聲源級 的英文怎麼說

中文拼音 [shēngyuán]
聲源級 英文
acoustic source level
  • : 名詞1. (水流起頭的地方) source (of a river); fountainhead 2. (來源) source; cause 3. (姓氏) a surname
  • : Ⅰ名詞1 (等級) level; rank; grade 2 (年級) any of the yearly divisions of a school course; gra...
  1. Verification regulation of standard ultrasonic sources for milliwatt level

    毫瓦標準超檢定規程
  2. Ultrasonic sources at milliwatt levels

    毫瓦
  3. Acoustics - determination of sound power levels of noise soures - engineering methods for small, movable sources in reverberant field - part 1 : comparsion method for hard - walled test rooms

    壓法測定噪功率混響場中小型可移動工程法第1部分:硬壁測試室比較法
  4. Acoustics - determination of sound power levels of noise sources - engineering methods for small, movable sources in reverberant fields - methods for special reverberation test rooms

    學.噪功率測定.在混響場中對可移動的工程測量方法.用專用混響試驗室的測量方法
  5. Acoustics - determination of sound power levels of noise sources - engineering methods for small, movable sources in reverberant fields - comparison for hard - walled test rooms

    學.噪功率的測定.在混響場中小和移動的工程測量方法.第1部分:硬墻試驗室的比較分析法
  6. Acoustics - determination of sound power levels of noise sources - engineering methods for small, movable sources in reverberant fields - part 1 : comparison method for hard - walled test rooms

    學.測定噪功率.混響場內小型可移動的工程法.第1部分:硬壁試驗室中的比較法
  7. Acoustics - determination of sound power levels of noise sources - engineering methods for small, movable sources in reverberant fields - part 2 : methods for special reverberation test rooms

    學.壓法測定噪功率.混響場中小型可移動的工程檢測法.第2部分:專用混響試驗室法
  8. Acoustics. determination of sound power levels of noise sources. engineering methods for small, movable sources in reverberant fields. part 1 : comparison method for hard - walled test rooms

    學.噪的測定.混響場中小和移動的工程測量方法.第1部分:硬墻試驗室的比較分析法
  9. Acoustics - determination of sound power levels of noise sources - using sound pressure - engineering metheds for small, movable sources in reverberant fields - part 2 : methods for special reverberation test rooms

    壓法測定噪功率混響場中小型可移動工程法第2部分:專用混響測試室法
  10. Acoustics - determination of sound power levels of noise sources - precision methods for anechoic and semi - anechoic rooms

    學噪功率的測定消室和半消室精密法
  11. Precision methods for the determination of sound power levels of noise sources in anechoic and hemi - anechoic rooms

    在無回和半無回的室內精確測定噪功率的方法
  12. Acoustics - determination of sound power levels of noise sources using sound pressure - precision methods for anechoic and hemi - anechoic rooms

    學.利用壓測定噪功率.消室和半消室用精密法
  13. Acoustics - determination of sound power levels of noise sources using sound pressure - precision methods for anechoic and hemi - anechoic rooms iso 3745 : 2003 ; german version en iso 3745 : 2003

    學.利用壓測定噪功率.消室和半消
  14. A large planar microphone array, which consists of 111 microphones, was successfully applied to obtain a two - dimensional mapping of the sound sources on a landing aircraft. the focus of study in this paper is on the landing gear noise source. the spectra, directivities and sound pressure levels of flap side - edge noise of 7 narrow - board commercial aircraft and 7 wide - board commercial aircraft are presented. it is found that the landing gear noise spectrum is broadband with some single tones in some cases. the directivity of the total sound pressure level of a landing gear noise resembles that of a horizontal dipole. the level differences between the various aircraft landing gears are larger than those expected from the airspeed differences. it is thus expected that the louder noise emission of the landing gears can be reduced by redesigning

    應用由111個傳器組成的平面傳器陣列對當前流行的民用客機進場著陸過程中的機體噪進行了實驗測量,本文對七架窄體客機和七架寬體客機的起落架噪進行了分析,得到了起落架噪的頻譜特性、指向特性和變化.研究發現,起落架噪的頻譜是由寬頻隨機噪與一些較為明顯的單音噪組成,起落架噪的指向性類似於一個水平放置的偶極子.不同飛機起落架噪相差較大,這說明可以通過重新結構設計降低起落架噪
  15. Acoustics - determination of sound power levels of noise sources using sound intensity - measurement at discrete points

    學.利用音強度測定噪功率.第1部分:離散點測量
  16. En iso 9614 - 2 acoustics. determination of sound power levels of noise sources using sound intensity. part 2 : measurement by scanning

    學.利用音強度測定噪功率.第2部分:掃描測量法
  17. Acoustics - determination of sound power levels of noise sources using sound intensity - part 2 : measurement by scanning iso 9614 - 2 : 1996 ; german version en iso 9614 - 2 : 1996

    學.利用音強度測定噪功率.第2部分:掃描測
  18. Acoustics - determination of sound power levels of noise sources using vibration velocity - measurement for seal machinery

    學振速法測定噪功率用於封閉機器的測量
  19. In this paper the train running noise level has been predicted with the theory of point sound source. the sound exposure level of a train set pass, equivalent continuous sound level and maximum sound level of a train set pass has been taken as estimate values, and some kinds of affixation attenuation on the course of noise propagation is considered, then the corresponding visual software has been developed. these make it convenient and precise to predict the noise level

    本文從點的理論出發,對列車運行噪進行預測計算,採用一列車通過時的單發暴露、時間特性的最大和一定時間內的等效等作為噪評價量,並考慮了噪傳播過程中的各種附加衰減,編制了相應的可視化軟體,使噪預測計算方便、準確。
  20. The propagation characteristics of underwater acoustic channels and their influences on long - range information transmission are studied thoroughly. based on the sonar equation, the optimal frequency band is abtained. from the calculation about transmission loss, the source level is forecasted. based on the random time varying channel theory, the fading characteristics of long - range underwater acoustic channels are analyzed

    系統、深入地研究了水通道特性及其對水遠程信息傳輸系統的影響;從納方程出發,確定了系統的最佳工作頻段;在傳播損失計算的基礎上,給出了聲源級的預報;基於時變通道理論,描述了遠程水通道的衰落特性。
分享友人