腐蝕速率 的英文怎麼說

中文拼音 [fǔshísùlǜ]
腐蝕速率 英文
corrosion rate
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  • 速率 : speed; rate; tempo
  1. The prescription of the inhibiter after optimization has good effectiveness, making the corrosion rate of steel no. 10 to be far smaller than the allowable value stipulated in the standard of power industry

    經優化的配方緩蝕效果良好，可使20號鋼的腐蝕速率遠遠小於電力行業標準允許值。
  2. Mechanism of lioh aqueous solution accelerating corrosion rate of zircaloy

    4合金腐蝕速率的機理
  3. Actual operation shows that, using the stabilizer can secure the concentration ratio in the process and corrosion speed and meet the design requirements

    現場實際運行結果表明，該水質穩定劑能保證該系統運動時的濃縮倍率及腐蝕速率滿足設計要求。
  4. Standard of test method for corrosion tate of buried steel test pieces

    埋地鋼質檢查片腐蝕速率測試方法
  5. On the basis of couple polarization theory, the mathematical expressions of couple potential and corrosion rate of fresh bare metal are inferred, the theory modeling relations of couple potential vs time is corresponding to experimental results

    根據耦合作用理論，獲得了耦合電位、裸露的新鮮金屬腐蝕速率的數學表達式，數學模擬所得的耦合電位與時間的關系，和實驗結果有較好的一致性。
  6. Because of the place obstruction of corrosion products in the surface of the alloys, while corrosion time is at 120 minutes above, the corrosion rate descends to the stable value in 48 hours

    當腐蝕浸泡的時間大於120分鐘后，腐蝕產物在鋁合金表面產生了明顯的位阻作用，從而使腐蝕速率逐漸下降，直至48小時后，腐蝕速率趨於一相對穩定的數值。
  7. From the varieties of the natural corrosion potential of aluminum alloys, it is deduced that the gradual dissolution of natural passive state film of the alloys brings about high - speed enhancement in the corrosion rate of the alloys

    從自腐蝕電位的變化規律可以推斷，在腐蝕的初期階段，鋁合金表面自然生成的鈍化膜逐漸溶解，使鋁合金腐蝕速率快速增加。
  8. The variations of the surface state and environment conditions could change the procedure of exfoliation, therefore, the potentiometry and electric resistance methods in this paper are used to measure the exfoliation rate of aluminum alloys in a constant temperature, the experimental results show that relations of natural corrosion potential vs time have a resemblance to those of corrosion rate vs time, both relations are all at the different change rates in the front and back of 120 minutes

    超硬鋁合金表面狀態、環境條件的變化，均可能改變剝蝕的發展過程，為此，本文提出在恆溫條件下，用電位法、電阻法定量研究鋁合金的剝蝕性能。實驗結果顯示了lc4cs鋁合金的自腐蝕電位與時間的關系，和腐蝕速率與時間的關系有著十分相似的規律，兩者均在120分鐘前後有不同的變化。
  9. At the same time, calculate corrosion velocity by actual thickness data and residual lifetime

    同時，根據實測的省煤器管壁數據得到腐蝕速率，計算省煤器管的剩餘壽命。
  10. Bidirectional diffusion between silicon and tini thin film has been exhibited in eds linescan curves, along with mapping distribution micrographs. moreover, a ternary titanium nickel silicide - nisti2si, is formed during sputtering deposition, which is determined by xrd analysis

    大量試驗表明：配比為35nil ： 27inl ： 118rnl的hfgyo3a12o腐蝕系統對twi薄膜具有較快的腐蝕速率，而且對8的腐蝕不明顯，因而適合於硅基tini形狀記憶薄膜的濕法腐蝕。
  11. Experimental. study on corrosion rates of deformed and plain bars in concrete

    混凝土中變形與光圓鋼筋腐蝕速率試驗研究
  12. The corrosion rate of porous silicon in hf / h2o2 solution is several orders higher than that of bulk silicon

    多孔硅在hf / h _ 2o _ 2溶液中的腐蝕速率比體硅的高幾個數量級。
  13. Numeric analysis of inductive resistance probe and application in atmospheric corrosion

    磁阻探頭系統腐蝕速率解析及在大氣腐蝕中的應用
  14. A series of nickel - chromium - copper cast - irons with varied rare earth were designed and theirs microstructures were observed by optical election microscope ， the corrosion rates of re - ni - cr - cu alloy cast irons in static 、 room ? temperature and strong alkali liquor were measured by the hydrometer method

    設計了含不同量的稀土鎳-鉻-銅合金鑄鐵，採用光學顯微鏡觀察組織，用失重法測定合金鑄鐵在靜態、室溫、高濃度堿液中的腐蝕速率。
  15. The quantitative relationship between the corrosion residual life and corrosion rate, variation coefficient, corrosion allowance and reliability is built up, and equations for calculating the corrosion residual life are derived

    初步建立了腐蝕剩餘壽命與腐蝕速率及變異系數、腐蝕裕量、可靠度之間的定量關系，得到了確定腐蝕剩餘壽命的計算公式。
  16. Once tube wall is overheated, oxidation corrosion rate is not only accelerated, hut also the tube performance is rapidly deteriorated

    一旦管壁過熱不僅加速氧化腐蝕速率，且急劇惡化管材性能。
  17. Study of linear polarization technique in geothermal system for corrosion ratio

    線性極化技術測試地熱腐蝕速率的試驗研究
  18. The corrosion behavior of 20a carbon steel in 4 % edta solution was studied by measuring steady - state polarization curves at 30 and corrosion rates at various temperatures

    摘要通過測量30下的穩態極化曲線和不同溫度下的腐蝕速率，研究了20a碳鋼在4 % edta溶液中的腐蝕行為。
  19. Corrosion rate and morphology of different materials in sulfer - bearing solution

    幾種不同材料在含硫介質中的腐蝕速率和腐蝕形貌研究
  20. Corrosion of metals and alloys - corrosivity of atmospheres - determination of corrosion rate of standard specimens for the evaluation of corrosivity

    金屬和合金的腐蝕大氣腐蝕性用於評估腐蝕性的標準試樣的腐蝕速率的測定
分享友人
分享到 Line

分享到臉書