脈動直流 的英文怎麼說

中文拼音 [màidòngzhíliú]
脈動直流 英文
pulsating dc
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 脈動 : [物理學] [天文學] pulsation; pulsing; pulse; ripple; impulsive motion; pulsating; panting; loping...
  • 直流 : direct current （dc）; constant current; steady current; continuous current; zero frequency curre...
  1. The experiment results indicate that this method is more effective in the brushless direct current motor ' s low speed torque ripple attenuation, and its more effective in improving system dynamic performance

    運行結果表明，此方案能有效地抑制無刷直流電動機低速時的轉矩脈動，更好地改善系統的動態性能。
  2. 3000 hours. lower voltage high capacitance cdf farad - grade aluminum electrolytic capacitor. well suited for use in super car audio systems, industrid robots, telecommunication equipmemt of dc or pulse circuits

    3000小時，低電壓高電容量法拉級cdf ，廣泛用於精密汽車聲頻系統、工業機器人，電信設備的直流電或脈動電路中。
  3. In the positioning servo - system, which generally is configured by the d. c. pulse width modulator ( pwm ) velocity governing system and position servo - loop, the parameter perturbance of pwm velocity loop really exist by reason of such as the load behavior ; power voltage supply ; operating setting value, etc. 1, 2 ， and it cannot be ignored. by using the identification technique to form the mathematical model of the system, authors have confirmed the facts. therefore, to design the discrete sliding mode controller ( dsmc ) of the positioning servo - system, the perturbed parameters value bounds of the pwm velocity loop, which is as the controlled plant of position servo - loop, should be accounted. consequently, the design principle of dsmc for accounting system with parameter perturbance is proposed by the authors. the proposed method can ensure the stability of system with parameter perturbance and the behavior of non - overshoot, fast precise positioning. in order to reveal the effects of the design method, the comparative research work is done by the authors. also, it has been tested in an industrial experiment, the results proved it is satisfactory

    由直流脈寬調速系統（ pwm ）和位置環構成的定位系統中，速度環的參數隨負載特性；電網電壓；給定工況而攝動是不容忽視的.作者通過系統辨識建模也證實了這一事實1 ， 2 .因此在設計位置環的離散滑模控制時，必須針對速度環（即位置環的控制對象）的參數攝動范圍採用「對象參數攝動離散滑模控制器的設計方法」 ，以確保系統在參數攝動時的穩定性和快速、無超調、準確定位的優良動態品質.為剖析該設計方法的控制效果，本文作了對比性研究，並將該設計方法用於工業試驗中，取得了滿意的結果
  4. Pulsating spray drying technique makes use of the unstable hot gas stream generated by a pulse combustor to atomi / e and dry a liquid material

    脈動燃燒乾燥技術是近年來出現的一種新型乾燥技術，它利用脈動燃燒器產生的高溫，高頻脈動尾氣流直接霧化和乾燥液態物料。
  5. Torque ripple reduction in brushless dc motor drives using a buck converter

    變換器的無刷直流電機轉矩脈動抑制方法
  6. For the bldcm which has a pseudo - sinusoidal back - emf waveform, this dissertation presents a svpwm control method using six discrete position signals for minimizing the torque ripple. the main aspects for the implementation of this method are analyzed, including the initial orientation of the voltage vector, reasonable choice of the impedance angle and the advance commutation angle, and estimation of the successive rotor positions

    針對反電動勢類似正弦的準正弦波反電動勢無刷直流電動機，本文提出一種基於六個離散位置信號的自同步svpwm （電壓空間矢量法）控制方法，用以削弱電磁轉矩脈動，分析了實現這種方法的主要控制環節，包括起動時電壓空間矢量的初始定位，阻抗角與電流超前角的合理選擇以及連續轉子位置的估計等。
  7. The simulation results prove that this control technique can effectively minimize the torque ripple for the bldcm drives whose back - emf waveform crest width is less than 120

    模擬結果表明這種控制策略能有效地抑制反電動勢平頂寬度小於120電角的無刷直流電動機的換相轉矩脈動。
  8. Furthermore, this dissertation also gives a comprehensive analysis and comparison to the torque ripple factor, torque - current ratio and other aspects for pseudo - sinusoidal emf bldcm drived by 120 conduction mode, 180 conduction mode and self - synchronous svpwm mode respectively. the simulation and the experimental results indicate that self - synchronous svpwm method is more effective for minimizing the torque ripple without any expense of the torque - current ratio when the crest width of the back - emf waveform is less than 107 electrical angles

    對準正弦波反電動勢無刷直流電動機在120導通方式、 180導通方式和自同步svpwm三種控制方式下的轉矩脈動系數、轉矩電流比等方面進行了全面的分析與比較，模擬研究和實驗結果表明，當反電動勢的平頂寬度小於107電角時，採用自同步svpwm控制方法可以在不損失轉矩電流比的基礎上，更有效地抑制電磁轉矩脈動。
  9. For the bldcm which has a general crest width of the back - emf waveform, two kinds of torque ripple conditions when drived by sine - wave current as well as by square - wave current are deduced based on the mathematical models. in addition, a comparison is carried out between these two conditions, which indicates that sinusoidal current driving is more favorable to minimizing the torque ripple when the crest width of the back - emf waveform is less than a certain value

    闡述了抑制齒槽轉矩措施對反電動勢波形的影響，利用無刷直流電機的數學模型推導並比較了任意平頂寬度梯形波反電動勢在正弦波和矩形波兩種電流驅動下的電磁轉矩脈動情況，得出在梯形波平頂寬度減小到一定數值后採用正弦電流驅動更有利於減小電磁轉矩脈動。
  10. 3. with fourier decomposition, the main component of pulsating torque, torque ripple is studied. it can be determined that torque ripple is caused by harmonic order 6n under the usual common conditions

    3 、對造成轉矩脈動的主要成分轉矩紋波進行諧波分析，得出在一般假設情況下，無刷直流電動機系統的轉矩紋波由電磁轉矩的6n次諧波造成的結論。
  11. At first, on the base of the analysis of the mechanism of the helical gear pump, the paper try to find the relationship of the helical gear pump flow pulse with its corresponding parameters, give the solution of the problems brought by the replace of spur gear to lay the firm basis for the structural design of helical gear pump

    本論文在對齒輪泵工作原理和流量脈動機理分析的基礎上，首先探討了斜齒齒輪泵的輸出流量脈動與斜齒輪各結構參數之間的關系，以及由於斜齒輪替代直齒輪帶來的相關問題並提出解決辦法，為斜齒齒輪泵的結構設計奠定基礎。
  12. At the aspect of hardware design, it adopts pulse distributor and the technology of single polar voltage drive to accomplish the function of controlling and driving stepmotor ; it adopts the technology of pulse width modulation and cmos h - bridge drive to accomplish the function of controlling and driving dc servomotor ; it adopts d / a convertor to accomplish the function of controlling ac transducer ; it adopts the technology of digital phase detection to accomplish the function of detecting the feedback position signal of induction phase shifter ; it adopts dsp ’ s capture cell to accomplish the function of detecting the feedback position signal of photoelectric coder

    硬體方面，採用脈沖分配器和單極性電壓驅動技術實現了步進電機的控制和驅動功能;採用脈寬調制技術和cmos互補h橋驅動技術實現了直流伺服電機的控制和驅動功能;採用d / a轉換器實現了交流變頻器的控制功能;採用數字化相位檢測技術實現了感應移相器位置反饋信號的檢測功能;採用dsp的捕獲單元實現了光電編碼器位置反饋信號的檢測功能。
  13. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  14. Analysis on commutation torque ripples of a pmbdc motor based on c - dump converter

    變換器供電的無刷直流電機換相轉矩脈動的分析
  15. An analysis and a compensation method for commutation torque ripple in trapezoidal bldc motor

    無刷直流電機換相轉矩脈動的分析及其補償方法
  16. Modified formula for sensorless dc motor speed estimation was proposed through the test for relationship between the current ripple frequency and the rotation speed in a 4 - pole dc motor

    摘要根據4極直流電動機的轉速與脈動電流頻率關系的實驗結果，對現有的無傳感器直流電動機測速公式提出了修正意見。
  17. The new modified formula not only meets with our experiment result, but also can explain the examples of relationship between the speed and the current ripple frequency of dc motors in the literature

    新的修正公式不僅能夠解釋文中的實驗結果，也能滿足以往文獻提出的直流電動機轉速與脈動電流頻率之間的關系。
  18. Gca silicon commutate battery charger are the ideal portable tools for charging, they are composed with the conditions of voltage dropping through rectifier transformer, then the bridge rectifying of rectification circuit. the output full - wave pulstin current charge the storage battery. the voltage changing composed with multiband switch. the outputcurrent can be adjusted. this kind of product used any moment onctarging anyplace

    Gca系列整流充電機是由整流變壓器的降壓，再經過流電路的橋式整流，輸出全波脈動直流對電瓶進行充電，電壓調速同多頭波段開關組，輸出流可以調節，該產品用任何需要補充充電的場所。
  19. Rules for capacitors ; part 11 : rules for capacitors of more than 600 v for the equalizing of pulsating direct voltages

    電容器的規范.第11部分:大於600 v的脈動直流電壓均
  20. ( 3 ) comparison of the experimental data with the simulation results a pulse combustion spray drying system was constructed and the spray drying of nacl solution was carried out under a high oscillating flow field generated by the pulse combustor

    （ 3 ）進行了脈動燃燒噴霧乾燥試驗和數學模型驗證建立了脈動燃燒噴霧乾燥試驗裝置，並利用質量分數10的nacl溶液進行脈動氣流直接霧化和乾燥的試驗。
分享友人
分享到 Line

分享到臉書