腐蝕測量 的英文怎麼說

中文拼音 [fǔshícèliáng]
腐蝕測量 英文
corrosion measurement
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. It is used for pressure and vacuum of ammoniac liquid and gas as well as of zhe madia which can ' t corrode carbon steel, stainless steel and solders like tin and lead

    儀表適用於測量氨的液體和氣體的壓力真空，也可測量對碳鋼、奧氏體不銹鋼和錫鉛類焊料無腐蝕作用的介質的壓力和真空。
  2. Abstract : through analysis of the components of coking on different parts of desullfur system of single tower and the waste water containing sulfur, we find the cause of coking in the stripping desulur system from single tower is the polymerization reaction of carbohydrate and the separattion of varied solid powders, organic compounds, and all corrosive productions of metal out of waste water in high temperature, therefore, the solving method is how to decrease the oil content, how to depolymerize form the carbohydrate and how to antisepticize by vapour of waste water

    文摘:對單塔脫硫系統中不同部位的垢物及現場催化含硫污水進行了分析測定，結果表明：塔內污垢成分及含量隨塔體部位的不同而不盡相同，單塔汽提脫硫系統中垢物的形成，主要是由於污水中所含各類粉塵、有機物、金屬腐蝕物等在高溫下因石油碳氫化合物的析出及其單體的聚合反應所致.如何降低污水中的含油成分、減少聚合反應的生成、防止污水蒸氣對塔體材料的腐蝕，是阻垢、除垢和防垢應解決的關鍵問題
  3. As a new component of sensor, fiber grating have many instinctive advantages, such as light in weight, anti - cauterization, anti - interference in electromagnetism, high - sensitivity and compaction in construction. it is very easy to be coupled with fibers and the coupling - loss is slight. using fiber grating ’ s character of sensitivity for stress ; people have done some envelope experiments on structural systems ( such as storied buildings, bridge, railway and dam )

    光纖光柵傳感器除了具有重量輕、耐腐蝕、抗電磁干擾、靈敏度高、結構緊湊等優點外，還有其獨特的優越性，如探頭尺寸小，其直徑與光纖等同;易於與光纖耦合，耦合損耗小;波長調制型，抗干擾能力強;集傳感與傳輸於一體且具有極強的復用能力，易於構成傳感網路;測量對象廣泛，易於實現多參數傳感測量等等。
  4. Standard test method for an imaging technique to measure rust creepage at scribe on coated test panels subjected to corrosive environments

    用成像技術在腐蝕環境中測量塗覆試驗板劃痕處銹蝕蠕變的標準試驗方法
  5. Applicable to lpressure measurements for liquid mediums at high temperature, such as corrosive, high viscous, crystallizable and solid - particles containing fluids commonly used in petrochemical indusery, etc

    隔膜壓力表用於化工等部門生產過程中測量具有腐蝕性、高粘度、易結晶、含有固體狀顆粒、溫度較高的液體介質的壓力。
  6. Industrial circulating cooling water - determination of undissolved material in acid, phosphorus, ferrum, aluminium, calcium, magnesium, zinc and copper for sludge and corrosion products

    工業循環冷卻水污垢和腐蝕產物中酸不溶物磷鐵鋁鈣鎂鋅銅含量測定方法
  7. The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological

    分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象，依據astm標準及國際通用文物保護研究方法與評估準則相結合，通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定，及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響，對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。
  8. According to the topology of the substation and resistance measurements of down - leaders, the erosion diagnosis equation is built and the resistance variations of grounding grid branches are solved, and the erosion of grounding grid could be found through the fuzzy diagnosis regulation

    利用接地網拓撲結構圖及接地網引下線間的電阻測量值，建立腐蝕診斷方程，通過求解診斷方程，計算出接地網支路電阻值變化量，採用模糊診斷方法判斷出接地網導體腐蝕的情況。
  9. Soil quality - measurement of the stability of soil aggregates for assessment of liability to surface sealing and hydric erosion

    土質.表面密封和水腐蝕傾向性評定用土壤集料穩定性的測量
  10. This paper discusses the characteristic of inductivity coupled plasm atomic excite spectroscope and applies the analysis method to measure the atmosphere corrosion rusty layer samples from qingdao and chengdu. we get the relative content of each element of rusty layer and show the charitable situation that the relative content varied with the change of corroded environment and time

    概述了電感耦合等離子體光譜法的特點，並運用該光譜法對青島和成都兩地的大氣腐蝕銹層樣品進行了比較測試，得出了銹層中各元素的相對含量及其隨腐蝕環境和時間的變化情況
  11. Standard test method for monitoring of atmospheric corrosion chambers by quartz crystal microbalances

    用石英晶體微量天平監測大氣腐蝕室的標準試驗方法
  12. Measuring object : high temperature corrosion or viscous fluid

    測量對象:高溫腐蝕性或粘性液體
  13. In the light of the status that there are caustic faults in the oil well tubing and there are not effective inspections, in this paper the plane roundness fault model of the is studied, and the magnetic leakage flux distributing model at the direction of the normal of the roundness fault is proposed

    針對油管容易遭到腐蝕性損傷而目前缺乏有效檢測手段的現狀，本文系統的研究了平面圓形缺陷模型，提出了圓形缺陷的法線分量漏磁場的實驗分佈模型。
  14. Standard practice for measurement of time - of - wetness on surfaces exposed to wetting conditions as in atmospheric corrosion testing

    在大氣腐蝕測試中表面暴露在潮濕條件下濕潤時間的測量
  15. Standard method for showing and measuring dislocation etch pits in indium antimonide single crystal

    銻化銦單晶位錯蝕坑的腐蝕顯示及測量方法
  16. In this paper, rebar corrosion state was judged with three electrochemical nondestructive measuring technologies, i. e. half - cell potential, a. c. impedance and time potential. when the rebar was transformed from passivation to depassivation, it can obtain the chloride ions corrosion critical content through taking and analyzing chloride ions content around the rebar

    本文利用半電池電位法、交流阻抗法和時間電位法三種電化學無損檢測技術判斷評估試件在試驗過程中鋼筋腐蝕狀況，當鋼筋由鈍化狀態轉為活化狀態時，取樣分析鋼筋周圍氯離子含量，得到了不同技術條件混凝土的氯離子臨界濃度。
  17. With variable assembly interfaces, special encasement against aggressive materials or optionally up to four switch contacts there is a broadly diversified range of products suitable for measuring and control tasks in many industrial fields

    Tecsis的產品有各種裝配介面特殊抗腐蝕材料外殼或多達四個的可選開關接點，因此我們有很廣的產品范圍，滿足眾多工業領域中的測量和控制任務。
  18. There are a lot of methods for measuring nitriding depth, incluing structural corrosion method

    現有的測量氮化層深度的方法很多，國內大多數採用組織腐蝕法。
  19. From the third chapter to the sixth chapter we mainly discuss a novel moisture permeation ratio measurement method, and model was developed qualitatively and quantitatively with the ‘ calcium degradation test ’ method

    第四章，主要介紹了鈣膜腐蝕法測量滲透率所用的系統組成，這個系統由ccd攝像頭、顯微鏡和計算機組成，並介紹了用於本系統的程序。
  20. Rating method of rust and stain of atmospheric corrosion for stainless steels

    不銹鋼大氣腐蝕的銹斑和和銹蝕的測量方法
分享友人
分享到 Line

分享到臉書