polyacrylic acid molecular. section two : preparation of polyacrylic acid / acrylamide / montmorillonite ( paa / am / mmt ) water absorbent hybrid by aqueous solution intercalated polymerization high water absorbent polyacrylate copolymer was prepared by aqueous solution intercalated copolymerization. in this reaction, the monomers were the partially neutralized acrylic acid ( aa ) and acryl amide ( am ) ; the cross - linking agent was diacryl ethylene ( egda )

    第二節溶液插層共聚制備聚丙烯酸鹽/丙烯酰胺/膨潤土雜化吸水材料及其性能研究首次利用溶液插層共聚制備了二丙烯酰基乙二醇酯（ egda ）交聯的聚丙烯酸鹽/丙烯酰胺/膨潤土（ paa / am / mmt ）雜化吸水材料。
  8. In the second part, we studied the plastic porous probe for ammonia measurement, which was made by methyl methylacrylate. we selected methyl methylacryte ( mma ) as the monomer, diethylene glycol dimethacrylate ( dgdm ) as cross - linking agent and toluene as the inert solvent. the probe was prepared by a copolymerization technique

    第二部分為以甲基丙烯酸甲酯為單體的多孔塑料光纖傳感探頭的研究，在這一部分里，我們以甲基丙烯酸甲酯為單體，雙甲基丙烯酸一縮二乙二醇酯為交聯劑，以甲苯為致孔劑，採用交聯共聚技術制備氨多孔塑料光纖傳感探頭，並將ph熒光指示劑藻紅固定於共聚體中。
  9. Research on preparation and crosslinking structure of semi - ipn copolymethaerylate fibers

    半互穿網路共聚甲基丙烯酸酯纖維制備及其交聯結構研究
  10. Study on dispersion morphology and mechanism of decanedioic acid in acrylic powder coating

    丙烯酸粉末塗料中交聯劑的分散形態及機理的研究
  11. Abstract : the property of silk fabric grafted ( cross - linked ) with hydroxypropyl methacrylate and protein at different rate of weigh gain, by measuring strength and elongation at break, dyeability, elastic, moisturecontent, whiteness, permeability of gas, ir and x - ray diffraction diagrams was studied

    文摘:通過對織物的拉伸特性、吸濕性、彈性、染色性、白度、透氣性、紅外和x射線衍射的研究，探討了在不同增重率條件下甲基丙烯酸羥丙酯在絲蛋白存在下與真絲綢接枝交聯后的結構及其特性的影響。
  12. In this paper, the method of rubber regeneration to modify the grt was investigated in order to decrease the crosslink density of ground rubber tyre ( grt ) and try to improving the interfacial contact state between grt and waste polypropylene ( wpp ), mechanism of proton - transfer devulcanization was studied in the first time

    本文研究了兩類再生劑de - link和乙撐胺對廢膠粉（ grt ）的改性效果，來適當降低膠粉的交聯度並試圖改善其與廢聚丙烯（ wpp ）之間的界面接觸情況，並首次對質子轉移法脫硫的機理進行了探討。
  13. Through the research on the crystallite of the composites modified with silicone coupling agent and pp - g - mah, research showed that the size of the crystallite and oriented crystallization had obviously influence on the mechanical performances. the sem results showed that nano - sio2 was dispersed well in pp, which promoted the matrix undergo shear yielding rather than brittle fracture

    通過對硅烷偶聯劑?馬來酸酐接枝聚丙烯共聚物作為界面改性劑改性pp微晶的研究，表明微晶尺寸變化與復合材料的力學性能有關；在界面附近形成擇優取向的結晶層，促使基體發生屈服變形，提高了復合材料的韌性。
  14. Both of water and soil dissolution rates of sapcus decreased obviously along with the increase of sap coating rate

    聚丙烯酰胺型高吸水性樹脂包膜尿素控緩釋效果好於交聯聚丙烯酸鹽型高吸水性樹脂包膜尿素。
  15. Synthesis of main chain helical poly 2 - a - methylacryloxy - 2 - methoxy - 1, 1 - binaphthyl

    主鏈螺旋聚甲基丙烯酸聯萘酚單甲醚酯的合成
  16. Results show that self - crosslinkable latex at room temperature with high elasticity can be prepared when amount of butyl acrylate is 60 %, and amount of methyl methacrylate is 40 %, and mass ratio of nonionic emulsifier to anionic emulsifer is 3 : 1, and amount of initiator is 0. 6 %, and amount of self - crosslinkable monomer and protective colloid is 2 % and 0. 4 % respectively

    研究結果表明：當丙烯酸丁酯的質量為60 % ，甲基丙烯酸甲酯的質量為40 % ，非離子乳化劑和陰離子乳化劑的質量配比為3 : 1 ，引發劑的質量為0 . 6 % ，自交聯單體的質量為2 % ，保護膠體的質量為0 . 4 %時，可以制備出高彈性自交聯乳液。
  17. The bp neural network was employed to analyze the relationship between the crosslinking monomers and crosslinking degree

    運用bp神經網路對交聯單體三乙二醇二丙烯酸酯、甲基丙烯酸縮水甘油酯、十一烯酸用量與交聯度的關系進行了分析。
  18. Pressure - sensitive adhesive tapes for electrical purposes - part 3 : specifications for individual materials - sheet 2 : polyester film tapes with rubber thermosetting or acrylic crosslinked adhesives

    電工用壓敏粘帶.第3部分:單項材料規范.第2活頁:用熱固橡膠或交聯丙烯粘合的聚酯薄膜帶
  19. Through multi - factor orthogonal experiment, wood fiber / plastic composite was manufactured to study the effects of polypropylene content on properties of wood fiber / plastic composite by using wood fiber and recycled polypropylene ( pp ) and mdi or ma as coupling agent

    摘要通過正交試驗，以木材纖維和廢舊聚丙烯塑料為原料，異氰酸酯或馬來酸酐作偶聯劑，壓制木材纖維聚丙烯復合材料，研究聚丙烯（簡稱pp ）用量對木塑復合材料性能的影響。
  20. Manufacture of several room - temperature self - curing non - aqueous acrylic dispersions manufacture of several room - temperature self - curing

    幾種常溫自交聯丙烯酸樹脂非水分散體的制備
分享友人
分享到 Line

分享到臉書