脈沖電流幅值 的英文怎麼說

中文拼音 [màichōngdiànliúfúzhí]
脈沖電流幅值 英文
pulse current amplitude
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 幅 : Ⅰ名詞1. （布帛、呢絨等的寬度） width of cloth 2. （泛指寬度） width; size 3. （姓氏） a surname Ⅱ量詞（用於布帛、呢絨、圖畫等）
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  2. By using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  3. Abstract : by using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    文摘:通過采樣電火花加工放電間隙的電壓、電流信號和檢測電壓幅值上的高頻信號的強弱，得出反映間隙放電狀態的各種時間脈沖，利用計數器分別對其計數，再送給單片機運算處理，輸出控制環節所需的各種放電狀態時間百分數。
  4. Many experiments on the effects with the change of several parameters, such as initial charging current, amplitude and frequency of positive pulses, variety of the amplitude of positive pulses among each charging stages, amplitude and duration of negative pulses, duration between positive and negative pulses, have been performed. the results of analysis and comparison of experimental data verify the validity and feasibility of the fast - charging method. on this basis, a new type of control strategy is advanced

    就充電過程中的起始充電電流、正脈沖的幅值、正脈沖的頻率、各充電級之間正脈沖幅值的變化幅度、負脈沖的幅值、負脈沖的持續時間、正負脈沖之間的停歇時間等幾個參數進行了大量的實驗，對實驗數據進行分析和比較，驗證了快速充電方法的有效性和可行性，在此基礎上提出了一種新型快速充電控制策略。
  5. Secondly the detection precision is only related to the synchronization phase but not to the amplitude of the mainline voltage because that it uses the optimized pulses synchronous with the mainline voltage as modulation signals. thirdly it decreases the requirement of the input low pass filter and eliminates the error resulting from the direct component and even harmonics of load current. the most significant merit is that it can eliminate the effect of a few low order odd harmonics and the detecting circuit is easy to be implemented

    模擬和實驗結果表明該方法的主要優點有：不需使用乘法器進行信號調制，調制信號採用與電網電壓同步的優化特定脈沖，其檢測精度只與同步相位有關，而與電網電壓幅值無關；降低了對輸入低通濾波器的通頻帶要求，直流和偶次諧波分量對檢測精度沒有影響；突出的優點是可以消除有限個低奇次諧波對檢測結果的影響。
  6. 2. the pre - flashover phenomena of alumina insulators in vacuum have been investigated. according to the experimental results, a reversed pre - flashover current was observed repetitively, which often occurs at the tail of pulse voltage close to zero ( sometimes after the applied pulse voltage )

    首次發現了大量的、重復性的反向預閃絡現象，即在沖擊電壓波尾附近電壓幅值已經接近零、甚至在沖擊電壓作用完后（已沒有電壓）的情況下仍然存在試樣表面發光現象，同時伴有反向的電流脈沖。
分享友人
分享到 Line

分享到臉書