肋結節 的英文怎麼說

中文拼音 [lèijiējié]
肋結節 英文
costae tubercle
  • : 肋構詞成分。
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : 節構詞成分。
  • 結節 : [生物學] tubercle; [拉丁語] tuber; tuberculum; plexus; protuberance; protuberantia; [拉丁語] scob...
  1. Thecalculating results show that the composite action between concrete floor and steel beamsgreatly influence the bending bearing capacity and initial rotational stiffness of joints, it shouldbe considered in practical engineer. reinforcement ratio of lengthways reinforcing bar andthe stiffener of web have great influencer on the behavior of connections, while the thicknessof end - plate and degree of shear connection have a litter influence on its behavior

    分析計算果表明:樓板與鋼梁的組合作用對點的抗彎承載力及初始轉動剛度的影響非常大,實際工程中點設計應當考慮這種組合作用;樓板內縱向鋼筋配筋率與柱腹板加勁點性能影響顯著,而連接端板厚度及剪力連接程度的影響則不是太顯著。
  2. Results : 1 the segmental artery sent off a spinal branch which transversed the intervertebral foramen and divided into anterior and posterior radiculomedullary arteries. 2

    果:段動脈在橫突關內側椎間孔部發出根髓動脈。
  3. Civil engineering new technology research institute of xi ' an university of architecture and technology, meeting the nation ' s call for wall reform, industrialization and continuable progress, invented a new structural system - multi - ribbed slab structure ( mrss ). the new structure is characterized by low self - weight and high strength, high efficiency in saving energy, construction convenience and low cost. previous study showed mrss is super ior to masonry structure in economy, technology and aseismic performance

    西安建築科技大學建築工程新技術研究所研製開發的密壁板構體系,具有輕質高強、高效能、施工簡便、造價低廉等顯著優點,並且前期的研究表明,密壁板構的各項經濟技術指標和抗震性能都優越于磚混構,因而用前者取代後者具有重要而深遠的現實意義。
  4. Spectral matching algorithm is applied, such as spectral angle mapping ( sam ) in section 3. 4 and cross correlogram spectral matching ( ccsm ) in section 3. 5 in order to discriminate different dominant species of red tide. the results of sam spectral matching are satisfying : identifications of mesodinium rubrum and leptocylindrus danicus succeed, identification of chattonella marina has wrong possibility and that of skeletonema costatum fails

    3 . 4將光譜角度制圖( spectralangl 「 mapping , sam )這一光譜匹配方法引入赤潮光譜識別研究之中,所進行的赤潮優勢種類識別取得了令人較為滿意的果:紅色中繞蟲、丹麥細柱藻赤潮的光譜識別取得了成功;海洋褐胞藻赤潮有誤識別的情況發生;只有中骨條藻赤潮的識別失敗。
  5. Multi - ribbed composite slab structure, as a new structural system, is very potential

    壁板構作為一種新型能住宅構體系,有著很好的發展前景。
  6. At the end of this section the paper specifies three possible failure modes of the ultimate resistance, depending on the ratio between the flexural resistance of the flanges and the axial resistance of the bolts. this numerical analysis includes many nonlinear structure behaviors such as contact status nonlinearities, geometric nonlinearities and material nonlinearities

    文章就連接翼緣板剛度的變化和設置加勁等構造措施對連接的高強度螺栓內力、翼緣板間的接觸壓力、撬力和點剛度的影響進行了對比分析,並對有限元的計算果進行了多項式擬合。
  7. Results of the experiment shows that end - plate connections have excellent hysteretic behaviors, and the determination factors, which have crucial influence on the behavior, are end - plate thickness, column web thickness, and the rib stiffeners

    試驗果表明端板連接具有良好的滯回性能,端板厚度、點域柱腹板厚度以及加勁構造是影響連接性能的主要因素。
  8. 2 based on experimental results and finite elements analysis of new joint, the stress transfer mechanism of the new joint is analyzed. there are two stress transfer patterns about the new joint, one is for rectangular steel tubular column joint, its stress transfer pattern is that beam moment is transferred to column webs mainly by stiffeners, the other is for crft column joint, its stress transfer pattern is that part of beam moment is transferred from stiffeners to column webs, another part of beam moment is transferred to infilled concrete by column flange

    (二)基於新型點的試驗果和有限元分析,研究了新型點的傳力機理,其應力的傳遞路徑分為兩種:對于鋼管柱點,梁端彎矩主要通過加勁板直接傳至柱腹板,對于鋼管混凝土柱點,梁端彎矩一部分通過加勁傳給柱腹板,另一部分通過柱翼緣傳給鋼管內的混凝土。
  9. Throught the comparation between supsendome and single layer reticulate, the advantages of suspend - dome was expatiated. through the analysis of lamella ’ s, rib - loop, rib - loop tilted bar type shell, the influence of lattice type to member ’ s force, joint ’ s displacement, reaction, intergral stability was studied, the suitable lattice type for suspendome was put forward

    通過對聯方型、環型、環斜桿型、環斜桿型、環斜桿型弦支穹頂構進行的分析優化比較,研究了網格形式對構件內力、點位移、支座反力、整體穩定的影響,提出了適合弦支穹頂構的合理網格形式。
  10. Multi - ribbed slab structure ( mrss ) is a new structural system, characterized by low weight, high strength, saving energy and good aseismic performance

    壁板構是一種輕質、高強、能、抗震的建築構新體系,在前期的研究中,已取得了不少的科研成果。
  11. After comparing between the finite - element analysis and experimental results, the author verified the fem. then according to the chinese code, the nonlinear finite model of the beam - to - column is established which are made of different size components. the responses of beam - to - column web moment connections which are made of different size components are compared and analyzed from three facets, and the conclusions about the joints behavior are drawn : thicken the connection plate, lengthen the connection plate or use a back - up stiffer can improve the connection behavior, consist of improving the behavior of load - supported and reducing the stress convergence in the flange moment plates

    本文根據我國規范的有關規定,自行建立了12個不同構件尺寸的樑柱腹板連接的三維有限元模型,對不同構件尺寸的樑柱腹板剛性連接點在單向荷載作用下的反應進行了研究,從構的mises應力等值線示意圖、梁端加載處的荷載? ?位移曲線、翼緣連接板兩端的mises等效應力以及翼緣連接板與柱相連接的三邊的mises應力等值線示意圖四方面進行了比較與分析,從而得出了不同構件尺寸的樑柱腹板剛性連接的在受力行為上的論:增加翼緣連接板的厚度、增加翼緣連接板的長度以及採用柱的橫向加勁均可以改善點的受力性能:提高點的承載能力;減小翼緣連接板內部與柱翼緣邊的的應力不均勻現象,從而避免試件過早地發生破壞。
  12. By simulating body node with fea software ansys and comparing its results with the experiment ones, natural capacity of semi - rigid connection node itself was discussed, and the experimental results were analyzed additionally, and the bearing conditions of sections which could n ' t be tested in experiment were obtained, as well as two kinds of bearing conditions under different conditions that the connections with and without stiffener were compared in detail

    在討論半剛性連接點本身的性能時,通過有限元軟體ansys對點進行三維非線性有限元精細模擬,將計算果與試驗所得數據對比,對試驗果進行補充分析,了解沒有測到試驗數據的點組件在加載過程中的受力情況,並對帶雙腹板角鋼頂、底角鋼連接在有無加勁兩種情況下的受力狀態進行詳細對比。
  13. After spectral data processing, remote sensing reflectance data of red tide are got, whose dominant species are leptocylindrus danicus, chattonella marina, skeletonema costatum and mesodinium rubrum respectively. section 3. 1 gives the data processing steps, results and biological details of the dominant species described above. method of extract spectrum absorption parameters such as absorption depth, width, symmetry and area is given in section 3. 2

    對所獲光譜數據進行處理,得出了丹麥細柱藻、海洋褐胞藻、中骨條藻、紅色中縊蟲等不同優勢種類赤潮水體的遙感反射率光譜曲線;上述數據處理步驟、數據處理果以及不同赤潮種類的生物特徵在本章的3 . 1給出。
  14. Abstract : cable - stayed is used to cable suspension, but cable force is calculated by manual, and only for less than 5 segments, and the prescion is poor. this paper puts forward “ zero moment method ”, which can not only calculate more segmental soupe force, but both temporary joint and fixed joint during construction. the mechanical concept is clear, and it is easy for calculating. it is fit for program, and the illustrations prove that the methods are right

    文摘:斜拉扣掛在纜索吊裝中經常運用,但扣索索力多採用手工計算,且多用於5段以內的吊裝,計算復雜,精度低.本文提出「零彎矩法」 ,可計算任意多段扣索索力,既可計算拱在施工過程中各段臨時鉸接,又可計算各段固的情況,將兩種連接方式統一成一種計算方法,力學概念清楚,計算簡便,適宜程,文中最後用示例證實本方法的正確性
  15. Lightweight frame structure of multi - ribbed wall panel is a new type of structure, which lightweight, big rigidity, good anti - seismic capacity, to economize energy resource, good social benefit and green environment protection are different from ordinary frame and shear wall

    壁板輕框構是一種自重輕、剛度大、抗震性能好,能效果佳、社會效益高、綠色環保新型構體系,它有別于普通的框架構和剪力墻構。
  16. Based on the achievements done by others and the feature of superstructures, we establish the segment models under the different loads for the fem calculating of the deck and make it for the final conclusion that the distribution of the stresses in the deck of this main girder are uniform

    本文合已有的研究成果以及金馬大橋橋面系的構特點,通過建立主梁的有限元段模型,並分工況計算橋面板的正應力分佈情況。計算果表明,板式斜拉橋主梁的橋面板正應力分佈是比較均勻的。
  17. Based on experimental research and theoretical analysis, investigations on the new type of joint are made systematically, the main contents and results include the following items. 1 four specimens of new joints between cfrt columns and steel beams are designed. by low - cyclic reversed load test, skeleton curves of new joints and shearing deformation in joint core area are studied, the influence of parameters, such as concrete cores, length of stiffener, and relative dimensions of column and beam, is discussed

    本文在分析現有點方案特點的基礎上,提出了角鋼加勁式點方案,並採用試驗和理論分析相合的方法,對這種新型點進行了系統研究,主要研究內容與成果如下: (一)設計了4個新型方鋼管混凝土柱?鋼梁點的試件,通過對新型點的低周反復荷載試驗,研究了新型點的骨架曲線和點核心區剪切變形等,探討了內填混凝土、加勁長度和樑柱相對尺寸等對點抗震性能影響。
分享友人