膜模擬化學 的英文怎麼說

中文拼音 [huàxué]
膜模擬化學 英文
membrane mimetic chemistry
  • : 名詞1. [生物學] (像薄皮的組織) membrane 2. (像膜的薄皮) film; thin coating
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : 動詞1. (設計; 起草) draw up; draft 2. (打算; 想要) intend; plan 3. (模仿) imitate
  • : Ⅰ動詞1 (學習) study; learn 2 (模仿) imitate; mimic Ⅱ名詞1 (學問) learning; knowledge 2 (學...
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  1. The feasibility that kaufman ion source is applied in reactive ion beam etching is discussed. etching characteristics of materials, including pr, cr, quartz, are investigated. the etch rate and mechanisms of such materials are measured and analyzed as a function of ion energy, ion beam density and ion incidence angle in pure ar and chf3, respectively. the etch rate has shown a square root dependence on variation versus

    深入研究了光刻膠、鉻薄、石英等光材料離子束刻蝕特性,分別以ar氣和chf3為工作氣體,研究光刻膠、鉻薄、石英等的刻蝕速率隨離子能量,束流密度和離子入射角度的變關系,得到刻蝕速率與影響因素的合方程,為掩的製作工藝路線提供了實驗依據和理論指導。
  2. In the theoretical description of grazing emission fluorescence, the mode of fluorescence intensity emitted from layered materials dependence of grazing angle is established by applying asymptotic approximations to double fourier integrals, and the theoretic calculation formula of fluorescence intensity from a thin layer is derived. by the derived expressions, the theoretic simulation curves of several thin layers on si substrate are calculated. in the experimental setup, the requirement of construction of the setup and some important parameters are brought forward

    最後,利用平穩位相方法建立了掠出射情況下薄層樣品產生的熒光強度和掠出射角的對應關系數型,推導了薄層樣品熒光強度理論計算公式,並以此為依據計算得出了cr 、 fe 、 ti和ni等幾種以si作基底的單層薄樣品的熒光強度隨掠出射角變的理論曲線。
  3. The enhanced photoconductive effect from small amount of tnf facilitates the preparations of new organic photoconductive devices under the drive of low fields. in the fourth chapter, inclpc nanoparticles embedded in poly ( n - vinylcarbzaole ) ( pvk ) were prepared successfully by dissolving inclpc in aprotic organic solvent / lewis acid with great concentration for the formation of electron donor - acceptor complexes, i. e., the method of complexation - mediated solubilization. the fabricated inclpc nanoparticles were characterized by means of uv / vis absorption, x - ray diffraction pattern, and tem

    論文的最後一章中,我們合成了具有較好的電子傳輸性能的合物』一二苯基四竣酸花酚亞胺( ddp ) ;研究了其溶解性、熱穩定性、晶體結構、紅外光譜、紫外吸收光譜和蒸鍍薄的屬性,並用量子計算方法其單分子的空間構型;載流子遷移率測試的結果約為ix10 「 、 m 』 v 」 』 ? s 「 』 。
  4. Finite difference time - domain method is used to calculate the reflection for these probes and absorbing boundary condition is used to deal with the singularity in the axis of the coaxial - line in the simulation. by comparing the reflection of different probes, the best probe has been selected according to sensitive requirement. the influence of parameters : such as thickness of protective film, length of protruding inner conductor of the coaxial - line probe to the measurement has been studied

    通過時域有限差分法進行數值分析,並採用吸收邊界處理同軸線軸心奇異點,計算出各種探頭測量相同溶液的反射系數,根據其測量的靈敏度,選出最優設計;並通過分析所選探頭的各種設計參數,如薄厚度、內導體伸出長度等的變對測量結果的影響,找出該探頭各參數的最佳范圍,使其具有高度靈敏性,以適用於測量反應溶液的介電常數。
  5. In this paper, the gas phase dissociation process during the diamond film growth from electron - assisted chemical vapor deposition ( eacvd ) by considering ch4 / h2 mixture gas as source gas had been studied by using monte - carlo computer simulation method. the eacvd gas phase dynamics model was built firstly and the low temperature deposition process was also discussed

    本工作採用蒙特卡羅( monte - carlo )計算機的方法,對以ch _ 4 h _ 2為源氣體的電子助進氣相沉積( eacvd )金剛石薄中的氣相分解過程進行了研究,初步建立了eacvd氣相動力型,並討論了eacvd中的低溫沉積過程。
  6. Mathematical models and simulation of pervaporation processes in practical membrane modules

    實用組件中滲透汽過程的數型和計算
  7. Manufactures pressure sensors, transducers, load cells, accelerometers, force sensors and strain gages from stock. specialist in micro - miniaturization and applications of semiconductor, thin film, metallic foil and hybrid circuit technologies for the measurement of acceleration, force, and pressure in a multitude of environments

    -提供薄制備微粉制備真空冶金分子束外延磁控濺射氣相沉積電子束鍍激光鍍甩帶機磁控電弧爐空間環境等設備
  8. The fourier transform infrared ( ftir ) spectrum is an effective technology for studying the hydrogen content ( ch ) and the silicon - hydrogen bonding configuration ( si - hn ) of hudrogenated amorphous silicon ( a - si : h ) films. in the paper, ch and si - hn of a - si : h films, fabricated at different ratio of h2 / sih4 by microwave electron cyclotron resonance plasma chemical vapor ( wmecr cvd ) method, have been obtained by analyzing their ftir spectra that are treated by baseline fitting and gaussian function fitting. the effects of ratio of h2 / sih4 on ch and si - hn are studied

    Fourier紅外透射( ftir )譜是研究氫非晶硅( a - si : h )薄中氫含量( c _ h )及硅-氫鍵合式( si - h _ n )最有效的手段,對于微波等離子體氣相沉積( mwecrcvd )方法在不同h _ 2 sih _ 4稀釋比下制備出的氫非晶硅薄,我們通過紅外透射光譜的基線合、高斯合分析,得出了薄中的氫含量,硅氫鍵合方式及其組分,並分析了這些參數隨h _ 2 sih _ 4稀釋比變的規律。
  9. In this paper the flow field of falling film along the inner of vertical tube is simulated and it ' s the necessary base of the further research that includes characteristics of heat and mass transfer in the absorber under the fluctuant state. in this paper the ocean fisher ' s movement in the ocean is studied and the physical and the mathematical models of fisher are founded, then the expressions of the force caused by the movement are obtained. the expressions are combined with partial different equations of falling film under the static state, thus the mathematical model of the falling film under fluctuant state can be gained

    本文首先研究了船舶在海洋中的運動,建立了船舶搖擺運動的簡物理型和數型,得到了運動附加力的表達式;並在此基礎上將吸收管的運動附加力表達式代入靜止狀態下液流動的數型中,即得到了搖擺狀態下液流動的數型;然後對液流動的數型進行了簡,在假定了速度分佈的條件下,得出了液流動的積分方程,經過以上簡就將求解三維問題轉成為求解二維問題;將積分方程離散後用數值計算的方法了整個流場。
  10. In this paper the flow field of falling film along the inner of vertical tube is simulated and it ' s the necessary base of the further research that includes characteristics of heat and mass transfer in the absorber under the fluctuant state. in this paper the ocean fisher ' s movement in the ocean is studied and the physical and the mathematical models of fisher are founded, then the expressions of the force by the movement are obtained. the expressions are combined with partial different equations of falling film under the static state, thus the mathematical model of the falling film under fluctuant state can be gained

    本文首先研究了船舶在海洋中的運動,建立了船舶搖擺運動的簡物理型和數型,得到了運動附加力的表達式;並在此基礎上將吸收管的運動附加力表達式代入靜止狀態下液流動的數型中,即得到了搖擺狀態下液流動的數型;然後對液流動的數型進行了簡,在假定了速度分佈的條件下,得出了液流動的積分方程,經過以上簡就將求解三維問題轉成為求解二維問題;將積分方程離散後用數值計算的方法了整個流場。
  11. Mechanical property testing and numerical simulation of alumina films containing highly - ordered nanopore array

    含有序孔洞的多孔氧鋁薄的力性能測量和數值
  12. On the application of evaporation & condensation, a new open cycle solar still, which is configured mainly by one kind of falling film evaporator, condenser, solar collector and some auxiliary devices, is proposed. parameters affecting system performance, i. e., temperatures and flow rates of moist air, seawater, and cooling water, are analyzed numerically and experimentally

    最後,本文建立了一種以高效降蒸發器為核心部件的新型開放循環海水淡系統,在降蒸發器、太陽能集熱器和冷凝器等部件數型基礎之上,建立了合理的系統型,通過數值對空氣、海水、冷卻水等有關參數對淡水產量的影響進行了分析。
  13. A five - phase numerical model based on prism coupled is derived from maxwell equation and fresnel equation. using the professional software - mathcad, characteristic of this numerical model is simulated. the relationships between depths of the metal film, bio - sensitive film, cover slide, the refractive index of bio - sensitive film and the resonant angle ospr has been discussed respectively

    根據maxwell方程和fresnel方程推導出5層棱鏡耦合spr數值型,利用數軟體mathcad對該數型進行了,討論了金屬厚度d _ 2 、生物厚度d _ 3和折射率n _ 3 、載玻片厚度d _ 1與諧振峰值_ ( spr )的關系。
  14. Iris images for this paper are provided by institute of automation chinese academy of science. this paper presents an iris recognition arithmetic which gets a better result in the experiment

    本文在中國科院自動所提供的casia虹數據庫上,實現了一個虹識別演算法,通過對演算法進行,證明了演算法的可靠性和高效性。
  15. On the basis of the preferential sorption - capillary flow mechanism proposed by sourirajan, the membrane interfacial equilibrium condition in reverse osmosis can be simulated by the hplc experiment. the hplc data on retention times can be used for quantitatively characterizing the dynamic nature on solid polymer membrane surface and physicochemical properties of polymer - solution interface. the experimental technique in this paper can offer definite guidelines for the choice of appropriate membrane material and the better understanding of reverse osmosis separation mechanism

    本論文根據索里拉金( sourirajan )提出的「優先吸附?毛細孔流」機理作為選擇材料的理論依據,用高效液相色譜為手段,反滲透實驗平衡條件,確定乙基纖維素固材料界面的動力參數以及求得表徵高分子材料在溶液界面上的特性參數,為預測材料的性質和探討反滲透分離機理提供了有效手段。
分享友人