脫碳處理 的英文怎麼說
中文拼音 [tuōtànchǔlǐ]
脫碳處理
英文
decarburization-
An activity decarburization model in rh vacuum refining
處理過程的脫碳動態模型Ceramic foam filter, tower packing, mass transfer, ceramic balls, hisina, internals, catalyst, huling brand, light - ceramic, china, porcelain, inert alumina ball, cast, foundry, industrial ceramic, pingxiang, cerami hisina industrial co., ltd is a professional manufacturer of the industrial ceramics and relative products such as ceramic foam filters, ceramic honeycombs, tower packings, tower internals, catalysts, ceramic balls etc. with the enterprise spirit of " people - oriented and innovation ", hisina grows very fast
輕瓷填料,工業陶瓷,泡沫陶瓷,蜂窩陶瓷,惰性瓷球,虎靈牌,新安工業,金屬塑料陶瓷填料,塔內件,陶粒濾料,耐火瓷磚,傳質設備,洗萘洗苯洗氨脫硫脫碳以及熱水飽和塔和直接式冷卻塔,水處理,When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set
當膠粘劑中填料為其它物質(未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合)時,通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時,膠粘劑的拉伸剪切強度最高;同時進行了沖蝕磨損試驗,通過比較得出,當膠粘劑塗層中有機化蒙脫土含量達到5時,塗層的耐沖蝕磨損性能最佳,並對沖蝕磨損試樣在掃描電子顯微鏡( set )上進行觀察。Based on the analysis about the influences of the mixing time, the penetration ratio of injected powder and the residence time of injected powder in the bath on the desulphurization process, a mathematical model which taken these three parameters into account was developed to simulate the desulphurization rate of hot metal by co - injection of magnesium - cac2 mixture, and the coupling effect between magnesium and cac2 was discussed
在具體分析熔池均混時間、粉劑穿透比及粉劑停留時間這3個基本參數對脫硫過程影響的基礎上,建立了能體現這3個參數影響的模擬鐵水噴吹鎂粒和碳化鈣復合粉劑脫硫處理的數學模型,並討論了兩種粉劑在脫硫過程中的耦合效果。It can not only remove gas, water and impurity, but also free carbon, decolor, deacidify, medium loss reducing and resume utilization property of oil to achieve treated oil up to national standard on water content, gas content, ph number and acid number, ect
它不僅能脫氣脫水除雜質,而且還具有去除絕緣油中的游離碳脫色除酸降介損的功能,恢復油的使用性能使處理后油中的含水量含氣量ph值酸值等均符合國家標準。Saturated charcoal can steam treated or directly replaced
活性碳飽和后可採用蒸氣脫附或直接更新方式處理。These costs may be partially offset if the plant can filter out gaseous sulfur simultaneously and store it with the co2, thus avoiding some of the considerable expense of sulfur treatment
如果電廠能同步濾除氣態硫,並與二氧化碳一併儲藏,省去脫硫處理時可觀的開銷,便可能彌補一部份成本。Rapid heating rate and no decarburized zone due to heat treatment during austenization, the staying time between 850 to 1000 is only 5 to 10 second, thus no decarburized zone can be formed
在加熱奧氏體化過程中,在850 - 1000溫度范圍內的停留時間只有5 - 10秒鐘,因此,不會有熱處理脫碳層。Abstract : according to the character and actual condition of rh in shanghai baogang, molten steel flow in ladle and its effect on decarburization were studied with a three dimension turbulent flow and concentration modelling. the results show that, within a certain range, the decarburization rate increases not only with the increase of snorkel diameter and ar fluid flow but also with the decrease of the immersed depth of the snorkel
文摘:根據上海寶鋼rh的特點和實際情況,建立了三維流場、濃度場程序,對鋼包內鋼水的流動、處理過程的脫碳進行了研究,並對它們的影響因素進行了分析.結果表明,在一定范圍內增加循環管直徑和吹氣流量、減小浸漬管浸入深度有助於提高脫碳速度分享友人