腹梁 的英文怎麼說

中文拼音 [fùliáng]
腹梁 英文
web girder
  • 腹 : 名詞1 （軀乾的一部分） abdomen; belly; stomach 2 （鼎、瓶子等器物的中空而凸出處） empty and protr...
  • 梁 : 名詞1 （屋架中架在柱子上的長木） beam 2 （通常也指檁） purlin 3 （橋） bridge4 （物體中間條狀隆起...
  1. Floor-beam webs have cracked in tied arch bridges.

    在系干拱橋的橫梁腹板上發生裂紋。
  2. The web and flanges of the main girders were fabricated from astm a441 steel.

    主梁的腹板和翼緣用ASTMA441鋼製造。
  3. It is the key of ebfs, therefore, furthermore calculation about link are carried out in this thesis, introduced achieved research, summarized the affect of link on whole capability in the first, the second, numerical calculation are proceeded on link with ansys : with the purpose of discussing yielding mode critical length of link, established five different specimens ; with the purpose of discussing the influence of h / tw of web, b / tf of flange and h / b, established eighteen different specimens ; with the purpose of discussing the affect of stiffener, established four different specimens, and elaborated the affect of stiffener on link based on achieved test researches

    因此，本文對耗能梁段進行進一步計算分析，概述耗能梁段對整體性能的影響，並利用有限元程序ansys對耗能梁段進行數值計算：針對耗能梁段的屈服類型建立5種不同長度的模型，計算討論耗能梁段屈服類型的長度劃分；針對耗能梁段腹板高厚比、翼緣寬厚比以及梁段截面形狀等因素共建立了18種模型進行計算分析；針對加勁肋對耗能梁段的作用建立了4種模型，並結合已有的試驗闡述了加勁肋對耗能梁段的影響。
  4. In addition to, the fatigue crack between web and upper flange of welded steel crane beam on heavy duty service was discussed, and based on long - term observation and research, the author classified fatigue crack into bearing type and middle type crack along the horizontal direction. the causation, distributive law and mechanism of the crack were analyzed, and the precautions to take and the measures to remedy crack were presented. the main defacts including damage, crack, erosion and aging in structures, especially in concrete structure were introduced ; the defact mechanism was analyzed and the precautions to take were also given

    另外，作者對重級工作制焊接鋼吊車梁腹板與上翼緣連接焊縫的縱向水平疲勞裂縫進行了長期的觀察和研究，根據疲勞裂縫產生的不同機理，將其分為支點裂縫和肋間裂縫，並討論了兩類裂縫產生的原因、分佈規律、機理以及防治的措施；對工程中經常遇到的結構構件，尤其混凝土構件的幾種主要病害（損傷、裂縫、腐蝕與老化）進行了機理分析並提出了防治措施。
  5. Cracks have been found in the flange and web splices at groove welds in at least four bridges.

    至少在四座橋梁的翼緣板和腹板拼接坡口焊縫中發現了裂紋。
  6. In order to considering the affections of the adjacent zone out of the girdler section, the internal - forces of two end surface which were obtained by the horizontal shaft system analysis are exerted on each model respectively. moreover, the weight, cable force and prestressing forces including girder longitudinal, diaphragm transverse and inclined web vertical directions are considered

    考慮到梁段以外附近區域的作用，在其兩端面上施加了由平面桿系結構分析所得的端面內力，另外，索力和預加力（梁縱向、橫隔梁橫向、斜腹板豎向）也施加在相應的位置，分析了箱形主梁在自重、索力和預應力作用下的空間應力效應。
  7. The consequence is, when the majority of structure does n ' t enter yield habitus, but the position of belly - board has been reached the ultimate habitus, it lead to material waste of the other positions, we should pay attention to the disastrous result it will bright to us

    它帶來的後果就是當結構的大部分處于彈性狀態時，箱梁腹板處由於剪力滯效應一般最先達到強度極限狀態，導致腹板間材料的抗力沒有得到充分的使用，如不引起重視會帶來災難性後果。
  8. Two structures that experienced cracking in the longitudinal girder web at x-type cross-frame are reviewed in detail hereafter.

    以下將詳細評論在縱梁腹板與X型橫向框架連接處開裂的兩座結構。
  9. The box beam ' s temperature stress of longitudinal direction and transverse direction with different conformation are analyzed, it finds that there is largish temperature tensile stress in the bottom of top deck and the haunch of box beam increase temperature tensile stress in the bottom of top deck. the paper makes a study of different thermal effects resulted from several kinds of closed rigid frame

    根據大量實測溫度場結果建議採用一個有利於理論推導的指數函數的公式來擬和箱梁體內的溫差分佈，既貼近實測數值，計算又比較簡單；通過對空腹式剛架拱橋尤溪洲大橋所在地夏季、秋季、冬季的溫度場及溫度應力的實測，以及與本文所提出計算方法的理論解進行的分析比較，證實了本文計算方法的正確，同時改進了已往混凝土箱梁溫度自應力的計算方法。
  10. Three - dimensional photoelastic test of beam - arch joint of open spandrel rigid - frame arch bridge

    空腹式剛架拱橋梁拱節點三維光彈性試驗研究
  11. Spatial static behaviors analysis on beam - arch joint of new - type rigid - framed arch bridge with open spandrel

    空腹式新型鋼架拱橋梁拱節點空間受力分析
  12. Stringer webs have cracked in suspension bridges at the stringer-floor beam connections.

    在懸索橋的縱梁和橫的連接處，縱梁的腹板上發生開裂。
  13. Body bolster diaphragm

    枕梁腹板
  14. Meanwhile, according to the reduced theoretic of the open - web truss, the strength simplification computational method are proposed, and in comparison of the theoretical calculating value with the tested one and the behavior analysis of the tested beams during the process, the hypothesis and the theory of the beam are verified and the stress distribution of the circular hole castellated beam is also obtained

    通過費氏空腹桁架簡化計算理論值與實測值的對比分析以及對試驗梁在試驗過程中的性態分析，驗證了理論計算及各項假設的正確性，分析得出圓孔蜂窩梁圓孔周邊應力分佈特徵；並通過撓度分析，提出了實用的簡化計算式。
  15. Thecalculating results show that the composite action between concrete floor and steel beamsgreatly influence the bending bearing capacity and initial rotational stiffness of joints, it shouldbe considered in practical engineer. reinforcement ratio of lengthways reinforcing bar andthe stiffener of web have great influencer on the behavior of connections, while the thicknessof end - plate and degree of shear connection have a litter influence on its behavior

    分析計算結果表明:樓板與鋼梁的組合作用對節點的抗彎承載力及初始轉動剛度的影響非常大，實際工程中節點設計應當考慮這種組合作用;樓板內縱向鋼筋配筋率與柱腹板加勁肋對節點性能影響顯著，而連接端板厚度及剪力連接程度的影響則不是太顯著。
  16. Based on the research to the stability variable cross - section beam, the bending defection differential equation of the variable cross - section beam in critical state of bucking is established. according to the edge condition of the structure, the differential equation is solved and bucking equation of variable cross - section beam is created. we can get the algorithm which can be used to calculate the equivalent inertia moment of the variable cross - section lattice structure when it is regarded as constant cross - section of solid web beam

    對變截面格構式構件的穩定性計算進行了初步的研究，通過建立變截面構件臨界狀態下彎曲變形的微分方程，根據變形邊界條件，得到了兩端鉸支的變截面梁失穩特徵方程，提出了幾種特殊形式的變截面格構式構件等效為等截面實腹式構件時等效慣性矩的計算方法。
  17. Fish belly beam

    角腹式梁7
  18. The plexiglass model test is carried out by two selective shape, the stress of each test operating loads was obtained in order to validate the correctness of the finite element modeling. in this paper, a regularity of shear lag effect of main sections in two kinds of box girder is given. as the foresight project of double - level - driveway continuous box girder, this research fully utilizes the space of box girder structure and flexural and torsional properties of high - depth box girder, which have innovative significance and applied foregroundin engineering

    對所選擇的結構形式進行縮尺有機玻璃模型試驗，得到實腹連續箱梁和空腹箱梁在各種試驗工況荷載下的應力，通過換算分析，驗證了本文所建立的有限元模型的準確性，由此得到兩種箱梁各主要斷面剪力滯效應的變化規律。
  19. Often lack of fusion adjacent to the girder web in the transverse groove welds led to the cracking.

    在靠近主梁腹板的橫向坡口焊縫處常常出現未熔透而導致裂紋。
  20. At the top flange there would be enough slack so that no relative twist of any significant magnitude would be introduced into the girder web.

    在上翼緣處有足夠的松動，因而在主梁腹板上並不會引起很大的相對扭轉。
分享友人
分享到 Line

分享到臉書