脈沖間隙 的英文怎麼說

中文拼音 [màichōngjiānxì]
脈沖間隙 英文
pulse interval
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 間隙 : （空隙） interval; gap; freedom; space; [機械工程] clearance; separation; stricture; clear; inter...
  1. By using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  2. Abstract : by using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    文摘:通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  3. It has been confirmed practically that the diamond highness above base material can be adjusted with the range when the generator is put into use, and the result shows that the current density drop sharply with the increase of machining gap

    結果表明，間隙值的擴大伴隨電流密度的顯著下降，檢測電解電流控制脈沖能量的方法對實現電蝕層厚度基本可控是可行的，可讓金剛石突出一定高度。
  4. Surface flashover across the insulators in vacuum is the major limitation of the performance of the high power system, such as high power microwave tube, pulse power switch, high - energy linear accelerator, etc. flashover studies are of considerable importance in many applications. alumina ceramics are used widely in vacuum insulation system. the flashover and charging performance have been systematically investigated on alumina ceramics in vacuum under pulse voltage ( 0. 7 / 4 ^ 8 )

    真空中絕緣子沿面閃絡現象是制約高功率微波管、脈沖功率開關、高能粒子加速器等系統性能的主要原因，這是因為真空中絕緣子在一個比自身及相同真空間隙擊穿電場低得多的電場下就發生了表面閃絡的緣故，研究真空中絕緣子沿面閃絡現象及其形成機理對于改善和提高系統性能有重要意義。
  5. To the discharge in the air gap, with the increase of applied voltage, the discharge area is larger, and the time interval is smaller, and discharge pulses frequency is higher

    對于間隙中的放電情況，施加電壓越高，放電區域越大，放電時間間隔越小，放電脈沖頻率越高;電壓進一步升高，放電轉化為穩定的輝光放電。
  6. By applying related theory of gas discharge and mathematical statistics, this paper more in - depth and systemic study the influence of the length of air gap, ice state, water conductivity and air pressure on the inception corona and pulse discharge characteristics, included the discharge frequency, discharge amplitude and time interval

    根據試驗結果，用氣體放電和數理統計方法，分析了覆冰水電導率、冰的狀態（乾冰和濕冰） 、空氣間隙長度、氣壓和施加電壓等參數的變化對間隙模型的起始放電電壓、脈沖放電特性、放電頻率、放電幅值和時間間隔等的影響。
  7. Aqueous fluid volume and [ c1 ~ j were assayed in samples withdrawn by micropipettes. intraocular pressure ( top ), pressure - dependent outflow, and anterior chamber compliance were determined from pressure measurements in response to pulsed and continuous fluid infusions into the anterior chamber using micropipettes. result : in wildtype mice ( gdi genetic background, age 4 - 6 weeks ), iop was 16. 0 ? 0. 4 mmhg, aqueous fluid volume was 7. 2 ? 0. 3 ul, aqueous fluid production was 3. 6 ? 0. 2 ul / hr, aqueous fluid outflow was 0. 36 ? 0. 06 ul / hr / mmhg, and anterior chamber compliance was 0. 036 ? 0. 006 ul / mmhg ( mean ? se, 8 - 10 eyes )

    實驗方法包括：將熒光物質用電離子滲透的方法穿透角膜導入活體小鼠的前房中，然後應用共聚焦顯微鏡根據熒光強度變化測量房水生成率；通過顯微注射針吸取房水檢測房水容積和氯離子濃度；顯微玻璃管刺入前房測量眼內壓，並將生理鹽水分別以連續和脈沖兩種方式注入前房，測量房水間隙的順應性和房水排出與眼內壓的相關性。
  8. An energy controllable ecm pulse generator which machining gap appearance changes with the detected eum current variable is developed, to make the electrolysis thickness of ecm and machining gap width of the diamond controllable

    用檢測電流的方法，設計和研製隨間隙狀態變化能量可控的脈沖電解電源，用於金剛石節塊電解修刃，以實現電解電蝕層厚度的基本可控，從而可實際控制金剛石的出刃高度。
  9. The results of calculations and experiments show that the delay and jitter increased as the percentage of sf _ ( 6 ) in sf _ ( 6 ) - n2 mixtures increased. the results of experiments show that the delay of sf _ ( 6 ) - ar follows the same rule. the u _ ( th ) u _ ( sb ) increased as the percentage of sf _ ( 6 ) in sf _ ( 6 ) - n _ ( 2 ) mixtures increased

    B ：等u _ w條件下電脈沖觸發火花隙的觸發延遲時間（ t _ d ）及其抖動（ t _ j ）隨混合氣中sf _ 6含量上升而上升，且場利用系數對這一規律沒有影響。
  10. Based on the theory mode, the delay time between the beginning of optical illumination and the onset of lock - on switching was calculated, and the transiting speed of electrons, the traversing velocity of the current filament, was obtained as well. the calculated results matched well the experimental results. taking advantage of the ultra - fast response characteristics of the devices, si - gaas pcss ' s are successfully applied to the broadening test of nanosecond laser pulses

    應用單極電荷疇模型數值計算了lock - on效應的光、電時間延遲和載流子的渡西安理工大學碩士學位論文越速度（絲狀電流穿越開關間隙的速度） ，所得計算結果與實驗測試結果基本吻a利川半絕緣gaas光屯導開關的超快光l匕11向應燈性，成功地應川下納秒激光脈沖展寬試驗中，證明了開關可廠泛應川在超快光電響應和光電反饋網路中。
分享友人
分享到 Line

分享到臉書