脈沖試驗機 的英文怎麼說

中文拼音 [màichōngshìyàn]
脈沖試驗機 英文
impulse testing machine
  • : 脈名詞1. (動脈和靜脈的統稱) arteries and veins2. (脈搏的簡稱) pulse 3. (像血管的組織; 連貫成系統的東西) vein
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : machineengine
  • 試驗 : trial; experiment; test
  1. In the dissertation ' s chapter 3 to chapter 5, the mechanical and physical performances of the engineering plastics are analyzed, the failure mode and the designing computing methods of engineering plastics member suffering the static load, dynamic load, impact load, pulse load, are studied. by the practice application and ball firing experiment of the engineering plastics key piece in the weapons, the precious experiences, for engineering plastics application and confirmation of the material performances guideline in the weapons, are obtained

    論文的第三章至第五章,分析了工程塑料物理械性能,研究了受靜載荷、動載荷、擊載荷及載荷下工程塑料構件的失效模式和設計計算方法,通過工程塑料在槍械關鍵受力結構件上的實際應用和實彈射擊,取得了寶貴的經,為高性能工程塑料在槍械上的應用和材料性能指標的確定奠定了基礎。
  2. In the paper, on the basis of research of static state and transient state in the scr and series connection valve circuit, the high voltage scr changing current valve device has been developed for ac - dc - ac high voltage commutatorless motor. the series connection valve circuit has been designed and simulated. the hardware design and software programming of trigger pulse system and monitoring system in the photo - electronic - photo fashion has been completed

    無換向器電動在火電廠等工礦企業的電調速節能領域中有十分廣闊的應用前景,本文在對晶閘管元件和串聯閥電路的靜態特性和動態特性研究的基礎上,研製了用於交直交電流型高壓無換向器電動的高壓晶閘管換流閥裝置,進行了串聯閥電路的設計和模擬,完成了電光電方式的觸發系統和監測系統硬體設計及軟體編程,並進行了裝置的實調
  3. This dissertation majorly researchs and designs full digital dc driving system with fuzzy control. it makes a scheme argumentation firstly, analyzing the pid algorithm and fuzzy control algorithm the ordinary digital pulse trigger algorithm and the double remainder method of pulse trigger in detail, and fuzzy control and the double remainder method are put forward to settle the under - mentioned problems, namely, the new viewpoint and the task having finished in this dissertation as follows : ( 1 ) in rder to overcome the influence of dc motor ' s parameter changing with time and nonlinear on the control system performance, this dissertation adopts fuzzy control as outside regulator and pi control as inside regulator in double regulators of the full digital dc motor driving system design ;. ( 2 ) aiming at the pulse trigger reliability of the ordinary d igital pulse trigger being low and leaking the pulse or the order of pulse confusion, this paper adopts the double remainder algorithm with short response time high pulse trigger reliability good adaptability and anti - jamming ; ( 3 ) this dissertation adopts tms320lf2407 which has good performance as major control chip this chip has power function with fast calculation capability, and accomplishes the software and hardware design in the dc motor driving system with fuzzy control ; ( 4 ) this dissertation also puts emphases on anti - jamming in hardware and software ; ( 5 ) after having designed the sample of full digital dc motor driving system with fuzzy control, a lot of experiments are performed to verify the performance and settles problems during experiment. the result of experiment proves the feasibility of design

    首先進行了方案論證,對模糊控制演算法和數字pid調節演算法、觸發的一般演算法和雙余演算法進行了詳細地研究分析,提出應用模糊控制和雙余法解決下述問題,即該論文主要的新見解和所完成的工作: ( 1 )為了克服直流電參數時變性和非線性因素對控制性能的影響,本設計中,雙閉環調速系統的外環採用模糊控制,內環採用pi控制,使系統在一定范圍內對直流電參數變化和非線性因素影響有自適應能力; ( 2 )針對常規數字觸發器演算法中觸發的可靠性不高,經常出現漏或是混亂的情況,本文採用雙余法,該演算法具有響應快,可靠性高,具有良好的適應性及抗干擾能力; ( 3 )本設計中採用了速度快、功能強的tms320lf2407作為系統的主控晶元,應用該晶元完成系統的軟硬體設計: ( 4 )本文對系統抗干擾的軟硬體措施進行了重點研究; ( 5 )設計了具有模糊控制的全數字直流傳動系統原理樣,並進行了證,對過程中出現的問題及時解決,最終實結果證明設計是可行的。
  4. Fibre optic communication subsystem test procedures - digital systems - time - resolved chirp and alpha - factor measurement of laser transmitters

    纖維光學通信子系統程序.數字系統.激光發射的時間分辨線性調頻和因數測量
  5. Fibre optic communication subsystem test procedures - part 2 - 10 : digital systems ; time - resolved chirp and alpha - factor measurement of laser transmitters

    纖維光學通信子系統程序.第2 - 10部分:數字系統.激光發射的時間分辨線性調頻和因數測量
  6. Basic safety publication ; environmental testing ; part 2 : tests methods ; test a : cold

    內燃全流式油濾清器方法第5部分:冷起動模擬和液壓耐久
  7. The main task of this dissertation is to model and simulate a monopulse radar system. in the end, we design a set of software platforms of a monopulse radar system, which would be a living, economical and convenient test platform for radar electronic warfare. firstly, this dissertation studies the model of radar signal environment

    本文的主要工作是對單雷達系統進行計算建模和模擬,最終目的是開發出一套模擬單雷達系統工作模式的軟體模擬平臺,為雷達電子戰提供一個逼真、快捷、高效、經濟和方便的平臺。
  8. The relationships between the laser performance index, such as laser power densities, pulse energy and energy densities, and the diameter of holes have been set up, and a experience formula between the energy density and the diameter of holes has been established by the regression method, based on the experiment results

    在此基礎上,本文對微噴帶激光打孔的性能進行了研究,得到了激光功率密度、激光能量和激光能量密度對打孔孔徑的影響關系。通過數據回歸的方法,建立了激光能量密度與孔徑之間的半經公式。
  9. 2 for an impulse source there shall be a peak reading instrument voltmeter connected directly to the electrode head, indicating continually the potential of the electrode with or without a grounded test wire in the chamber

    火花,電壓表直接接在電極上,顯示的是測電線沒有接地的情況下的峰值電壓。
  10. Then using kerosene as fuel, oxygen and compressed air as oxidizers, proof - of - principle experiments of pdre were successfully conducted the results show that the measured detonation wave pressures are close to theoretical values it also indicate that using kerosene as the fuel of pdre is feasible

    採用航空煤油為燃料,氧氣和壓縮空氣為氧化劑,分別進行了兩相爆震火箭發動原理性,所測得的爆震波壓力接近充分發展的理想爆震波壓力,說明採用煤油作為爆震火箭發動的燃料是可行的。
  11. Hopefully, the results obtained from this paper would prompt the further research of the degradation and destruction mechanisms of zinc oxide varistors under multipulse current strike, and offer suggestion on revising the lightning test standards and improving the product quality of zinc oxide varistors, etc

    本文的工作和結論有助於進一步研究氧化鋅電阻在多電流作用下的擊老化破壞理,另外也為修改我國氧化鋅電阻的雷電流標準提供理論依據,並為改進氧化鋅電阻生產和提高產品質量提出了建設性意見。
  12. Portable pulse fogger - part 2 : test methods

    便攜式煙霧.第2部分:方法
  13. Test results have shown that with discharge energy of 40 j, our ppt ' s thrust has reached more than 0. 605 mn, and its isp is 1188 s and weight is 4. 2kg, which reaches the level of current ppt used in the world

    所研製的等離子體推力器樣質量為4 . 2kg ,在放電能量為40j時,推力為0 . 605mn ,比為1188s ,達到國際同期空間的水平。
  14. Experimental study on two - phase pulse detonation engine model

    兩相爆震發動模型研究
  15. Input pulse signal can be directly transformed into micro - step linear motion by use of linear pulse motor, which have found wide applications in the digital linear servo systems with high positional accuracy and high reliability. taking slpmu - 025a, a two - phase hybrid lpm manufacturing by shinko motor company ltd, as an specimen, the study on the drive control system is carried out in this thesis, which contains : ( l ) three kinds of drive circuits are designed and comparison analysis in theory is done ; ( 2 ) introduction to at89c51 microchip as controller and special micro - step constant current driver, a great variety of running modes driver control are developed ; ( 3 ) experimental testing and theoretical analysis of current waveforms and displacement graphs and velocity graphs are carried out in case of different micro - step constant current driver

    本文以日本神鋼電株式會社生產的兩相混合式直線slpmu - 025a為樣,對直線的驅動控制系統進行了研究,內容包括: ( 1 )設計了幾種直線驅動器電路,從理論上進行了對比分析研究; ( 2 )用at89c51單片作為控制器,採用專用的恆流細分驅動器sh ? 2h057m ,實現了開環控制方式下對slpmu ? 025a樣各種運行方式的驅動控制; ( 3 )對不同細分數下恆流驅動的電流波形以及各種運行方式下的位移圖、速度圖進行了實和理論分析研究。
  16. Mechanical vibration and shock - cold provocation tests for the assessment of peripheral vascular function - part 1 : measurement and evaluation of finger skin temperature iso 14835 - 1 : 2005

    械振動和擊.評估周邊管功能的冷刺激.第1部
  17. Experimental investigation on detonation velocity in pulse detonation engines with different inner diameters

    不同內徑兩相爆震模型爆震波速的研究
  18. Methods of testing plastics - mechanical properties - tensile vibration - sonic - pulse propagation method

    塑料方法.第3部分:械性能.拉伸震動.方法323f :聲傳播法
  19. The working principle of pulsed eddy current ( pec ) nondestructive testing technology is analyzed, the pec testing system was been established to examined the specimen of multi - layered aircraft structure, peak and zero - crossing time of the time domain transient response signal of pec are extracted as the features to detect the corrosion in the second layer of aircraft structure quantificationally, the experiment results are consistent with that of the theory analysis, as the pec have the advantages of fast speed and quantification, this makes the method have the broad using foreground in the testing of aircraft structure corrosion

    摘要對渦流無損檢測技術的工作原理進行了分析,建立了渦流的檢測系統對加工的模擬飛多層結構的件進行了測,提取其時域瞬態感應信號的峰值和過零時間作為特徵量,對出現在飛多層結構第二層中的腐蝕缺陷進行了定量檢測,結果和理論分析相一致,證明了渦流檢測方法的有效性,由於其具有快速和定量化的優點因而在飛結構的腐蝕檢測中具有廣闊的應用前景。
  20. Detonation pressure properties of kerosene aero - valve pulse detonation engine

    煤油氣動閥式爆震發動爆震波壓力特性
分享友人