膜傳導理論 的英文怎麼說

中文拼音 [mózhuàndǎolǐlún]
膜傳導理論 英文
membrane theory of conduction
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 論 : 論名詞（記錄孔子及其門徒的言行的「論語」） the analects of confucius
  • 理論 : theory
  1. By examining the new generation condutive polymer material 3 ， 4 ? polyethylene dioxythiophene ( pedt ), this paper investigated the edt monomer synthetic path and the optimum filming conditions of the compound pedt. based on this research, i also discussed the manufacturing processes and the related principles of the solid tantalum capacitors, when replacing the conventional inorganic material mno2 with the pedt as the negative pole

    本文以新一代導電聚合物材料3 ， 4 ?聚乙烯二氧噻吩（ pedt ）為研究對象，研究了edt單體合成路線及聚合物pedt的最佳成膜條件，並以此為基礎，討論了以導電聚合物有機材料pedt取代傳統的無機材料mno2作陰極的固體鉭電解電容器的制備工藝及相關機理。
  2. Theory calculation and derivation demonstrate that the heat conduction of membrane exerts little influence on performance. the characteristics of mass transfer through membrane are mixed flow including knudsen flow and poiseuille flow, which moreover, vary with operational variables

    理論推導與計算表明：膜的導熱性對真空膜蒸餾過程的影響可以忽略，膜蒸餾過程膜內質量傳輸機制是努森流與粘性流共同作用的混合流機制。
  3. To set up reasonable designing and manufacturing techniques and accurate calibration system and to speed up forming the native pvdf pressure sensors is the direction of this project. first, based on the piezoelectric theorem, the theoretic support of pvdf pressure sensors is deduced. according to purposes of practical projects, special purpose sensor configurations are designed and the corresponding calibration system based on shpb ( split hopkinson pressure bar ) technique is built in succession

    本文從壓電材料的一般壓電控制方程開始，導出了pvdf壓電薄膜測壓技術的相關論據；根據測試目的以及被測結構的特點，設計了多種夾心式的傳感器構造形式；摸索出了一套基於國產pvdf壓電薄膜製作壓力計的加工、安裝工藝；建立了一套基於系統集成技術的多點pvdf壓力測試的數據採集、處理系統；建立了一套基於shpb技術、適用於實際工程應力范圍的pvdf壓力計的動態標定方法，並對兩種厚度的國產pvdf壓電薄膜進行了標定。
  4. On the basis of above theoretical derivation and analysis on experimental results, by correlating solvent ( water ) transfer with solute ( salt ) transfer on hot side and correlating mass transfer with heat transfer during vmd and introducing a contribution coefficient which can reflect the characteristics of mass transfer through membrane, a new model of mixed flow is presented

    在上述理論推導及實驗分析的基礎上，本文將熱側溶劑傳輸與溶質傳輸、膜蒸餾過程熱量傳輸與質量傳輸相關聯，並引入一個能夠反映膜內質量傳輸特徵的「貢獻系數」 ，將努森流模型與粘性流模型結合起來，從而提出了新的混合流模型。
  5. The laser heats up the diamond and causes the temperature rises on the surface of diamond film. at the different temperature, the different physical and chemic change will happen. the rules of the laser ablating diamond were researched by experiment

    從激光加熱和熱傳導的理論出發，研究了激光傳熱及其在金剛石表面引起的溫度分佈情況，以及在不同的溫度和激光功率下，金剛石膜發生的不同的物理和化學變化。
  6. Analysis and measurement of thermophysical properties contribute to microscale heat transfer, heat transfer ability and heat dispersion velocity of micro - device and developing new micro - device

    分析和測量微尺度下薄膜材料的熱物性參數對微尺度傳熱理論分析和研究微器件的熱傳導能力、散熱速度以及新器件的開發具有重要的意義。
  7. The dissertation gives a comment on the field of energy - transmitting fibers for mid - infrared laser, an introduction to the mechanism of infrared - transmitting fibers in view of radiations and waveguides, and a theoretical analyze of the layer - selecting method for the fibers with multi - layer dielectric films. in view of the properties of sic in the region of mid - infrared, the author has done many works about the energy - transmitting fibers with sic, and summarized as follows : first, it is found that sic is a very good material for the fabrication of power - transmitting fibers for mid - infrared laser, especially for co2 laser that works at 10. 6um wavelength, and sic / sio2 hollow fibers has not been studied in the world for the first time to our knowledge. second, it is pointed out, for the first time to our knowledge, that the hollow fibers with a structure like si / sic / sio2 or ge / sic / sio2 have very good properties for the mid - infrared laser power transmitting, especially for co2 laser

    本論文評述了關于中紅外傳能光纖的國內外進展，從光射線理論和波導理論出發介紹了紅外傳能光纖的傳輸機理，從薄膜光學出發分析了多層介質膜傳能光纖的膜層選擇機理等基礎理論，針對碳化硅（ sic ）在中紅外區的特點，在導師侯藍田教授領導的科研組已有成果的基礎上進行了以下幾個方面的研究：發現了sic是制備紅外傳能光纖的良好的紅外材料， sic sio _ 2空芯傳能光纖在國際上還沒有人進行研究：提出了具有si sic sio _ 2和ge sic sio _ 2膜結構的空芯傳能光纖，據我們所知，這種光纖目前在國內外還沒有人進行研究，並對其傳輸性能進行了可行性分析。
  8. First this paper introduces the development of microscale heat transfer from theory, experiment and computer simulation. then it analyses the heat transfer mechanism during short - pulse heating of metals and the microscale heat conduction in dielectric thin films. last it expatiates on the principle of ac calorimetric method and its experimental techniques

    本論文首先從微尺度理論、實驗技術和計算機模擬三方面介紹了微尺度傳熱學研究現狀，接著分析了超短激光脈沖加熱金屬薄膜過程中的熱傳導和介質薄膜中的熱傳導機制，闡述了超短激光脈沖交流量熱法的原理和實驗技術。
  9. After introducing the background and the trend of research on ppv thin film light - emitting diodes ( leds ) and the structure of ppv device and its characterizes, the theoretical model of the leds * light - emitting efficiency was presented. based on this model, the formula of light - emitting efficiency was deduced to be : the injecting - currents and the recombining - efficiencies were calculated nwnerically, we found the calculated results agreed very well with the experimental results under the electric field from 0. 5 x 106 to 1. 5 x 106v / cm, the numeral calculations and theoretical analyzes of the light - emitting efficiency were done. the conclusions were as follows : ( 1 ) the basic mechanism of the injection transportation and recombination of the carriers which were presented in this paper were proved to be right ; ( 2 ) the electroluminescence in ppv thin film is the result of exciton recombination, the light - emitting efficiency was affected by many factors

    本文主要研究聚對苯乙炔（ ppv ）薄膜發光二極體發光效率及主要影響因素，簡單地介紹了ppv薄膜發光二極體的研究背景及發展趨勢、 ppv器件的結構和性質后，提出了一個計算器件發光效率理論模型，利用這個理論模型得出了發光效率公式的表達式：並對注入電流、復合效率等進行了數值計算，通過合理地選擇計算參數，發現計算值在場強為0 . 5 10 ~ 6 1 . 5 10 ~ 6v / cm的范圍內與實驗結果較好地符合，在此基礎上，對發光效率進行了數值計算和理論分析，結果表明：計算結果與理論研究結果相符較好，得出結論如下： （ 1 ）本文的理論推導正確地反映了器件中載流子的注入、傳輸和復合等基本機制； （ 2 ） ppv薄膜中的電致發光是激子復合的結果，發光效率受多種因素影響。
  10. Firstly, based on the biot - savat theory, we set up the computational model of the inductors, for different shape, and then use this theory to design our thin - film inductors with multi - value

    首先基於biot - savat定律，推導不同繞線形狀電感的新理論計算式，並根據理論計算結果設計了不同電感值的薄膜電感，並首次提出多層薄膜磁場分佈的傳輸線模型。
分享友人
分享到 Line

分享到臉書