脈沖模 的英文怎麼說

中文拼音 [màichōng]
脈沖模 英文
pulse mode
  • : 脈名詞1. (動脈和靜脈的統稱) arteries and veins2. (脈搏的簡稱) pulse 3. (像血管的組織; 連貫成系統的東西) vein
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  1. Simulations of gain and aberrance are done to study the amplification of pulse signal with a frequency of 0. 25mhz

    對頻率為0 . 25mhz的信號放大進行了擬,分析了其增益和畸變隨放大參量的變化情況。
  2. Clinical study on dengzhan xixin injection combined with photon - autotransfusion therapy in treating diabetic peripheral neuropathy

    相干激光雷達對運動目標成像
  3. In the dissertation ' s chapter 3 to chapter 5, the mechanical and physical performances of the engineering plastics are analyzed, the failure mode and the designing computing methods of engineering plastics member suffering the static load, dynamic load, impact load, pulse load, are studied. by the practice application and ball firing experiment of the engineering plastics key piece in the weapons, the precious experiences, for engineering plastics application and confirmation of the material performances guideline in the weapons, are obtained

    論文的第三章至第五章,分析了工程塑料物理機械性能,研究了受靜載荷、動載荷、擊載荷及載荷下工程塑料構件的失效式和設計計算方法,通過工程塑料在槍械關鍵受力結構件上的實際應用和實彈射擊試驗,取得了寶貴的經驗,為高性能工程塑料在槍械上的應用和材料性能指標的確定奠定了基礎。
  4. By using the processing method of sliding time window, the problem of the periodicity range ambiguity is solved. meanwhile, the problem of range ambiguity which is produced because the range of target is biger than the maximum range of radar is also solved by using this method. then, the pulse width parameter which is the most important in the parameters of fmicw is analyzed. the stricter restrict is given to ensure the range spectrum has only one beat frequency after signal processing. at last this thesis introduces the different signal processing methods of fmpcw and fmicw

    同時利用該方法解決了fmpcw信號的由於目標距離超過雷達的最大單值測距范圍而引起的距離糊問題。然後對fmicw波形參數中最為重要的寬度進行了分析,給出了更為嚴格的約束條件,保證了信號處理后距離譜峰值的唯一性。最後,分別介紹了fmpcw和fmicw信號的不同處理方式,並對兩者不同的時域濾波性能進行了比較,並對二者的差異進行了分析。
  5. Based on the analysis of the beat frequency signal, the expression of the beat frequency phase is deduced. the expression indicates physics meanings of quantities to be detected and supplies theoretical bases for detection methods. by using two - dimensional fft, the range and velocity information of target is got out from the echo. according to the periodicity range ambiguity of symmetrical pulses in fmpcw, the processing method of sliding time window is used

    通過對差頻信號進行的分析,得出了差頻相位的具體表達式,表現出了要檢測的各量的物理意義,對檢測的方法提供了理論依據。利用二維fft方法,可以有效地提取回波中目標的距離與速度信息。對于fmpcw信號由於均勻產生的周期性距離糊的問題,採取時間波門的處理方法。
  6. It can create micro magnetic field. it combine computer proceeding frequency vibration massage and low frequency bioelectricity impulse treatment. easy to use. instruction manual included

    4 .生物電脈沖模式和電腦頻率振動狀態的按摩時間分別設有定時控制鍵3分鐘5分鐘15分鐘。
  7. But there has been not correspondingly control system for it by far. ln this thesis a pulse nitrogenous conveying control system based on profibus is designed and achieved on the thinking of modularizing the pulse nitrogenous conveying system, which can be used for different the pulse nitrogenous conveying system and added new control cells. the thesis reviewed systematically the pulse nitrogenous conveying system in practical, and makes the understanding that the system is composed of standard gas storage cell, conveying equipment cell and target container ceil. then a common modularized control system project is designed and achieved by structurized programming orienting process, which consists of four control models, respectively for gas storage cell, for conveying equipment cell and for target container cell

    本文綜合實際使用的氮保護氣力輸送系統,把氮保護氣力輸送系統分為標準化的氣源設備單元、發送設備單元和目的料倉設備單元,在此基礎上,設計了用於氮保護氣力輸送系統的通用塊化控制方案,採用面向過程的結構化編程思想,基於profibus現場總線,實現了組成該方案的四類控制塊:氣源單元控制塊、發送單元控制塊、目的料倉單元控制塊和通訊處理控制塊。
  8. Second, this paper analyzes the time - frequency distribution of the clutter from airborne pulse doppler radar ( pdr ). the side - lobe clutter, which is the main factor to influence the pdr, is analyzed and calculated. based on the simulation of typical geometry of the land, we analyze and discuss the side - lobe clutter and concluded that the dft of can be considered as the phase of the coho

    並且根據各種典型地貌的近似擬,從統計特性上和頻率域上對多卜勒雷達的旁瓣雜波進行了分析討淪,還得出多卜勒雷達的dft可以近似地看作相參積累,並在程序的編制中利用了這一個結論。
  9. The research work of the dissertation includes the following two parts : researching the passive ranging technology of three elements dissymmetrical array and developing system software of the sonar pulse detection module

    本論文的研究工作分為兩個部分:三元非對稱陣被動測距技術研究和聲吶偵察塊系統軟體的研製。
  10. By analysis, two kinds of caq are found : one is width - modulated countable pulse series, the other is frequency - modulated countable pulse series. furthermore, the method of generating caq is described and its double features is also proved

    通過分析找到兩種計數型擬量:調寬計數串和調頻計數串,同時本文也闡述了計數型擬量的產生方法,並進一步驗證了它的二象性特徵。
  11. The system comprises three modules : the first is the ccd driver module, which controlled with cpld. programming the cpld to produce ccd driving pulses and synchronized communication signals. after preprocessing, the output video signals are transmitted into high resolution adc module, in which they are converted into digital signals, and then processed in arm processing module

    整個系統分為三個塊: ccd驅動塊的核心是一片復雜可編程邏輯器件( cpld ) ,對其編程產生ccd的驅動及同步控制信號;視頻輸出信號經預處理后,由高精度ad轉換塊進行采樣,將ccd輸出的擬信號轉換成數字量;最後,將數據送入arm處理系統中進行后續處理。
  12. This paper presents a method that chopping wave is done by switch devices which consist of three - level resistance regulating module and intelligence power module ipm, and which realizes constant - current discharge of storage battery. to achieve the intelligence control of the drive protection and the discharge process of ipm, the paper designs circuit formed by igbt threshold drive pulse pwm signals. ipm fault - blocking protection circuit and microcomputer 80c196. the devices can accurately control the 0 ~ 150a discharge current and the discharge time of the storage battery and calculate the releasing power

    實現蓄電池恆流放電過程智能控制是蓄電池放電裝置發展的必然趨,本文提出了一種通過三極電阻調節塊和由智能功率塊ipm為開關器件進行斬波從而實現蓄電池恆流放電的方法。為達到對ipm的驅動保護和放電過程的智能控制,文中設計了igbt門極驅動pwm信號形成電路和ipm故障封鎖保護電路及由單片機80c196為核心的微機控制器。本裝置能夠對蓄電池進行0 150a放電電流及放電時間的精確控制及釋放容量的計算。
  13. Based on a duralumin flexible beam with piezoelectric films attached, distributed parameter modal described by partial difference equations is builded, and then turned into a set of two order systems with the method of modal analyse. state feedback control and independent modal control is investigated. and simulation of the closed - loop system with thest two methods is performed in matlab

    並用態分析的方法,將系統的偏微分方程型轉化成了型;研究了狀態反饋和獨立態方法;進一步完善了軟體界面以及軟體功能;在實際系統中,應用狀態反饋演算法,有效抑制了懸臂梁在受到外界瞬時擾動和激振引起的一階、二階態振動。
  14. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中,作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰噪聲抑制、兩分頻電路及死區時間設定;驅動及式選擇電路中開關管的寬長比的選擇及式轉換點的設計。
  15. Transitional section cone angle design of emp simulator

    電磁脈沖模擬器前後過渡段錐角設計
  16. Chapter 5 describes how to design fuzzy control rulers by reverse pulse algorithm, which solves the problem of fast charging on the storage battery. this method is applied to improve the efficiency of power conversion and shorten the charging time

    第五章從蓄電池快速充電理論出發,根據馬斯定律,以電壓和溫升作為控制變量,運用反向脈沖模糊控制演算法對蓄電池快速充電進行擬,用以提高電能轉換效率,縮短充電時間。
  17. Characterization of an external - magnetic field mid with polymer anode and a self - magnetic field mid with graphite anode operated in unipolar and bipolar pulse mode, respectively, has been performed. it is found that the characteristics of hipib are mainly depended on two crucial factors, i. e. the properties of insulated magnetic field and anode plasma

    通過聚合物陽極的單極脈沖模式外磁絕緣離子二極體和石墨陽極的雙極脈沖模式自磁絕緣離子二極體工作特性的實驗研究發現,影響hipib產生特性的主要因素是離子二極體的絕緣磁場性質和陽極等離子體特性。
  18. Response of a short single - wire line illuminated by an emp simulator

    有界波電磁脈沖模擬器下短線纜效應的理論和實驗研究
  19. It is based on a set of practical data in some area. the nonlinear least - square method is used to work out the parameters of the mobile communication channels " model, and then the error sequence comes into being. the noise ' s model of automobile that can reflect the random characteristics of the noise is also founded

    本論文採用簡單分群的markov二狀態型建立移動通道概率統計型,從某一移動通道實測曲線出發,利用非線性最小二乘法得出狀態型參數,從而獲得移動通道的差錯序列;本文對汽車噪聲的產生以及它對信號的影響進行了詳細的分析,提出了汽車噪聲型;並且採用尖脈沖模擬汽車點火噪聲,實現了噪聲對信號的隨機干擾,形象地反映了移動通道中信號的疊加過程。
  20. This paper has analyzed the characteristics of near - field electromagnetic fields and the measurement principle of magnetic - field sensor, and designed probe, amplifier unit and compensator according to measurement needs. finally, based on the electromagnetic pulse simulator in the lab, a set of experiments have been done on the designed magnetic fields measurement system and analyzed the error of the measurement system

    文中分析了近場電磁場分佈的特點;研究了磁場探頭的測量原理;根據實際測量需要製作了磁場探頭、設計了信號放大單元和用於補償電纜信號衰減的補償器;最後利用實驗室的電磁脈沖模擬器對所設計的磁場測量系統進行了一系列實驗,分析了系統的測量誤差。
分享友人